2019-2024 Porsche Taycan 2 Door 12-volt battery User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

12-volt battery for Your Porsche Taycan 2 Door First Generation (2019-2024)

A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
12-volt battery
282
12-volt battery
General safety instructions
The 12-volt lithium battery is automatically discon-
nected from the vehicle electrical system if the bat-
tery charge condition is low. The vehicle cannot be
operated if the 12 V lithium battery is discharged.
The electrical system is deactivated temporarily.
e Observe warning message.
To charge the 12 V lithium battery:
e Establish operational readiness.
> Please refer to chapter "Starting, driving and
stopping the vehicle" on page 236.
– or –
e Charging the 12 V battery using the charger.
– or –
e Supply external power from another vehicle for
at least 5 minutes.
Then establish operational readiness or charge
the 12 V battery using a charger.
After establishing operational readiness and when
the battery is charged (for at least 10 minutes) or
when the vehicle has been connected to an external
power supply, the electrical system is reactivated
automatically. The 12-volt lithium battery is auto-
matically reconnected to the vehicle electrical
system.
Another vehicle's battery can be used as an external
power supply with the help of jump leads. Both bat-
teries must have a nominal voltage of 12 V. The ca-
pacity (Ah) of the donor battery must not be
substantially less than that of the flat battery. The
flat 12 V lithium battery must be connected properly
to the vehicle electrical system.
The need to repeatedly provide power from a power
supply or repeated charging of the 12 V lithium bat-
tery under normal operating conditions may indicate
that the 12 V lithium battery is damaged.
e Never connect jump leads or a the charger di-
rectly to the 12 V lithium battery.
WARNING
Electric shock, short cir-
cuit, fire or explosion
Touching conductive parts of the vehicle can give
you an electric shock. You can cause a short circuit
when working on the vehicle's electrical system.
Short circuits can cause fires.
e The battery should only be removed and installed
or have work performed on it at a qualified spe-
cialist workshop. Porsche recommends a Por-
sche partner as they have trained workshop
personnel and the necessary parts and tools.
WARNING
Escaping electrolyte fluid
and toxic gases
Risk of electrolyte fluid and toxic gases escaping in
exceptional cases if the 12 V lithium battery is
damaged or handled incorrectly.
e Avoid any inhalation of the vapours and any skin
contact with the electrolyte fluid.
e Keep people away and stay on the side facing
into the wind.
e The 12 V lithium battery should only be charged
in well-ventilated areas.
NOTICE
Risk of short circuit, fire and damage to electronic
control units and components.
e The battery should only be removed or installed
by a qualified specialist workshop. Porsche rec-
ommends a Porsche partner as they have trained
workshop personnel and the necessary parts and
tools.
e Disconnect the negative terminal on the battery
during all work on the electrical system.
The 12 V lithium battery is located under a plastic
cover in the front luggage compartment. Please re-
fer to chapter "Installing and removing the plastic
cover in the front luggage compartment" on
page 155.
Safety symbols on the 12 V lithium battery
Read instructions
Wear eye protection
Danger of explosion
Fire, sparks, naked flames and smoking
are prohibited
Avoid causing sparks and short circuits
when handling cables and electrical
devices.
Danger of caustic burns
Electrolyte fluid is highly corrosive: wear
safety gloves and eye protection.
First aid
If electrolyte fluid splashes into your eye,
rinse immediately for a few minutes with
clean water. Immediately seek medical
attention from a doctor. If electrolyte
fluid splashes onto your skin or clothing,
neutralise immediately with soapsuds
and rinse with plenty of water. If you ac-
cidentally drink electrolyte fluid, consult
a doctor immediately.
Keep children away
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
12-volt battery
283
Disposal
Hand in the old battery at a battery col-
lection point.
Never dispose of an old battery with do-
mestic waste.
Always have maintenance work carried
out by qualified technicians
Never attempt to replace the 12 V lith-
ium battery yourself. The 12 V lithium
battery of this vehicle must only be re-
placed with a 12 V lithium battery ex-
plicitly specified by Porsche for this
vehicle. The use of other 12 V lithium or
lead-acid batteries will result in consid-
erable malfunctions, including total fail-
ure of the electrical system.
Always have the 12 V lithium battery re-
placed by a qualified specialist work-
shop. Porsche recommends a Porsche
partner as they have trained workshop
personnel and the necessary parts and
tools.
12 V lithium battery
What do I
want to do?
What do I have to do?
Avoid run-
ning down
the battery
e Switch off unneeded electri-
cal loads on short trips.
Prepare for
winter
driving
e Have the 12 V lithium battery
checked before the start of
winter.
What do I
want to do?
What do I have to do?
Charging
the 12 V
lithium
battery
e Never charge a damaged 12 V
lithium battery.
Lay up the
vehicle
e If the vehicle is left for long
periods in the garage or
workshop, the doors and lids
of the vehicle should be
closed.
e Turn off the vehicle.
Information
The 12 V lithium battery still discharges even when
your vehicle is not in use.
e To maintain its function, charge the 12 V lithium
battery approximately every 6 weeks or connect
it to a trickle charger suitable for lithium bat-
teries with a CC/CV or pure CV characteristic.
Porsche recommends Porsche Tequipment
chargers and trickle chargers.
Charging the 12 V battery using the charger
Fig. 225: 12 V lithium battery terminals
CAUTION
Escaping irritating gases
due to a damaged 12 V
lithium battery
The use of non-approved chargers or boosters can
result in the 12 V lithium battery being charged with
excessive charging voltage and excessive charging
current. This can damage the 12 V lithium battery,
and irritating gases can escape. This can cause con-
siderable damage to the vehicle and burns.
e Only use chargers or boosters that have been
approved by the equipment manufacturer for
LiFePO
4
batteries with integrated electronic
protection circuits.
e The following maximum values must never be
exceeded:
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
12-volt battery
284
– Max. charging voltage: 14.8 V (even in the
event of a fault with the 12 V lithium battery
disconnected; no voltage peaks permitted)
– Max. charging current: 90 A
e If in doubt, contact your Porsche partner.
e Observe the instructions of the charger
manufacturer.
e Ensure adequate ventilation when charging the
12 V lithium battery.
1. Open the bonnet.
> Please refer to chapter "Opening and closing
the bonnet and tailgate" on page 153.
2. Remove the plastic refer to
chapter "Installing and removing the plastic cov-
er in the front luggage compartment" on
page 155.
3. Fold open the cap on the positive terminal for
jump-lead starting +.
4. Connect the red positive cable of the charger to
the positive terminal for jump-lead starting +.
5. Connect the black negative cable of the charger
to the ground point –.
6. Switch on the charger.
7. After charging the battery, first switch off the
charger and then disconnect it.
8. Close the cap on the positive terminal for jump-
lead starting +.
9. Install the plastic cover. Please refer to
chapter "Installing and removing the plastic cov-
er in the front luggage compartment" on
page 155.
For recommendations on a suitable charger:
e Contact your Porsche partner.
Supplying external power from another
vehicle
WARNING
Unsuitable jump leads
and incorrect procedures
Supplying external power using unsuitable jump
leads or following incorrect procedures can cause
short circuits. Short circuits can cause fires.
e Use only standard jump leads with sufficient
cross section and completely insulated terminal
clamps. Follow the instructions provided by the
jump lead manufacturer.
e The vehicles must not touch, otherwise current
may flow as soon as the positive terminals are
connected.
e Ensure that conductive jewellery (e.g. rings,
chains, watch straps) does not come into contact
with live parts of the vehicle.
e Never connect jump leads directly to the 12 V
lithium battery or other electrical components.
Only connect jump leads to the jump-lead start-
ing terminals.
NOTICE
Exhaustively discharged
12 V lithium battery
Risk of damage when supplying external power to an
exhaustively discharged 12 V lithium battery.
e If you suspect that the 12 V lithium battery is
exhaustively discharged, do not supply power
from an external source.
NOTICE
External power supply or
emergency starting
Emergency starting and supplying external power
can severely damage the vehicle electronics.
e Do not supply external power or initiate emer-
gency starting.
e Contact a qualified specialist workshop. Porsche
recommends a Porsche partner as they have
trained workshop personnel and the necessary
parts and tools.
1. Open the bonnet. Please refer to
chapter "Perform emergency unlocking of the
bonnet" on page 58.
2. Remove the plastic cover. Please refer to
chapter "Installing and removing the plastic cov-
er in the front luggage compartment" on
page 155.
Fig. 226: 12 V lithium battery terminals
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
12-volt battery
285
3. Fold open the cap on the positive terminal for
jump-lead starting +.
4. Connect the red positive cable to the positive
terminal for jump-lead starting +.
5. Connect the red positive cable to the positive
terminal of the donor battery.
6. Connect the black negative cable to the negative
terminal of the donor battery.
7. Connect the black negative cable to the ground
point–.
8. Allow the engine of the donor vehicle to run at a
higher engine speed.
9. Charge the 12 V lithium battery from the exter-
nal power supply (min. 5 minutes).
The electrical system is reactivated
automatically.
10.Ready for operation:
First, disconnect the black negative cable from
the ground point – then from the negative ter-
minal of the donor battery.
11.Ready for operation:
Disconnect the red positive cable from the pos-
itive terminal of the donor battery first, then from
the positive terminal for jump-lead starting +.
12.Close the cap on the positive terminal for jump-
lead starting +.
13.Install the plastic cover. Please refer to
chapter "Installing and removing the plastic cov-
er in the front luggage compartment" on
page 155.
14.To continue charging the 12 V lithium battery:
Charge the 12 V lithium battery using the
charger. Please refer to chapter "Charging the 12
V battery using the charger" on page 283.
– or –
Establish operational readiness. Please refer to
chapter "Starting, driving and stopping the ve-
hicle" on page 236.
Replacing the 12 V lithium battery
WARNING
Danger of fire due to un-
suitable 12 V lithium
battery
In addition to significant malfunctions of the vehicle
electrical system, use of an unsuitable 12 V lithium
battery or its incorrect installation may in excep-
tional cases cause a fire (e.g. during charging).
e Never attempt to replace the 12 V lithium bat-
tery yourself. Only have the 12 V lithium battery
of this vehicle replaced with a 12 V lithium bat-
tery explicitly specified by Porsche for this ve-
hicle. The use of other lithium or lead-acid
batteries results in significant malfunctions in-
cluding total failure of the electrical system.
e Always have the 12 V lithium battery replaced by
a qualified specialist workshop. Porsche recom-
mends a Porsche partner as they have trained
workshop personnel and the necessary parts and
tools.
e Observe the disposal instructions for lithium
batteries.
Power interruption
Following a temporary power interruption, some
equipment has to be reinitialised.
1. Store the end position for the power windows.
> Please refer to chapter "Windows" on
page 277.
2. Registering wheels and tyres in Tyre Pressure
Monitoring (TPM).
> Please refer to chapter "Tyres and Wheels"
on page 249.

Related Topics

Popular Owner Manuals