HEADLIGHT BEAM ADJUSTMENT
Examples of positions for
adjusting
control A according to the load
A
Driver alone or with front passenger
0
All seats occupied
2
Switch A is used to adjust the height of
Driver with passengers and luggage
the headlight beams according to the
(or load) reaching the maximum
3
load.
permissible all-up weight
With the dipped beam headlights lit,
press or lift switch A as many times
as is necessary to select the required
Driver without passengers and luggage
position on the instrument panel. The
(or load) reaching the maximum
4
position selected is displayed on the
permissible all-up weight
instrument panel for approximately
30 seconds.
Note: depending on the vehicle, at
each engine start-up the selected po-
sition may be displayed on the instru-
The table below gives some examples. In all cases, adjust control A accord-
ment panel for approximately 30 sec-
ing to the vehicle load so that the road can be seen and other drivers are not
onds.
dazzled.
1.106
English 
