2009-2017 Seat Ibiza SUV Driver assistance systems -> Cruise speed* (cruise control system - CCS) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driver assistance systems -> Cruise speed* (cruise control system - CCS) for Your Seat Ibiza SUV Fourth Generation (2009-2017)

Operation  
front of the vehicle. At the rear, these indi-  
cate obstacles located between 30 cm and  
160 cm from the vehicle’s rear. As the vehicle  
approaches an obstacle, the segments are  
displayed closer to the vehicle. The red seg-  
ments represent obstacles located at less  
than 30 cm from the bumper. At this point  
the driver should not move forward/reverse  
any further.  
Switching on the cruise control system  
●
Always switch the cruise control system off  
after using it in order to avoid involuntary  
use.  
A
–
Move the control ››› Fig. 147  
to ON.  
to the left  
●
It is dangerous to use a set speed which is  
too high for the current road, traffic or weath-  
er conditions. Risk of accident.  
Switching off the cruise control system  
A
–
Move the control  
to the right to OFF or  
turn the ignition off when the vehicle is sta-  
tionary.  
Note  
The cruise control cannot maintain a constant  
speed when descending downhill. It will in-  
crease due to its own weight. Use the foot  
brake to slow the vehicle.  
When the cruise control is on and a speed is  
programmed, the indicator on the instru-  
ment panel* is lit.  
Cruise speed* (cruise control  
system - CCS)  
If the cruise control system is switched off,  
the symbol is switched off. The system will  
also be switched off fully when the 1st gear  
is engaged.*  
Switching the cruise control system  
on and off  
Description  
The CCS is able to maintain the set speed in  
the range from approx. 30 km/h (19 mph) to  
180 km/h (112 mph).  
Setting speed*  
Once the speed setting has been saved, you  
may take your foot off the accelerator.  
WARNING  
It could be dangerous to use the cruise con-  
trol system if it is not possible to drive at con-  
stant speed.  
●
Do not use the cruise control system when  
Fig. 147 Turn signal and main beam head-  
light lever: switch and rocker switch for the  
cruise control.  
driving in dense traffic, on roads with lots of  
bends or on roads with poor conditions (with  
ice, slippery surfaces, loose grit or gravel), as  
this could cause an accident.  
Fig. 148 Turn signal and main beam head-  
light lever: switch and rocker switch for the  
cruise control.  
150  
Driver assistance systems  
●
–
Press the lower part SET of the rocker  
than 10 km/h (6 mph) for longer than 5 mi-  
nutes. The speed will have to be stored  
again.  
if the vehicle is accelerated to over  
180 km/h (112 mph),  
B
switch ››› Fig. 148  
once briefly when you  
have reached the speed you wish to set.  
●
A
when the lever  
is moved in the direction  
of OFF without fully being engaged.  
Cruise control is switched off if you reduce  
speed by depressing the brake pedal. Reacti-  
vate the control by pressing once on the up-  
per part of the rocker switch RES+ ››› Fig. 148  
When you release the rocker switch, the cur-  
rent speed is set and held constant.  
To resume cruise control, release the brake or  
clutch pedal or reduce the vehicle speed to  
less than 180 km/h (112 mph) and press  
once on the upper part of the rocker switch  
B
B
.
Adjusting set speed*  
RES ››› Fig. 149  
.
The speed can be altered without touching  
the accelerator or the brake.  
Switching off cruise control  
temporarily*  
Completely switching off the system  
Vehicles with a manual gearbox  
Setting a higher speed  
–
Press the upper part RES of the rocker  
B
switch ››› Fig. 148  
to increase the speed.  
The system is completely turned off by mov-  
The vehicle will continue to accelerate as  
long as you keep the rocker switch pressed.  
When you release the switch, the new  
speed is stored.  
A
ing the control  
››› Fig. 149 all the way to  
the right hand side (OFF engaged), or when  
the vehicle is stationary, switching off the ig-  
nition.  
Setting a lower speed  
Vehicles with an automatic gearbox  
–
Press the lower part of the rocker switch  
To completely disengage the system, the se-  
lector lever must be placed in one of the fol-  
lowing positions: P, N, R or 1 or with the vehi-  
cle stopped and the ignition turned off.  
B
SET– ››› Fig. 148  
to reduce the speed.  
Fig. 149 Turn signal and main beam head-  
light lever: switch and rocker switch for the  
cruise control.  
The vehicle will automatically reduce its  
speed for as long as you keep the switch  
pressed. When you release the switch, the  
new speed is stored.  
The cruise control system will be switched off  
in the following situations:  
When you increase speed with the accelera-  
tor and then release the pedal, the system  
will automatically restore the set speed. This  
will not be the case, however, if the vehicle  
speed exceeds the stored speed by more  
●
●
if the brake pedal is depressed,  
if the clutch pedal is depressed,  
151  

Related Topics

Popular Owner Manuals