CHECKS -> AIR FILTER AND PASSENGER COMPARTMENT FILTER for Your Peugeot 407 4 Door First Generation (2004-2011)

CHECKS  
9
It may be necessary to check  
the brake pads for wear, even  
between services.  
press the red button on the angle  
of the front right-hand suspension  
housing, under the bonnet.  
CHECKS  
Battery  
At the start of winter, have  
your battery checked by a  
PEUGEOT dealer.  
RUNNING OUT OF FUEL  
(DIESEL)  
Parking brake  
If you should run out of fuel, it is ne-  
cessary to prime the fuel system.  
The priming pump and the bleed screw  
are located under the bonnet (see cor-  
responding illustration in the technical  
information section):  
Where the parking brake trav-  
el is too great or there is a re-  
duction in the performance of  
the system, the parking brake  
should be adjusted.  
Air filter and passenger compartment filter  
Have the filter elements  
replaced regularly. If you  
drive in dusty conditions,  
change them twice as often.  
Have the system checked by a PEUGEOT  
dealer.  
1.6 litre 16V HDI engine  
To ensure the best perfor-  
mance from components as  
important as the power steer-  
Particle emission filter (Diesel)  
-
fill the fuel tank with at least five li-  
tres of diesel,  
ing and the braking system,  
It is essential that the particle emission  
filter is maintained in accordance with  
the manufacturer's servicing schedule,  
by a PEUGEOT dealer.  
the manufacturer selects and offers  
specific products, only use products  
recommended by PEUGEOT.  
-
squeeze and release the manual  
priming pump until fuel appears in  
the transparent pipe,  
Note: following prolonged operation  
of the vehicle at very low speed or at  
idle, you may, in exceptional circum-  
stances, notice emissions of water va-  
pour at the exhaust on acceleration.  
This does not have any effect on the  
performance of the vehicle or the en-  
vironment.  
On vehicles which are fitted with a par-  
ticle emission filter, the cooling fan may  
operate after the vehicle has stopped,  
even when the engine is cold.  
-
operate the starter until the engine  
starts.  
Disc wear status  
For any information relating to check-  
ing disc wear, contact a PEUGEOT  
dealer.  
2 litre 16V HDI engine  
-
fill the fuel tank with at least five li-  
tres of diesel,  
unscrew the bleed screw,  
squeeze and release the manual  
priming pump until diesel is seen  
escaping via the bleed screw,  
retighten the bleed screw,  
operate the starter until the engine  
starts.  
To prevent damage to the electrical  
units, high pressure washing of the en-  
gine compartment is strictly prohibited.  
-
-
FUEL SUPPLY CUT-OFF  
(PETROL)*  
-
-
Brake pads  
As a safety precaution, in certain cir-  
cumstances the fuel supply to the en-  
gine is cut off.  
Brake pad wear depends on  
the style of driving, in particu-  
lar for vehicles which are used  
in town, over short distances.  
To re-establish the fuel supply:  
* According to version.  
112