2025-2026 Porsche Taycan 2 Door Windscreen Wiper User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Windscreen Wiper for Your Porsche Taycan 2 Door Second Generation (2025-2026)

A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Windscreen Wiper
279
Windscreen Wiper
General safety instructions
WARNING
Unintended wiping
In rain sensor mode, the windscreen wipers wipe
automatically if moisture is detected on the
windscreen.
e Always switch off the windscreen wipers before
cleaning the windscreen.
NOTICE
Risk of damage to luggage compartment lid, wind-
screen and wiper system.
e Only wipe the windscreen when sufficiently wet,
otherwise it could become scratched.
e Carefully detach frozen wiper blades from the
windscreen before driving.
e Always switch off windscreen wipers in car
washes to prevent them wiping unintentionally
(rain sensor operation).
Responding to warning messages
Always heed any warning and information messages
displayed in the vehicle.
> Please refer to chapter "Warning and information
messages" on page 271.
Controls
Fig. 223: Windscreen wiper stalk
0 Windscreen wipers off
1 Rain sensor operation
2 Slow wiping
3 Fast wiping
4 Wiping with one-touch function
5 Spray and wipe
Switching on rain sensor
operation
In rain sensor mode, the speed of the windscreen
wipers depends on the quantity of water measured
on the windscreen.
e Move the wiper stalk upwards to the first detent
(position 1).
The rain sensor operation is active.
Adjusting the rain sensor sensitivity
By adjusting the sensitivity in 4 stages, it is possible
to determine what water quantity on the windscreen
will trigger the next wiper operation.
Fig. 224: Switch for rain sensor/intermittent operation
High sensitivity (more frequent wiping)
e Move switch (A) upwards.
The setting is confirmed by one wipe of the
windscreen.
Low sensitivity (more infrequent wiping)
e Press switch (A) downwards.
Switching on continuous wiping
Slow wiping
e Move wiper stalk upwards to the second detent
(position 2).
Fast wiping
e Move wiper stalk upwards to the third detent
(position 3).
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Windscreen Wiper
280
Wiping with one-touch function
One-time wiping
e Briefly press the wiper stalk downwards
(position 4).
Multiple wiping
e Press and hold the wiper stalk downwards
(position 4).
Spraying and wiping
e Pull wiper stalk towards the steering wheel.
Spray nozzles and windscreen wipers are active
as long as the wiper stalk is held.
When the wiper stalk is released, the windscreen
wipers continue to perform a few drying wipes.
Switching the windscreen wipers
off
e Move the wiper stalks to position 0.
Information
After switching off the windscreen wipers or opera-
tional readiness, the wipers move up slightly from
their rest position so that the wiping edges are
aligned correctly.
Replacing wiper blades
CAUTION
Incorrectly fitted wiper
blades
If they are not changed properly, the incorrectly fit-
ted wiper blades can come loose while driving.
e The wiper blades must latch properly in the wiper
arm.
e Check that the wiper blades are fitted securely.
NOTICE
If the wiper arms accidentally fall back onto the
windscreen, they can damage the windscreen.
e Always hold the wiper arms securely when re-
placing the wiper blades.
It is essential for wiper blades to be in perfect con-
dition for a clear view. The wiper blades should be
replaced twice a year (before and after the cold
season) or if wiper performance deteriorates or the
blades are damaged.
Replacing front wiper blades
The windscreen wipers must be extended to replace
the wiper blades or fit ice or sun protective covers
underneath.
Extending the windscreen wipers
bb Switch off readiness for operation.
1. Press the wiper lever downwards once (position
4).
The windscreen wipers move upwards by approx.
90°.
2. Replace the wiper blades according to the sepa-
rate instructions provided by the manufacturer.
Note the different lengths of the wiper blades!
Retracting the windscreen wipers
bb Switch on readiness for operation.
e Press the wiper lever downwards for at least 2
seconds (position 4).
The windscreen wipers return to their home
position.
Information
Get a qualified specialist workshop to carry out this
work if necessary. Porsche recommends a Porsche
partner as they have trained workshop personnel and
the necessary parts and tools.
Cleaning the Night View Assist
and reversing cameras
> Please refer to chapter "Night View Assist" on
page 171.
> Please refer to chapter "ParkAssist" on page 176.
Additional information
Wiper behaviour when operational readiness
has been established.
– The wiper stalk is in position 1: The rain sensor is
activated from 4 km/h (2.5 mph).
– The wiper stalk is in position 2 or 3: The wind-
screen wipers remain off until the wiper stalk is
actuated.
For example, this prevents the wipers from wiping an
ice-covered windscreen as soon as operational
readiness is established.
Wiper behaviour when the speed is changed
bb The wiper stalk is in position 2 or 3.
– At speeds below 4 km/h (2.5 mph): The wipers
switch to rain sensor operation.
– The speed increases above 12 km/h (8 mph):
The wipers switch to the selected setting.
Application example: When braking at traffic lights,
the wipers switch to rain sensor operation. When the
vehicle accelerates, the wipers switch to the se-
lected setting from 12 km/h (8 mph).
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Windscreen Wiper
281
Information
The wipers stop when the bonnet is opened.
e To switch on the windscreen wipers again, move
the windscreen wiper stalk upwards/
downwards.

Related Topics

Popular Owner Manuals