WARNING
Headlights
■
Always read and observe the warnings before completing any work in the
engine compartment » page 138.
■
Accidents can be caused if the road in front of the vehicle is not suffi-
ciently illuminated and the vehicle cannot or can only be seen with difficul-
ty by other road users.
■
Bulbs H7 and H4 are pressurised and may burst when changed - there is a
risk of injury. We therefore recommended wearing gloves and safety
glasses when changing a bulb.
■
Switch off the respective vehicle light when changing the bulb.
CAUTION
Fig. 154 Bulb arrangement: Halogen headlights/halogen projector head-
lights
■
Do not take hold of the glass bulb with naked fingers (even the smallest
amount of dirt reduces the working life of the light bulb). Use a clean cloth,
napkin, or similar.
Read and observe and on page 171 first.
■
When removing and installing the number plate light and tail light make sure
that the paintwork of the vehicle and the tail light are not damaged.
Bulb arrangement in the Halogen headlamp
A - low beam, main beam and side lights
Note
■
B - front turn signal light
This Owner's Manual only describes the replacement of bulbs where it is pos-
sible to replace the bulbs on your own without any complications arising. Other
light bulbs should be changed by your specialist garage.
We recommend that you always carry a box of replacement bulbs in the vehi-
Bulb arrangement in the Halogen projector headlights
1
- low beam / low and main beam
■
2 - Parking light / parking and main beam lights
3 - turn signal lights
cle. Replacement bulbs can be purchased from ŠKODAOriginal Accessories.
We recommend having the headlight settings checked by a specialist garage
after replacing a bulb in the main beam, low beam or fog lights.
■
■
Visit a specialist garage if an LED is faulty.
Changing the low beam and high beam bulb (halogen headlights)
Fig. 155
Removing bulbs for low and
main beam
Read and observe and on page 171 first.
Remove the rubber cover A » Fig. 154 on page 171.
›
171
Fuses and light bulbs