44 Doors, windows and boot lid › Sliding/tilting roof
If the obstacle is not removed, the force limit is disabled when
you try to close again by moving and holding a finger in the
closed direction (if the time span between the closing attempts
is less than 5 s). The sliding/tilting roof will then close with full
force.
Troubleshooting
The window regulator has stopped working after repeated
opening and closing
The window regulator mechanism could have overheated.
Allow the window regulator mechanism to cool down.
›
CAUTION
Risk of injury!
The window operation does not work after disconnecting the
12 volt vehicle battery
Close the sliding/tilting roof carefully, even though there is a
force limiter.
▶
Enable window operation » page 44.
›
NOTICE
During winter time, if necessary, remove any ice and snow
around the area of the sliding/tilting roof before opening.
Always close the sliding/tilting roof before disconnecting the
12 volt vehicle battery.
▶
▶
Activation after disconnecting the 12-volt vehicle
battery
Activate automatic window operation
Turn on the ignition.
Pull the corresponding button upwards and the window
closes.
›
›
Operating conditions
Release the button.
Pull up the respective button and hold for 1 second.
›
›
✓ Ignition is switched on.
✓ The outside temperature is higher than -20 °C (applicable for
the opening of the sliding/tilting roof).
Sliding/tilting roof
What you should be mindful of
To reduce the risk of pinch injuries when closing the tilt/slide
sunroof, the vehicle has a force limiter.
If the operation is activated in the closed direction and the clos-
ing process is hindered by an obstacle, the movement of the
glass pane is stopped and the pane moves back a few centime-
tres.
English 
