2016-2020 Seat Ateca SUV Driving -> Start and driving User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving -> Start and driving for Your Seat Ateca SUV First Generation (2016-2020)

Lights and visibility  
Home” and/or “Leaving Home” delay time  
may also be set (default: 30 sec).  
Fog lights  
Fog lights with cornering light func-  
tion*  
Vehicle with halogen headlights  
The cornering light function is an additional  
function to the dipped beam headlights to  
improve lighting of the side of the road when  
taking a sharp turn at low speed.  
In the “Coming Home” function, the daytime  
running lights (DRL), the rear side lights and  
the licence plate lights are turned on.  
The cornering light function works when the  
dipped beam headlights are already on and  
it is enabled when driving at speeds below  
approximately 40 km/h (25 mph).  
Vehicle with full-LED headlights  
In the “Coming Home” function, the dipped  
beams, the daytime running lights (DRL), the  
rear side lights, the number plate lights and  
the courtesy lights in the rear view mirror  
(Welcome Light) switch on.  
Fig. 152 Instrument console: light panel.  
Forward gear  
If the steering wheel is turned to the right or  
The warning lamps or also show, on the  
light switch or instrument panel, when the fog  
lights are on.  
the right-hand turn signal switched on, the  
right-hand fog lamp is gradually switched on.  
Automatic* activation of “Coming Home”  
For vehicles with a light and rain sensor (rota-  
ry light switch in position ).  
If the steering wheel is turned to the left or  
Turn on the fog lights* ; pull the light  
the left-hand turn signal switched on, the left-  
hand fog lamp is gradually switched on.  
1
switch to the first point››› Fig. 152 , from  
Switch off the engine and remove the key  
positions , or .  
After the turn, the cornering light function is  
from the ignition with the rotary light switch in  
position ›››  
Turn on the rear fog light : completely pull  
gradually switched off.  
page 33.  
2
the light switch  
.  
from position , or  
The automatic “Coming Home” function is  
Reverse gear  
only active when the light sensor detects  
darkness.  
To switch off the fog lights, press the light  
When engaging the reverse gear, both fog  
switch or turn it to position .  
lights turn on.  
When the car door is opened, the “Coming  
Home” lighting comes on.  
Note  
The rear fog light can dazzle drivers behind  
you. You should use the rear fog light only  
when visibility is very poor.  
“Coming home” function  
Manual “Coming Home” activation  
For vehicles with a light and rain sensor (rota-  
ry light switch without position ).  
This function may be connected/disconnec-  
ted through the radio menu. The “Coming  
»
153  
Operation  
Switch off the engine and remove the key  
Home” function switch-off delay may also be  
set (default: 30 sec).  
Welcome light*  
3 Valid for vehicles with a light and rain sensor  
and Full LED headlights.  
from the ignition.  
Activate the headlight flashers for approxi-  
Vehicle with halogen headlights  
mately 1 second.  
The Welcome light is a light located on the  
exterior mirrors facing the ground which is  
switched on or off if the lights control is in the  
 position and the “Coming Home” /  
“Leaving Home” function is switched on or off.  
In the “Leaving Home” function, the daytime  
running lights (DRL), the rear side lights and  
the licence plate lights are switched on.  
Activated for any position of the rotary light  
switch.  
When the car door is opened, the “Coming  
Home” lighting comes on. The headlights are  
turned off 60 seconds after the vehicle door  
is opened.  
Vehicle with full-LED headlights  
In the “Leaving Home” function, the dipped  
beams, the daytime running lights (DRL), the  
rear side lights, the number plate lights and  
the courtesy lights in the rear view mirror  
(“Welcome Light”) switch on.  
Hazard warning lights  
Deactivation  
If no door has been closed, they go out au-  
tomatically after 60 seconds.  
After the last door has been closed, the  
Activation  
headlights will be switched off after the  
“Coming Home” delay (as established in the  
radio menu) has elapsed.  
When the vehicle is unlocked using the re-  
mote control.  
The “Leaving Home” function is only activa-  
On turning the light switch to position   
page 33.  
ted when the rotary light switch is in position  
 and the light sensor detects darkness.  
›››  
When the ignition is switched on (when  
starting the engine).  
Fig. 153 Dashboard: switch for hazard warning  
Deactivation  
lights.  
When the “Leaving Home” delay period  
ends (default: 30 sec).  
Read the additional information carefully  
Function “Leaving Home”  
When the vehicle is locked using the remote  
›››  
page 34  
control.  
The “Leaving Home” function is only available  
for vehicles with a light and rain sensor (rota-  
ry light switch in position ).  
The hazard warning lights are used to draw  
the attention of other road users to your vehi-  
cle in emergencies.  
When the light control is switched into a po-  
sition other than .  
This function may be connected/disconnec-  
ted through the radio menu. The “Leaving  
With the ignition is switched on.  
If your vehicle breaks down:  
154  

Related Topics

Popular Owner Manuals