Parking 231
3. Hold the original remote control approx. 12 in.
(30 cm) away from the marked position
(illustration) and press and hold the transmit
button until the vehicle’s turn signal lights flash
on and off three times or the indicator light A
starts flashing quickly.
The turn signal lights flash three times and the
indicator light A flashes quickly to confirm that
the new signal has been programmed
successfully.
Several attempts with different distances
between the vehicle and the original remote
control may be necessary.
4. The turn signal lights will flash once when the
5 minutes teaching time are up.
Repeat steps 2 to 3.
f Repeat steps 2 to 4 to assign signals to the
other buttons.
Assigning garage door opener signal to
button with changeable code system
1. The standard factory-set codes must be
deleted before programming for the first time.
2. Press and hold the desired button on the
overhead operating console keypad until the
indicator light A on the button starts to
flash slowly.
You now have 5 minutes to teach the button.
3. Hold the original remote control approx. 12 in.
(30 cm) away from the marked position
(illustration) and press and hold the transmit
button until the vehicle’s turn signal lights flash
on and off three times or the indicator light A
starts flashing quickly.
The turn signal lights flash three times and the
indicator light A flashes quickly to confirm that
the new signal has been programmed
successfully.
Several attempts with different distances
between the vehicle and the original remote
control may be necessary.
4. To synchronize the system:
Press the programming button on the receiver
of the garage door opener.
Afterwards, you usually have approx.
30 seconds to initiate step 5.
5. Press the button you selected in step 2 on
the overhead operating console keypad.
(You must press the button on the keypad
several times to complete the setting process
for some devices.)
6. Repeat steps 2 to 5 to assign signals to the
other buttons.
Information
f Please consult an authorized Porsche dealer if
you have not been able to successfully assign
signals to the buttons even though you have
carefully followed the instructions in this
section and the operating instructions for the
original remote control. Your authorized
Porsche dealer has a list of all garage door
opener signals that can be adapted.
f Make sure that the battery in the remote
control for the garage door opener is new.
If the battery voltage is inadequate, faults may
occur in signal transmission. The system in the
vehicle then learns the wrong code, which will
not be recognized reliably by the garage door
opening mechanism.
English 
