2017-2026 Seat Arona 4 Door Seats and head restraints User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Seats and head restraints for Your Seat Arona 4 Door First Generation (2017-2026)

Seats and head restraints  
WARNING  
Rear seats  
Seats and head re-  
straints  
Serious injuries can be caused if the rear  
seat backrest is lowered or lifted without due  
care and attention.  
Folding down and raising the rear  
seat backrest  
Front seats  
Never lower or lift the rear seat backrest  
while driving.  
Manual adjustment of the front seats  
Do no trap or damage the seat belt when  
raising the rear seat backrest.  
When lowering or lifting the rear seat back-  
rest, keep your hands, fingers, feet and other  
body parts out of its path.  
For the rear seat belts to oꢀer the nec-  
essary protection all the parts of the rear  
backrest must be properly engaged. This  
is particularly important in the case of the  
centre rear seat. If someone is seated in a  
seat whose backrest is not properly engaged  
they will fly forward, along with the backrest,  
during an accident or a sudden driving or  
braking manoeuvre.  
Fig. 64 Rear seat: folding down the backrest.  
The rear seat backrest is split and each part  
be lowered separately to extend the luggage  
compartment.  
Fig. 63 Front seats: manual seat adjustment.  
2
A red mark on button  
warns that the rear  
Folding the backrest forwards  
backrest is not engaged. Always check that  
the red marking is not visible when the back-  
rest is in the upright position.  
1
Pull the lever to move the seat forwards or  
backwards. The seat must engage when  
the lever is released!  
Fully lower the rear headrests ››› page 83.  
1
Press the unlock button ››› Fig. 64  
for-  
When the rear seat backrest is lowered or  
wards and at the same time fold the backrest  
2
Move the lever up or down to adjust the  
seat height; several times if necessary.  
is not properly engaged nobody else can  
travel in the corresponding seats (not even  
a child).  
down. The rear seat backrest is not engaged  
when the red marking of the button  
2
is visible.  
3
Without placing force on the seat backrest,  
turn the wheel to adjust the backrest.  
Converting the table to a seat  
Raise and lock in the back rest. The red mark-  
2
ing on button  
should no longer be visible  
when the backrest is properly secured.  
82  
Headrest
Adjusting the head restraint for short people  
NOTICE  
NOTICE  
Lower the head restraint completely, even if  
your head is below its upper edge. In the low-  
est position, there may be a small distance be-  
tween the head restraint and the backrest.  
Serious damage can be caused to the vehi-  
cle and other objects if the rear seat back-  
rest is lowered or lifted without due care and  
attention.  
When assembling and disassembling the  
head restraints, do not let them meet the top  
lining of the vehicle, the back rest of the front  
seat or other parts of the vehicles. If not, this  
could damage the vehicle.  
Before lowering the rear seat backrest, al-  
Adjusting the head restraint for tall people  
ways adjust the front seats so that neither  
the head restraints nor the cushions of the  
rear backrest can hit them.  
Push the head restraint up as far as it will go.  
Adjusting the headrests  
WARNING  
If travelling with the head restraints removed  
or improperly adjusted, the risk of severe or  
fatal injuries in the event of accidents and  
sudden braking or manoeuvres increases.  
Headrest  
Introduction  
The possibilities for the adjustment and disas-  
sembly of the headrests are described below.  
Always make sure that the seats are correctly  
adjusted ››› page 37.  
Always travel with the head restraint cor-  
rectly installed and adjusted.  
To decrease the risk of cervical injuries in  
the event of an accident, adjust the head  
restraint correctly based on your height, al-  
ways making sure that its upper edge is at  
the same height as the top of the head, but  
never below eye level. Keep the back of your  
head always as close to the head restraint as  
possible and centred.  
All seats are equipped with a head restraint.  
The central rear headrest is only intended for  
the central seat of the rear bench. Therefore,  
do not install it on any other seat.  
Fig. 65 Front seat: adjusting the head  
restraint.  
Correct adjustment of head restraint  
Never adjust the head restraint while the  
Adjust the headrest so that its upper edge is  
at the same level as the top of your head and  
under no circumstances below eye level. Keep  
the back of your head always as close to the  
head restraint as possible.  
vehicle is in motion.  
Under no circumstances should the rear  
passengers travel while the head restraints  
are in the non-use position.  
83  
Seats and head restraints  
Removing the front head restraints  
Removing and fitting the headrests  
Lower the head restraint if necessary.  
To unlock it, look for the rabbet on the bottom  
of the backrest and press in the direction of the  
1
arrow ››› Fig. 67  
.
Remove the head restraint in the direction of  
2
the arrow  
.
Fitting the front head restraints  
Place the head restraint in the correct posi-  
Fig. 66 Rear headrest: adjusting the headrest.  
tion on the guides of the corresponding back-  
rest and insert it.  
Fig. 67 Front head restraint: removal.  
Adjusting the height of the head restraints  
Press the head restraint downwards until the  
Grab the sides of the head restraints with  
bars lock.  
both hands and push upwards to the desired  
Adjust the head restraint according to the in-  
position. To lower it, repeat the same action,  
structions on the correct position of the seat.  
1
pressing the button on the side  
››› Fig. 65 ,  
››› Fig. 66.  
Removing the rear head restraints  
The headrest must lock correctly in one posi-  
tion.  
To remove the head restraint, the correspond-  
ing backrest must be partially folded forward.  
Unlock the backrest ››› page 82.  
Move the head restraint upwards until it ar-  
Fig. 68 Rear head restraint: removal.  
rives to the top.  
1
Press button ››› Fig. 68 , while simultane-  
2
ously pressing on the safety hole  
with a flat  
screwdriver a maximum of 5 mm wide, and re-  
move the headrest.  
Move the backrest until it engages properly  
››› in Folding down and raising the rear  
seat backrest on page 82.  
84  
Headrest
Fitting the rear head restraints  
To mount the external head restraints, the cor-  
responding backrest must be partially folded  
forward.  
Unlock the backrest ››› page 82.  
Insert the head restraint bars into the guides  
until they perceptibly engage. It should not be  
possible to remove the head restraint from the  
backrest.  
Move the backrest until it engages properly  
››› in Folding down and raising the rear  
seat backrest on page 82.  
WARNING  
Remove the rear headrests only when it is  
necessary to fit a child seat. After removing a  
child seat, refit the headrest immediately.  
85  

Related Topics

Popular Owner Manuals