Using the key
Turn the key in the lock on the
driver's door to lock the vehicle.
mote control battery or in the event
of a remote control malfunction, the
remote control must be reinitialised.
Key in ignition
A buzzer sounds on opening the driv-
er’s door, if the key has been left in
the ignition.
Switch off the ignition.
Switch the ignition on again.
Turn the key again within five sec-
onds to deadlock the vehicle.
Changing the remote control
battery
Press the remote control locking but-
ton immediately for a few seconds.
Each action is confirmed by fixed
lighting of the direction indicators for
approximately two seconds.
Switch off the ignition and remove
the remote control key from the ig-
nition lock.
The remote control is now working
again.
When the vehicle is locked,
if unlocking is activated inad-
vertently without a door being
opened within 30 seconds,
the vehicle will lock automatically.
The folding and unfolding of the ex-
terior mirrors can be deactivated by
a PEUGEOT dealer.
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control sys-
tem a few moments after the ignition
has been switched off and therefore
prevents starting of the vehicle by
anyone who does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code is
recognised and starting is possible.
If the system does not function cor-
rectly, the service warning light comes
on, accompanied by an audible signal
and a message on the multifunction
display.
Battery ref.: CR1620/3 volts.
The information "battery flat" is given
by displaying of the service warning
light, accompanied by an audible sig-
nal and a message on the multifunc-
tion display.
To replace the battery, unclip the cas-
ing using a coin at the notch.
Locating your vehicle
To locate your vehicle, if
you have locked it, in a
car park:
If the remote control does not work
after the battery has been changed,
re-programme the remote control.
In this case, your vehicle will not
start. Contact a PEUGEOT dealer as
soon as possible.
A heavy object attached to the key
(key ring, ...), weighing down on the
shaft of the key in the switch, may
cause a malfunction.
Reprogramming the remote
control
Following disconnection of the vehi-
cle’s battery, replacement of the re-
press button B, the courtesy lights
come on and the direction indica-
tors flash for a few seconds.
62