2017-2026 Seat Arona 4 Door Opening and closing -> Keyless Access system User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Opening and closing -> Keyless Access system for Your Seat Arona 4 Door First Generation (2017-2026)

Opening and closing  
NOTICE  
Changing the battery  
Keyless Access system  
Unfold the vehicle key shaft.  
If the battery is not changed correctly, the  
Locking and unlocking with the Key-  
less Access system  
Remove the cover from the back of the vehi-  
vehicle key may be damaged.  
cle key in the direction of the arrow ››› Fig. 47 ,  
Use of unsuitable batteries may damage  
›››  
.
the vehicle key. For this reason, always re-  
place the dead battery with another of the  
same voltage, size and specifications.  
Remove the battery from the compartment  
with a suitable fine object ››› Fig. 48.  
When fitting the battery, check that the po-  
Fit a new button battery into the compart-  
larity is correct.  
ment ›››  
.
Press the cover onto the key housing until it  
clicks into place.  
For the sake of the environment  
Please dispose of your used batteries cor-  
rectly and with respect for the environment.  
WARNING  
Swallowing a battery with a 20 mm diameter  
or any other button battery can cause seri-  
ous and even fatal injuries within a very short  
time.  
Fig. 49 Keyless Access: proximity zones.  
Synchronize the vehicle key  
If the button is pressed frequently outside of  
the vehicle range, it is possible that the vehicle  
can no longer be locked or unlocked using the  
key. In this case, the key must be resynchron-  
ised as described below:  
Keep the vehicle key and key fobs with bat-  
teries out of reach of children.  
If you suspect that someone may have  
swallowed a battery, seek immediate medi-  
cal attention.  
Unfold the vehicle key blade ››› page 64 .  
If necessary, remove the cover from the driver  
door handle ››› page 74.  
Press the button on the vehicle key. For this,  
Fig. 50 Door handle: sensor surfaces.  
it must remain with the vehicle.  
Open the vehicle within one minute using the  
››› Fig. 50  
key blade. The key has been synchronised.  
A
Unlocking sensor surface on the inside of  
If necessary, fit the cap.  
the door handle.  
66  
KeylessAccesssystem  
B
Locking sensing surface on the outside of  
the door handle.  
Unlocking the rear lid  
Comfort functions  
When the vehicle is locked, the rear lid auto-  
matically unlocks when it is opened if there is  
a vehicle key in its proximity zone. The rear lid  
locks again after closing.  
To close all the electric windows using the com-  
fort function, keep a finger on the locking sen-  
sor surface ››› Fig. 50  
handle for a few seconds until the windows  
have closed.  
Depending on the equipment, the vehicle may  
have the Keyless Access system. This is a key-  
less locking and starting system that can un-  
lock and lock the vehicle without actively using  
its key. For this, it is only necessary that there  
is a valid vehicle key in the detection area cor-  
responding to the attempted access to the ve-  
hicle.  
B
(arrow) of the door  
Temporarily deactivating the Keyless Ac-  
cess system  
How the doors open when touching the sensor  
surface on the door handle will depend on the  
settings that have been activated in the info-  
tainment system, using the button  
tings > Opening and closing.  
The “Keyless Access” system’s unlocking func-  
tion can be temporarily deactivated:  
> Set-  
Unlock the vehicle  
Move the gear lever to position P since other-  
wise the vehicle cannot be locked.  
Touch the sensor surface on the inside of the  
Troubleshooting  
A
Lock the vehicle using the button on the  
handle . All turn signals flash twice.  
vehicle key.  
If selective opening is fitted, touching the sen-  
sor's surface twice unlocks the entire vehicle.  
The Keyless Access system does not work  
Within 5 seconds, touch the sensor on the  
The operation of the sensor surfaces may be  
limited if they are soiled.  
B
outside of the door handle once ››› Fig. 50  
Do not grip the handle while doing so. This tem-  
porarily deactivates the Keyless Access system.  
.
If the vehicle is not unlocked for an extended  
period, the function is deactivated. The function  
will reactivate the next time that the vehicle is  
unlocked with the remote control.  
Clean the sensor surfaces.  
Check that it is deactivated by pulling on the  
All turn signals flash four times  
door handle after at least 10 seconds. It should  
not be possible to open the door.  
The key that was last used is still inside the vehi-  
cle.  
Lock the vehicle  
The next time, the vehicle can only be unlocked  
electronically with the vehicle key. After being  
unlocked the next time, the Keyless Access sys-  
tem will be activated again.  
Park the vehicle.  
Remove the key and lock the vehicle.  
B
Touch the sensor surface ››› Fig. 50  
on the  
outside of the door handle. All turn signals flash  
Automatic deactivation of the sensor surfa-  
ces  
once.  
To check that the vehicle is properly locked,  
the unlocking function is deactivated for a few  
seconds.  
The sensor surfaces are deactivated in the fol-  
lowing cases:  
67  

Related Topics

Popular Owner Manuals