Access
Risk of explosion or leaking of
inflammable liquid or gas!
Do not use in/store in/place in an environment
where the temperature is extremely high or
where the pressure is extremely low due to
very high altitude.
► Switch off the ignition and remove the key
from the ignition switch.
The remote control is now fully operational
again.
Central locking / unlocking
This function enables the doors to be locked or
unlocked simultaneously from inside the vehicle.
2
Do not try to burn, crush or cut a used battery.
Reinitialising the remote
control
Following replacement of the battery or in
the event of a fault, it may be necessary to
reinitialise the remote control.
When locking/deadlocking from the
outside
When the vehicle is locked or deadlocked
from the outside, the indicator lamp flashes
and the button is deactivated.
► After normal locking, pull one of the
interior door controls to unlock the vehicle.
► After deadlocking, you must use the
remote control, the "Keyless Entry and
Start" system or the built-in key to unlock the
vehicle.
► Insert the mechanical key (incorporated into
the remote control) into the lock to open the
vehicle.
► Place the electronic key against the back-up
reader on the steering column and hold it there
until the ignition is switched on.
► With a manual gearbox, place the gear lever
in neutral then fully depress the clutch pedal.
► With an automatic gearbox, while in mode
P, depress the brake pedal.
Without Keyless Entry and Start
► Switch on the ignition by pressing the
"START/STOP" button.
Manual mode
If the fault persists after reinitialisation, contact
a PEUGEOT dealer or a qualified workshop
without delay.
► Press this button to lock / unlock the
vehicle.
► Switch the ignition off.
► Turn the key to position 2 (Ignition on).
► Immediately press the closed padlock button
for a few seconds.
Driving with the doors locked could make
it difficult for the emergency services to
enter the vehicle in an emergency.
41
English 
