countertop with a damp cloth and a mild liquid soap. Should some dried-on residue still be present wet
a damp cloth moistened with the liquid cleaner stand directly on
top of that residue for 15-30 minutes to loosen the residue, then
clean that spot accordingly.
Please note that strong chemicals, solvents, and cleaners (e.g.,
oven cleaner) may damage the surface; so do not use any
products not specifically designed for countertop cleaning.
The countertop (Figure 7-2) may be physically damaged, too, if
proper care is not taken. Do not cut anything (e.g., vegetables,
fruits) directly on the countertop; rather, use a cutting board on
top of the countertop to provide necessary protection. Excessive
heat may also damage the countertop; therefore, any pots or pans
taken directly from the range or oven should not be placed
directly on the countertop; rather, use trivets or some other form
of fireproof heat insulators to hold very hot pots or pans on the
countertop.
All drawers are equipped with metal slides to provide additional
load-bearing strength for the drawers and to permit effortless
opening and closing of those drawers, even when they are fully loaded. These metal guides have a slight
“locking” action, when closed. To open those drawers, slightly lift up on the drawer handle and then
pull the drawer open.
To close, push the drawer closed until it “clicks” back into place (i.e., the locking action is engaged).
As this cabinetry is typically of furniture-grade quality, any commercial furniture polish or cleaner can
be used. Do not try to soak these wooden surfaces with any water or any other liquid; be sure to wipe
up spills or residues of any fluids that contact these surfaces to preclude any staining or discoloration of
the cabinet surfaces.
KITCHEN, LIVING & DINING AREAS
Sofa Booth
On the Wayfarer floor plan, a built in dinette booth (Figure 7-3) or sofa
are available. Both provide additional storage under the seat area, in
addition to providing additional sleeping facilities.
Dinette Instructions
1. Remove seat back and side cushions.
2. Slide seat bottoms back.
3. Pull the lever underneath the table to release the table down.
4. Reinstall the seat back cushions and back
rests to make up the mattress for the bed.
56
English