2019-2024 Porsche Taycan 2 Door Porsche Active Suspension Management (PASM) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Porsche Active Suspension Management (PASM) for Your Porsche Taycan 2 Door First Generation (2019-2024)

A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Porsche Active Suspension Management (PASM)
187
Porsche Active Suspension
Management (PASM)
General safety instructions
Responding to warning messages
Always heed any warning and information messages
displayed in the vehicle.
> Please refer to chapter "Warning and information
messages" on page 271.
Operating principle
The PASM system actively adjusts the chassis dy-
namics. Your vehicle may be equipped with one of
the following versions:
– PASM with steel suspension.
– PASM with selectable air suspension and level-
ling system
The adjustable chassis system individually sets the
appropriate damper force level for each wheel.
3 different chassis setups can be selected at the
push of a button:
– Normal: comfort setup
– Sport: sporty setup
– Sport Plus: very sporty shock setup, such as for
driving on the race circuit.
PASM with selectable air suspension and lev-
elling system
The levelling system provided with the air suspen-
sion automatically balances load changes and main-
tains a constant ride height. The following chassis
heights are available:
Medium
– Standard level in the "Normal" and "Sport" chas-
sis setups
– Can be selected manually in the "Sport Plus"
chassis setup
Lift
– Increases the ground clearance by approx.
20 mm compared to the "Medium" level.
– Can be selected at speeds of up to approx.
30 km/h (19 mph) and is deselected automati-
cally at higher speeds.
– Used to drive over obstacles.
Lower
– Reduces the ground clearance by approx. 10 mm
compared to the "Medium" level.
– Can be selected manually.
Low
– Reduces the ground clearance by approx. 22 mm
compared to the "Medium" level.
– Used for sporty driving.
– Can be selected manually.
– Selected automatically when the "Sport Plus"
chassis setup is active or when RANGE drive
mode is active.
When RANGE drive mode is active, a range-opti-
mised chassis setup is selected and the low level is
applied. Chassis setup selection is locked in RANGE
drive mode.
Selecting chassis setup
Selecting chassis setup using buttons
Fig. 138: PASM button
bb Ready for operation.
e Press button (repeatedly).
Selecting chassis setup via the central display
bb Ready for operation.
e
e Drive e Chassis
The last selected chassis setup is shown on the in-
strument cluster. It remains effective even when the
vehicle is no longer ready for operation.
Display Chassis setup
None Normal
Sport
Sport Plus
Selecting the chassis height
bb Porsche Active Suspension Management
(PASM) with air suspension and levelling system
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Porsche Active Suspension Management (PASM)
188
Selecting chassis height via the central
display
bb Ready for operation.
e
e Drive e Chassis height
Selecting chassis height "Lift" using the
button
The chassis height "Lift" can be selected using the
button on the instrument cluster in order to increase
ground clearance quickly.
Fig. 139: Lift button
bb Ready for operation.
e Press the button.
The selected chassis height is displayed on
the instrument cluster.
The last selected chassis height is shown on the in-
strument cluster. This is retained even after the ve-
hicle has been turned off.
Display Chassis height
None Medium
Lift
Display Chassis height
Lower
Low
Information
The vehicle will not be lowered with the door open.
The selected level is set after closing the door.
Information
Frequent level changes can cause the compressor to
overheat. In this case, the compressor must cool for
several minutes before the levelling system is fully
functional again. The vehicle adjusts automatically
to the selected level when the compressor cools
down.
Switching the levelling system off
WARNING
Lifting the vehicle
If a PASM or hot vehicle warning message is dis-
played, there is a risk of injuries and damage to the
vehicle if the vehicle is hoisted.
e The vehicle must only be hoisted when cool.
e If a PASM warning message is displayed, you
should not perform any work on the chassis
yourself. Call in a qualified specialist workshop.
Porsche recommends a Porsche partner as they
have trained workshop personnel and the neces-
sary parts and tools.
WARNING
Control operation of the
levelling system
A vehicle on which the levelling system is activated
can move unexpectedly or tip or fall off lifting
equipment, e.g. a jack or lifting platform. This can
result in serious injury and damage.
e Set the vehicle to the medium level and switch
off the levelling system before hoisting the
vehicle.
> Please refer to chapter "Jack and Lifting Plat-
form" on page 138.
e
e Setting e Vehicle e Additional chassis
settings e Deactivate chassis adjustment
before using a jack
Information
The levelling system is switched on automatically at
speeds of more than approx. 7 km/h (4 mph).
Additional information
Lowering the vehicle after leaving it unused
for long periods
bb Porsche Active Suspension Management
(PASM) with air suspension and levelling system
If the vehicle is left unused for several weeks, the
ride height may be lowered. The vehicle will com-
pensate for this lowering automatically once opera-
tional readiness has been established. This process
may take several minutes depending on the vehicle.
During this time, ground clearance is reduced.
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Porsche Active Suspension Management (PASM)
189
Levelling after parking the vehicle
bb Porsche Active Suspension Management
(PASM) with an air suspension and levelling
system
The ride height may be adjusted automatically in or-
der to balance the vehicle load after the vehicle is
parked.

Related Topics

Popular Owner Manuals