Space under the front flap › Coolant 211
Open the bonnet.
Checking the level
›
›
Remove the bonnet stay from the
holder and insert the end of the
stay into the opening in the bon-
net.
The fill level must be within the
marked range.
If the fill level is below the mark
›
, top up the coolant.
Closing
Lift the bonnet.
Unhook the bonnet stay and insert it into the holder.
Fold the bonnet down and release it with a distance of 30 cm
remaining.
›
›
›
NOTICE
Risk of damage to the space under the front flap!
Do not top up the coolant above the marked area. The coolant
could be forced out of the cooling system when heated.
▶
Check that the bonnet is closed.
›
NOTICE
There must be a small quantity of coolant in the tank.
NOTICE
Do not add coolant when the tank is empty.
▶
Do not press down on an unclosed bonnet.
▶
▶
Stop driving! Seek the help of a specialist garage.
▶
Open and close the flap again.
Refilling
CAUTION
Risk of scalding!
Coolant
Checking the fill level and topping up
The cooling system is pressurised.
Do not open the coolant expansion tank cap immediately after
the ignition is stopped and turned off.
▶
Test conditions
✓ The vehicle is on a horizontal surface
✓ Ignition off
Place a wipe on the lid of the tank and carefully unscrew the
lid.
›
Refill with coolant of the correct specification.
Screw on the cap until it clicks into place.
›
›