2025-2026 Porsche Taycan 2 Door Lane Change Assist (LCA) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Lane Change Assist (LCA) for Your Porsche Taycan 2 Door Second Generation (2025-2026)

A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Lane Change Assist (LCA)
139
Lane Change Assist (LCA)
General safety instructions
WARNING
Lack of attention
Even with Lane Change Assist and Rear Turn Assist,
absolute care and attention on the part of the driver
is still required while driving. Ultimately, the driver is
still responsible for changing lanes.
e Keep the direction of travel and the relevant area
around the vehicle in view at all times.
WARNING
Vehicles not detected
Vehicles cannot or may not be detected by the sys-
tem in time in the following situations:
– The view of the radar sensors may be reduced in
adverse weather conditions (rain, snow, ice,
heavy spray), in tight bends, and when ap-
proaching crests.
– Lane Change Assist will only warn of approach-
ing vehicles or vehicles in the blind-spot area
from a speed of approx. 15 km/h (9 mph).
– Vehicles that approach at high speed from be-
hind or vehicles that are falling back.
– If the vehicle is not facing in the direction of the
driving lane when turning, but is facing diago-
nally or at right angles to it, approaching vehicles
can no longer be detected by the radar sensors.
– In the case of the Rear Turn Assist, it is possible
that, owing to the small differences in speed be-
tween your vehicle and moving or stationary ob-
jects, fixed objects (e.g. a metal post) may also
trigger a warning, or that slow-moving vehicles
are not detected.
– The Rear Turn Assist is activated when driving
off. It is therefore possible that vehicles that are
already moving or are driving off are not detected
or are only detected late. Vehicles already lo-
cated immediately next to your vehicle and
therefore outside of the detection range of the
sensor may also not be detected.
– The rear collision warning does not respond to
cross traffic, small cross-section vehicles, nar-
row vehicles, and objects that are not recognised
as vehicles.
e Keep the direction of travel and the relevant area
around the vehicle in view at all times.
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Lane Change Assist (LCA)
140
System limitations
– Only Rear Turn Assist is available at speeds be-
low 15 km/h (9 mph). When driving off, the
driver is therefore only supported by monitoring
of the area behind the vehicle on the side where
the direction indicator was actuated.
– Lane Change Assist and Rear Turn Assist are not
available if the system detects that the radar
sensors are covered.
– The rear collision warning may be switched off if
there is a malfunction in the Lane Change Assist.
– The radar sensors cover the adjacent lane to the
left and right. Other lanes are not covered by the
radar sensors.
– The radar sensors can sometimes detect other
objects (e.g. high or raised crash barriers), not
just vehicles.
Information
If the position of the radar sensors was changed fol-
lowing an accident, for example, this can impair the
function of Lane Change Assist.
e Visit a qualified specialist workshop. Porsche
recommends a Porsche partner as they have
trained workshop personnel and the necessary
parts and tools.
Information
To ensure that Lane Change Assist can work
properly:
e Do not cover the radar sensors on the rear
bumper (e.g. with stickers). Also remove any dirt,
snow and ice from this area.
e Do not cover the warning indicator in the exterior
mirror (e.g. with stickers).
e Subsequent painting of the bumper may lead to a
reduction in the sensor range owing to the
thicker coating layer. The electrical properties
may also differ from those of the approved
paints.
Fig. 97: Radar sensors in the rear bumper
Responding to warning messages
Always heed any warning and information messages
displayed in the vehicle.
> Please refer to chapter "Warning and information
messages" on page 271.
Operating principle
Lane Change Assist (LCA) warns the driver about
vehicles approaching from behind or those in the
blind-spot area. This applies both when overtaking
other vehicles and when your vehicle is being
overtaken.
Lane Change Assist measures the distance and
speed difference of detected vehicles compared to
your vehicle using the radar sensors integrated in the
rear bumper. The radar sensors capture an area of up
to 70 m to the rear and in the blind-spot area.
As soon as the direction indicator is activated for a
lane change regarded as critical, the warning indica-
tor in the respective exterior mirror lights up brightly
and briefly several times. The system therefore pro-
vides assistance separately for both sides of the
vehicle.
When slowly overtaking another vehicle (speed dif-
ference of less than approx. 15 km/h (9 mph)), the
warning indicator lights up as soon as this vehicle is
in your blind-spot area and is detected by Lane
Change Assist. If there is a greater speed difference,
this is not indicated in the exterior mirror.
Rear Turn Assist is always automatically switched to
standby together with Lane Change Assist. The
driver is supported by Rear Turn Assist until the Lane
Change Assist speed range is reached after driving
off.
When the direction indicator is on, Rear Turn Assist
detects objects located next to and behind your ve-
hicle, but only at the side on which the indicator has
been activated. If a potential hazard is detected, the
respective warning indicator on the exterior mirror
lights up. If your own calculated driving path crosses
that of a detected vehicle on the side of the vehicle
on which the indicator has been activated, the cor-
responding warning indicator on the exterior mirror
will flash brightly and briefly several times.
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Lane Change Assist (LCA)
141
Rear collision warning
If the radar sensors in the rear of the vehicle detect
vehicles travelling behind, the system calculates the
probability of a rear-end collision.
If a collision risk is detected, the hazard warning
lights come on to alert the driver in the vehicle trav-
elling behind to the imminent danger situation.
In this case, the hazard warning lights could flash
faster than they normally would when switched on
manually.
Display elements
Lane Change Assist provides information by means
of two indicator levels, an information level and a
warning level, which are activated accordingly de-
pending on whether or not the direction indicator
has been set.
Information stage
If the direction indicator is not set, Lane Change As-
sist informs you about detected vehicles that are
considered critical for a possible lane change. The
warning indicator on the respective mirror lights up
dimly.
Warning stage
If the direction indicator is on and Lane Change As-
sist has detected a vehicle on this side that it re-
gards as critical, the warning indicator in the exterior
mirror on this side will briefly flash brightly multiple
times. You should check the driving situation again
by looking in the exterior mirror and looking over
your shoulder.
Fig. 98: Warning indicator on the exterior mirror
Switching Lane Change Assist on
and off
Lane Change Assist can be switched on and off in
the central display.
e
e Assistance e Lane Change Assist
When Lane Change Assist is active, the
sym-
bol appears on the instrument cluster.
Setting display brightness of Lane
Change Assist
The brightness of the display in the exterior mirror is
adjusted automatically to the ambient brightness.
The basic brightness can also be adjusted.
e
e Assistance e e Assistance system
settings e Lane Change Assist e LED
brightness
Additional information
Driving situations
The following driving situations describe possible
scenarios and the associated Lane Change Assist
and Rear Turn Assist warning indicators.
Vehicles approaching quickly
Fig. 99: Vehicle approaching fast
A – Warning indicator in exterior mirror does not
light up
The sensors do not detect a vehicle. Warning indi-
cator in exterior mirror does not light up.
B – Warning indicator lights up in the information
stage
A fast approaching vehicle – in the left lane in the
example – is detected. This vehicle is already re-
garded as critical for changing lanes due to the sig-
nificant speed difference, even though it is still a
good distance away. Warning indicator in the exte-
rior mirror lights up.
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Lane Change Assist (LCA)
142
C – Warning indicator flashes in the warning stage
If the direction indicator is switched on in driving
situation B, the warning indicator in the exterior
mirror flashes briefly several times. Lane Change
Assist alerts you to the fact that you may have
overlooked a vehicle.
Vehicles approaching slowly
Fig. 100: Vehicle approaching slowly
A – Warning indicator in the exterior mirror does
not light up
A slowly approaching vehicle – in the left lane in the
example – is detected. Due to the small speed dif-
ference and the large distance, the warning indicator
in the exterior mirror does not light up.
B – Warning indicator lights up in the information
stage
The slowly approaching vehicle is now closer. Warn-
ing indicator in the exterior mirror lights up. Only
when Lane Change Assist regards the speed differ-
ence and distance as critical for changing lanes does
the warning indicator in the exterior mirror light up.
You are alerted to all vehicles detected by Lane
Change Assist when they are in the blind-spot area
at the latest.
C – Warning indicator flashes in the warning stage
If the direction indicator is switched on in driving
situation B, the warning indicator in the exterior
mirror flashes briefly several times. Lane Change
Assist alerts you to the fact that you may have
overlooked a vehicle.
Vehicles falling back slowly
Fig. 101: Vehicle falling back slowly
A – Warning indicator in the exterior mirror does
not light up
The overtaken vehicle is not yet detected. Warning
indicator in the exterior mirror does not light up.
B – Warning indicator lights up in the information
stage
The vehicle on the right that is falling back slowly
(speed difference of less than approx.
15 km/h (9 mph)) – in the right lane in the example
– is detected. Warning indicator in the exterior mir-
ror lights up.
C – Warning indicator flashes in the warning stage
If the direction indicator is switched on in driving
situation B, the warning indicator in the exterior
mirror flashes briefly several times. Lane Change
Assist alerts you to the fact that you may have
overlooked a vehicle.
Vehicles falling back quickly
Fig. 102: Vehicle falling back quickly
A – Warning indicator in the exterior mirror does
not light up
The overtaken vehicle is not yet detected. Warning
indicator in the exterior mirror does not light up.
B – Warning indicator in the exterior mirror does
not light up
The vehicle on the right that is falling back fast
(speed difference of more than approx.
15 km/h (9 mph)) – in the right lane in the example
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Lane Change Assist (LCA)
143
– is detected, but is not regarded as critical for
changing lanes because it is falling back fast. Warn-
ing indicator in the exterior mirror does not light up.
C – Warning indicator in the exterior mirror does
not light up
If the direction indicator is switched on in driving
situation B, the warning indicator in the exterior
mirror is still not activated.
Pulling away to turn off
Fig. 103: Pulling away to turn off
A – Warning indicator in the exterior mirror does
not light up
The direction indicator has not been actuated. The
rear turn assist is therefore not active after driving
off and the motorbike located in the blind spot is not
detected. A fast approaching vehicle may not be
detected as well. Warning indicator in the exterior
mirror does not light up.
B – Warning indicator lights up in the information
stage
If the relevant direction indicator is switched on in
driving situation A, the warning indicator in the ex-
terior mirror lights up. Turn Assist alerts you to the
fact that you may have overlooked a vehicle.
C – Warning indicator flashes in the warning stage
If, in driving situation B, the driver has initiated
turning off by steering to the corresponding side and
this results in his own calculated driving path cross-
ing that of a detected vehicle, the warning indicator
in the exterior mirror flashes briefly several times
and then lights up. This warns you of a potential
collision with a vehicle that may have been
overlooked.
Driving around bends
When driving around a bend, Lane Change Assist
may react to a vehicle driving in the next lane but
one and the warning indicator in the exterior mirror
may light up.
Lane Change Assist cannot detect vehicles in tight
bends.
e Be particularly careful when driving around
bends.
Lane width
When driving on narrow lanes, the detection area
may cover even more lanes, particularly when driving
at the edge of a lane. In such situations, vehicles
driving two lanes away may be detected and Lane
Change Assist may switch to the information or
warning stage.
Likewise, when driving on very wide lanes, vehicles
in the adjacent lane may not be detected as they are
outside the detection area.
Fig. 104: Lane width and detection area

Popular Owner Manuals