2011-2017 Porsche Cayenne SUV Seats, Mirrors, Steering Wheel and Sun Protection -> Safety Belts User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Seats, Mirrors, Steering Wheel and Sun Protection -> Safety Belts for Your Porsche Cayenne SUV Second Generation (2011-2017)

44 Seats, Mirrors, Steering Wheel and Sun Protection
Safety Belts
Safety belts cannot protect the body if they are
not fastened. Improperly worn safety belts
increase the risk of injury in the event of an
accident.
Always make sure your and your passengers'
safety belts are properly fastened when seated in
the vehicle.
f For your and your passengers' protection, use
safety belts at all times while the vehicle is in
motion.
f Use appropriate child restraint systems for all
small children.
f Safety belts must be positioned on the body as
to restrain the upper body and lap from sliding
forward. Improperly positioned safety belts
can cause serious personal injury in case of an
accident.
f The shoulder belt should always rest on your
upper body. The shoulder belt should never be
worn behind your back or under your arm.
f For maximum effectiveness, the lap belt
should be worn low across the hips.
f Pregnant women should position the belt as
low as possible across the pelvis. Make sure it
is not pressing against the abdomen.
f Belts should not be worn twisted.
f Do not wear belts over rigid or breakable
objects in or on your clothing, such as eye
glasses, pens, keys, etc. as these may cause
injury.
f Several layers of heavy clothing may interfere
with proper positioning of belts.
f Belts must not rub against sharp objects or
damage may occur to the belt.
f Two occupants should never share the same
belt at the same time.
Damaged, heavily stressed or worn safety belts
cannot protect the body sufficiently in the event of
an accident.
f Keep belt buckles free of any obstruction that
may prevent a secure locking.
f Belts that have been subjected to excessive
stretch forces in an accident must be
inspected or replaced to ensure their
continued effectiveness in restraining you.
The same applies to belt tensioner systems
which have been triggered. In addition, the
anchor points of the belts should be checked.
f If safety belts do not work properly, see your
authorized Porsche dealer immediately.
f If the belts show damage to webbing, bindings,
buckles or retractors, they should be replaced
to ensure safe operation.
f Do not modify or disassemble the safety belts
in your vehicle.
f The belts must be kept clean or the retractors
may not work properly.
Please see the chapter “CLEANING THE
SAFETY BELTS” on page 260.
f Never bleach or dye safety belts.
f Do not allow safety belts to retract until they
are completely dry after cleaning or this may
cause damage to the belt.
Belt tensioner
Depending on the force of a collision, fastened
safety belts are automatically tightened in an
accident.
The belt tensioners are triggered in:
– Front and rear impacts of sufficient severity
– Side impacts
– In cases of vehicle rollover
Information
The belt tensioner system can be triggered only
once; the system must be replaced afterwards.
If there is a fault in the belt tensioner system, the
airbag warning light lights up.
Work may be performed on the belt tensioner
system only by an authorized Porsche dealer.
Smoke is released when the belt tensioners are
triggered.
This does not indicate a fire in the vehicle.
An audio-visual warning system is
interconnected with the driver’s safety belt.
Every time the ignition is turned on, the gong will
sound for about 6 seconds to remind driver and
passenger to buckle up.
In addition, the gong will sound for approximately
90 seconds if vehicle speed exceeds 15 mph
(24 km/h).
The safety belt warning lights in the instrument
panel and multi-purpose display will go off as soon
as the driver has buckled up.
Failure to Use Safety
Belts
DANGER
h
Using Damaged Safety
Belts
DANGER
h
Safety belt warning system
Seats, Mirrors, Steering Wheel and Sun Protection 45
Fastening the safety belt
1. Assume a comfortable sitting position.
2. Adjust the seat backrest so that the belt always
rests on your upper body and runs across the
middle of your shoulder.
3. Grasp the belt tongue and pull the belt in
a slow, continuous motion across your chest
and lap.
Information
The belt can be blocked if the vehicle is standing
at an angle or the belt is pulled out using a jerking
movement.
The belt cannot be pulled out while accelerating
and slowing down, when cornering and when
driving uphill.
4. Insert the belt tongue into the appropriate
buckle on the inboard side of the seat until
it locks securely with an audible click.
5. Make sure that belts are not trapped or twisted
and that they are not rubbing on sharp edges.
6. The horizontal section of the belt should
always fit snugly across the pelvis. Therefore,
after fastening the belt, always pull the
diagonal part of the belt upward.
Pregnant women should position the belt as
low as possible across the pelvis, and ensure
that it is not pressing against the abdomen.
7. Pull on the diagonal section of the belt now and
again during the journey to ensure that the
horizontal section remains tight.
8. Make sure that the belts and buckles fit
correctly on the rear seat bench.
Releasing the safety belt
1. Hold the belt tongue.
2. Press the red button (arrow).
3. Guide belt tongue to the reel.
Safety belt height adjustment
The height of the belt deflectors on the front seats
can be adjusted.
f Adjust the height of the safety belt so that it
runs across the middle of the shoulder, not
against the neck.
Adjusting the belt height
f Upward – push belt deflector up.
f Downward – press locking button A and move
belt deflector.

Related Topics

Popular Owner Manuals