Audio equipment - 31
Adjusting the front/rear sound
distribution (Fader)
Selecting radio mode
RADIO
Audio RB3: press the
"SRC" button several
times in succession.
When "FAD" is displayed, press
button I or J.
Button I increases the volume in the
Notes on radio reception
Your car radio is subject to pheno-
mena which do not affect domestic
radio sets. Both AM (MW/LW) and
FM reception are subject to various
forms of interference. This is no re-
lection on the quality of the equip-
ment, but is due to the nature of the
signals and the way in which they are
transmitted.
On MW/LW, interference may be
noticed when passing under high
voltage power lines or bridges, or in
tunnels.
On FM, interference may be the result
of increasing distance from the trans-
mitter, delection of the signals by
obstacles (mountains, hills, buildings,
etc.), or of being in an area which is
not covered by a transmitter.
front.
Button J increases the volume in the
rear.
Audio RD3: press
button R.
Adjusting the right/left sound
distribution (Balance)
When "BAL" is displayed, press
button I or J.
Button I increases the volume on the
right-hand side.
Button J increases the volume on the
left-hand side.
Selecting a waveband
Audio RB3: briely
press the "BND/AST"
button to select the
FM1, FM2, FMast and
AM wavebands.
Automatic volume correction
This function enables the volume to
be automatically adjusted depending
on the level of noise produced by the
speed of the vehicle.
Press buttons I or J to switch the
function on or off.
Audio RD3: briely
press button
R
to
select the FM1, FM2,
FMast and AM wave-
bands.
01-02-2005
English 
