2021-2026 Seat Ibiza SUV Cockpit -> Digital display in the instrument panel User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Cockpit -> Digital display in the instrument panel for Your Seat Ibiza SUV Fifth Generation (2018-2026)

54  
Cockpit  
When the needle reaches the red area of the reserve zone ⇒ fig. 34, the  
warning lamp will light and an acoustic signal will sound reminding the driver  
to refuel. At this point there are still about 7 litres of fuel in the tank.  
WARNING  
When working in the engine compartment, always bear in mind the safety  
warnings ⇒ page 169.  
Speedometer  
Caution  
Accessories in front of the air inlet reduce the cooling effect of the coolant. At  
high outside temperatures and high engine loads, there is a risk of the  
engine overheating.  
The speedometer is equipped with a digital odometer and a trip counter, in  
addition to a service intervals display.  
During the running-in period, the instructions shown on ⇒ page 143 should  
be followed  
Fuel gauge and reserve indicator  
Digital display in the instrument panel  
Digital clock*  
5
–
–
Turn the setting knob ⇒ page 52, fig. 32 A anti-clockwise to  
the stop to set the hour. If the knob is turned briefly anti-clock-  
wise the clock will advance one hour further.  
Turn the setting knob clockwise to the limit stop to set the  
minutes. If the knob is turned briefly clockwise the clock will  
advance one minute further.  
Fig. 34 Fuel gauge  
Details of the instrument panel: Fuel gauge  
The fuel tank has a capacity of approx. 45 litres.  
Cockpit  
55  
Ambient temperature display*  
Display with multi-function display (MFD)*  
The outside temperature is displayed when the ignition is  
switched on.  
The multi-function display (MFD) shows you diverse journey  
and consumption data.  
At temperatures between +6° C to -7°C , in addition to the outside tempera-  
ture, an ice crystal is displayed and if travel speed is over 10 km/h an acoustic  
buzzer is heard.  
The illumination of the crystal symbol aims to warn the driver of the risk of  
ice, so that he/she proceeds with due care.  
When the vehicle is stationary or travelling at very low speeds, the tempera-  
ture displayed may be slightly higher than the actual outside temperature as  
a result of heat coming from the engine.  
Fig. 35 Windscreen wiper  
and washer lever: Button  
A and rocker switch B  
Fig. 36 Digital screen on  
the instrument panel:  
outside temperature  
display  
Safety First  
Operating instructions  
Tips and Maintenance  
Technical Data  
56  
Cockpit  
The multi-function display is equipped with two automatic memo-  
ries: 1 - Trip memory and 2 - Total journey memory. The selected  
memory will be shown in the upper right-hand corner of the display.  
Displays in the multi-function display (MFD)*  
Selecting memory  
–
With the ignition switched on, briefly press the button  
A
⇒ page 55, fig. 35 A on the windscreen wiper lever to move  
between the two memories.  
Resetting the memory  
–
–
Select the memory that you would like to reset.  
A
Press and hold button A on the windscreen wiper lever for at  
least 2 seconds.  
Fig. 37 Windscreen wiper  
and washer lever: Button  
A and rocker switch B  
The trip memory 1collects the travel and consumption data from the moment  
the ignition is switched on until it is switched off. If the journey is continued  
within two hours of switching off the ignition, the new values will be added to  
the existing trip recorder memory. The memory will automatically be deleted  
if the journey is interrupted for more than two hours.  
The total journey memory 2 collects the journey data for any number of indi-  
vidual journeys (even if the ignition is switched off for longer than two hours)  
up to a total of 99 hours and 59 minutes travel time, 9999 miles distance trav-  
elled and 999 litres of fuel consumed. The memory will automatically be  
deleted if one of the named values is reached.  
Fig. 38 Digital screen on  
the instrument panel:  
outside temperature  
display  
You can switch between the following displays in the multi-function display  
B
(MFD) by operating the rocker switch ⇒ fig. 37 A on the windscreen wiper  
lever.  
Cockpit  
57  
Memory displays  
Ø litre/100km - Average fuel consumption  
•
•
•
•
•
•
•
Time  
The average fuel consumption will be shown ⇒ page 56, fig. 38 after a  
distance of approximately 100 metres has been travelled. Dashes will appear  
in the display until that time. The display will be updated every 5 seconds  
whilst the vehicle is in motion. The amount of fuel used will not be shown.  
Journey duration  
Average speed  
Distance  
ltr/100km or ltr/hr - Current fuel consumption  
Distance to empty (the distance you can travel with the remaining fuel)  
Average fuel consumption  
The display will show the current fuel consumption in litre/km whilst the  
vehicle is in motion or in litre/hour when the vehicle is in a stationary position  
with the engine running.  
Current fuel consumption  
Time  
Using this display you can see how your driving style affects fuel consump-  
tion ⇒ page 151.  
The time is also displayed when the ignition is switched off. The clock can be  
set with the right-hand rotating button below the rev counter “digital clock”.  
Ambient temperature display  
min - Journey duration  
The measurement margin extends from -45° C to +58° C. At temperatures  
lower than +4° C, an “ice crystal symbol” is displayed and a “warning”  
sounds if the vehicle is moving at more than 20 km/h (ice warning). This  
symbol will flash for about 10 seconds and remains lit until the exterior  
temperature rises above +4° C or 6° C if it was already lit.  
The display shows the amount of time which has elapsed since the ignition  
was switched on.  
The maximum display value in both memories is 99 hours and 59 minutes.  
The memory will automatically be deleted once this value has been reached.  
Ø mph - Average speed  
WARNING  
The average speed will be shown after a distance of approximately 100  
metres has been travelled. Dashes will appear in the display until that time.  
The display will be updated every 5 seconds whilst the vehicle is in motion.  
There could be black ice on the road surface even if the “snowflake symbol”  
is not shown. You should, for this reason, not rely exclusively on this  
display - Risk of accident!  
Miles - Distance travelled  
The display shows the distance travelled since the ignition was switched on.  
Note  
The maximum display value in both memories is 9999 miles. The memory will  
automatically be deleted once this value has been reached.  
When the vehicle is stationary or travelling at very low speeds, the tempera-  
ture displayed may be slightly higher than the actual ambient temperature as  
a result of the heat radiated from the engine.  
Miles - Fuel range  
The fuel range is calculated using the figures for tank content and current fuel  
consumption. It shows how far the vehicle can travel using the same condi-  
tions as a reference.  
Safety First  
Operating instructions  
Tips and Maintenance  
Technical Data  
58  
Cockpit  
Service interval display  
Display field for selector lever position*  
When it is time for a service, the lower counter (trip counter) of the speedom-  
eter displays the symbol of a spanner, followed by one of the following  
messages:  
The position of the automatic gearbox selector lever is shown on the display  
⇒ page 130.  
OIL- Changing the engine oil  
INSP- Maintenance service  
Mileage display or Service Interval Display  
The maintenance message switches off 3 minutes after the engine is started.  
The trip counter can also be reset, by pressing the reset button for more than  
2)  
0.5 seconds  
The Service Centre who carry out the maintenance service will reset the main-  
tenance interval display on completion of the service.  
We recommend that the repair and maintenance work only be carried out at  
Authorised Service Centres.  
The service indicator can also be reset by pressing the trip counter button.  
Proceed as follows:  
-
A Switch off ignition.  
-
A Keep “Reset” button on distance counter pressed.  
-
A Connect ignition with the “Reset” button pressed. The fixed mode  
display appears.  
Fig. 39 Service interval  
display  
-
A After a minimum of 10 sec, release the reset button.  
Distance display  
The upper counter in the display registers the total distance covered by the  
vehicle.  
Caution  
We recommend that the resetting of the service interval indicator be carried  
out in an Authorised Service Centre to avoid possible faults in the vehicle.  
The lower counter registers the short journeys. The last digit indicates steps  
of 100 metres. The trip recorder counter may be reset by the reset button  
6
⇒ page 52, fig. 32 A.  
2)  
With “Ignition OFF” the maintenance display remains visible.  
Cockpit  
59  
Note  
•
Only the desired service message should be reset in each case. By  
pressing the reset button it is possible to change from one message to  
another.  
•
Do not reset the display between two service intervals, otherwise the  
dispaly will be incorrect.  
•
The values are stored even when the battery is disconnected.  
Safety First  
Operating instructions  
Tips and Maintenance  
Technical Data  

Related Topics

Cockpit
Overview Instruments Warning lamps

Popular Owner Manuals

Audi
Audi
BMW
BMW
Citroen
Citroen
Ford
Ford
Honda
Honda
Peugeot
Peugeot