2020-2024 Skoda Enyaq 4 Door 12 volt vehicle battery and fuses -> Using the jump-starting cable User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

12 volt vehicle battery and fuses -> Using the jump-starting cable for Your Skoda Enyaq 4 Door First Generation (2020-2024)

12 volt vehicle battery and fuses › Using the jump-starting cable 215  
The state of charge of the 12 volt vehicle battery is insuffi-  
cient  
Using the jump-starting cable  
Usage  
illuminates together with  
A message in the display of the instrument cluster re-  
garding low charge or discharged 12 volt vehicle battery.  
With the help of jump start cables, a vehicle with a discharged or  
defective 12-volt vehicle battery can be put into operation using  
the 12-volt vehicle battery of another vehicle.  
Travel a distance of several kilometres to charge the 12 volt  
›
vehicle battery.  
Or:  
What you should be mindful of  
Charge the vehicle using a charger.  
›
WARNING  
Or:  
Risk of explosion and chemical burns!  
Charge the 12 volt vehicle battery with a charger.  
›
Do not operate the vehicle with the 12 volt vehicle battery of  
another vehicle under the following conditions:  
The discharged 12 volt vehicle battery is frozen. A dis-  
▶
Worn 12 volt vehicle battery  
▶
illuminates together with  
A message in the display of the instrument cluster re-  
garding exchange of the 12 volt vehicle battery.  
charged 12 volt vehicle battery may already freeze at tem-  
peratures just below 0 °C.  
The acid level of the 12-volt vehicle battery is too  
▶
Seek the help of a specialist garage.  
›
low » page 213.  
Use jump leads with a sufficient cross section and insulated ter-  
minal clamps.  
Disconnecting, connecting and replacing  
The rated voltage of both batteries must be 12V. The capacity (in  
Ah) of the 12 volt charging vehicle battery must not be signifi-  
cantly lower than the capacity of the discharged 12 volt vehicle  
battery.  
The connection cables of the 12-volt vehicle battery are not ac-  
cessible. The 12 volt vehicle battery may only be disconnected  
and connected by a specialist company.  
Changing  
The new 12 volt vehicle battery must have the same parameters  
as the original battery. Have the replacement carried out by a  
specialist garage.  
216 12 volt vehicle battery and fuses › Using the jump-starting cable  
Use another vehicle's 12 volt vehicle battery to operate  
the vehicle  
current-supplying 12 volt vehicle battery  
1
-pole of the discharged 12-volt vehicle battery  
-pole of the current-supplying 12 volt vehicle battery  
WARNING  
Risk of injury! Danger of damage to vehicle!  
2
3
-pole of the current-supplying 12 volt vehicle battery (or  
earth point)  
Lay the jump start cables so that they cannot become caught  
by rotating parts in the engine compartment.  
▶
4
Earth point of the vehicle with discharged 12 volt vehicle  
battery  
NOTICE  
Short circuit!  
The non-insulated parts of the terminal clamps must not touch  
each other.  
▶
The cable connected to the positive pole of the 12 volt vehicle  
battery must not come into contact with electrically conduc-  
tive vehicle parts.  
▶
The vehicles must not touch each other.  
▶
Connect the jump start cable  
Switch off the ignition.  
Connect the terminal clamps of the jump start cables in the or-  
der shown in the legend.  
›
›
Under the front flap: Ground point / -pole of the 12-volt vehicle bat-  
tery (under the cover cap)  
Start the vehicle  
Start the engine of the current-giving vehicle and let it idle (ap-  
plies to vehicles with combustion engine)  
›
Or:  
Switch on the electric drive of the vehicle supplying power  
(applies to vehicles with an electric motor).  
›
Switch on the ignition of the vehicle with the discharged 12  
volt vehicle battery.  
›
discharged 12 volt vehicle battery  

Related Topics

Popular Owner Manuals