Download User Manual App

Quickly access user manual for free!

Practical information -> Bonnet for Your Peugeot 308 4 Door 2021-2025

Practical information  
system, the wipers and the dipped beam  
headlamps or courtesy lamps, for a combined  
duration of approximately 40 minutes.  
indicator lamp is off on the instrument panel  
and wait 4 minutes - risk of serious injury!  
Load reduction mode  
This system manages the use of certain  
functions according to the level of charge  
remaining in the battery.  
Selecting the mode  
A confirmation message is displayed when  
energy economy mode is entered, and the active  
functions are placed on standby.  
When the vehicle is being driven, the load  
reduction function temporarily deactivates certain  
functions, such as the air conditioning and the  
heated rear screen.  
The deactivated functions are reactivated  
automatically as soon as conditions permit.  
The location of the interior bonnet  
release lever prevents the bonnet being  
opened when the left-hand front door is  
closed.  
If a telephone call is in progress at the  
time, it will be maintained for around 10  
minutes via the audio system’s hands-free  
system.  
Bonnet  
When the engine is hot, handle the  
exterior safety catch and the bonnet stay  
with care (risk of burns), using the protected  
area.  
When the bonnet is open, take care not to  
damage the safety catch.  
Stop & Start  
Exiting the mode  
These functions are automatically reactivated the  
next time the vehicle is used.  
Before doing anything under the bonnet,  
you must switch off the ignition to avoid any  
risk of the engine restarting automatically.  
Take care with objects or clothing that could  
be caught in the blades of the cooling fan  
or in certain moving components - risk of  
strangulation and serious injury!  
To restore the use of these functions  
immediately, start the engine and let it run:  
– For less than 10 minutes, to use the  
equipment for approximately 5 minutes.  
– For more than 10 minutes, to use the  
equipment for approximately 30 minutes.  
Let the engine run for the specified duration to  
ensure that the battery charge is sufficient.  
To recharge the battery, avoid repeatedly or  
continuously restarting the engine.  
Do not open the bonnet under very windy  
conditions.  
Cooling of the engine when stopped  
The engine cooling fan may start after  
the engine has been switched off.  
Take care with objects or clothing that  
could be caught in the blades of the fan!  
Rechargeable hybrid vehicles  
A flat battery prevents the engine from  
starting.  
For more information on the 12 V battery,  
refer to the corresponding section.  
Before any work is carried out under the  
bonnet, it is essential to switch off the ignition  
and disconnect the charging connector nozzle  
if it is connected, check that the READY  
168  
Practical information  
Diesel engine  
Opening  
Closing  
7
► Lower the bonnet and release it near the end  
of its travel.  
► Check the locking.  
Because of the presence of electrical  
equipment under the bonnet, it is strongly  
recommended that exposure to water (rain,  
washing, etc.) be limited.  
1. Screenwash fluid reservoir  
2. Engine coolant reservoir  
3. Brake fluid reservoir  
4. Battery/Fuses  
5. Remote earth point (-)  
6. Fusebox  
Engine compartment  
The engine shown here is an example for  
illustrative purposes only.  
The locations of the following components may  
vary:  
► Open the left-hand front door.  
► Pull the interior release lever, located at the  
bottom of the door frame, towards you.  
7. Air filter  
– Air filter.  
8. Engine oil filler cap  
9. Engine oil dipstick  
– Engine oil dipstick.  
– Engine oil filler cap.  
Petrol engine  
Diesel fuel system  
This system is under very high pressure.  
All work must be carried out only by a  
PEUGEOT dealer or a qualified workshop  
Checking levels  
Check all of the following levels regularly in  
accordance with the manufacturer's service  
schedule. Top them up if required, unless  
otherwise indicated.  
► Lift the exterior safety catch and raise the  
bonnet.  
► Unclip the stay from its housing and place it  
in the support slot to hold the bonnet open.  
169