Get Seats and head restraints -> Seat functions Guide for Seat Ibiza SUV Fourth Generation (2009-2017)

Operation

WARNING

CAUTION

Seat functions

●

Never drive if the head restraints have been

removed. Risk of injury.

To avoid damaging the heating elements,

please do not kneel on the seat or apply

sharp pressure at a single point to the seat

cushion and backrest.

Heated seats* 

●

Never drive if the head restraints are in an

unsuitable position, there is a risk of serious

injury.

●

Note

After refitting the head restraint, you must

always adjust it properly for height to achieve

optimal protection.

The seats are only heated electrically when

the engine is running.

●

Please observe the safety warnings in ›››

in Correct adjustment of front head restraints

on page 33.

Note

Fig. 100 Front seat heating switch.

●

To fit and remove the rear head restraints,

gently tilt the seat backrest forwards.

The front seat cushions and backrests can be

heated electrically.

●

When fitting the head restraints again, in-

sert the tubes as far as possible into the

guides without pressing the button.

–

Press the corresponding switch ››› Fig. 100

to switch on the seat heating.

–

Press once to connect the heating at maxi-

mum force. The two LEDs illuminate

››› Fig. 100. After 15 minutes of high inten-

sity, the upper LED goes out, the system is

deactivated for 2 minutes and is then reac-

tivated at low intensity (the lower LED re-

mains on permanently).

–

Press the switch again to set the heating to

minimum force. (The lower LED lights up).

To disconnect the heating, press the switch

again.

102

Seats and head restraints

–

Lift the cushion

forwards in the direc-

Folding down rear seats

WARNING

tion of the arrow.

●

Please be careful when folding back the

Pull the release button ››› Fig. 102 in the di-

rection of the arrow and fold the backrest

forwards.

backrest! Injuries can be caused if the seat

height is adjusted without due care and at-

tention.

●

Do no trap or damage seat belts when rais-

ing the backrest.

–

Insert the head restraints in the spaces on

the rear of the seat cushion which are visi-

ble when the seat cushion is lowered.

●

After raising the backrest, check it has en-

gaged properly in position. Do this by pulling

on the central seat belt or directly on the

backrest and check that the position lever is

in the neutral position.

Folding seat forward

–

Remove the head restraints from the

spaces in the seat cushion.

Fig. 101 Folding up the rear seat cushion.

●

The three point automatic seat belt only

works correctly when the backrest of the cen-

tral seat is correctly engaged.

–

Lift the backrest, and before securing it, re-

place the head restraints in the seat cush-

ion, and then click the seat correctly onto

the locking rails.

–

Once the backrest is locked, pull on the

central seat belt or directly on the backrest

to check that the backrest has properly en-

gaged in position.

–

Check that the position lever is in neutral

position.

Fig. 102 Button for unlocking the rear back-

rest.

Lower the cushion and push it backwards

below the seat belt buckles.

Folding seat down

Press the front part of the cushion down-

wards.

–

Remove the head restraint ››› page 101.

–

Pull the front edge of the seat cushion

On split rear seats*, the backrest and cush-

ion can be lowered and raised respectively in

two sections.

››› Fig. 101

upwards in the direction of

the arrow.

103

Seats and head restraints -> Seat functions for Your Seat Ibiza SUV Fourth Generation (2009-2017)

Related Topics

Popular Owner Manuals

Latest Owner Manuals