Keys, locks and alarm system for Your Skoda Fabia 4 Door Third Generation (2014-2020)

22 Keys, locks and alarm system › Key  
Fold out the key bit.  
Keys, locks and alarm system  
Loosen the battery  
cover with your thumb  
or with a flat-blade  
screwdriver at the  
marked positions.  
Open the battery cov-  
er.  
Key  
Key overview  
Lock the vehicle  
Operate the luggage  
compartment lid  
Unlock vehicle  
Battery status indi-  
cator light  
Safety button for  
opening and closing  
the key bit  
A
B
Take out the battery.  
Press any key on the  
radio key, and the key  
resets.  
Insert the new battery.  
Fit the battery cover  
and press until it clicks  
into place.  
NOTICE  
Protect the key from moisture and strong vibra-  
tions.  
Keep the grooves in the key bit clean.  
The effective range of the key signal is approxi-  
mately 30 m. The effective area can be reduced, e.g.  
due to signal interference from other transmitters.  
Central locking  
Functionality  
Troubleshooting  
Central locking system  
The system unlocks and locks all doors, the fuel filler  
flap and the luggage compartment flap at the same  
time.  
The battery in the key is almost empty  
After pressing a button on the key, the warning  
light does not flash.  
Unlock indicator: the flashing lights flash twice.  
Lock indicator: the flashing lights flash once.  
Or:  
A message stating it is necessary to change the  
The warning light in the driver's door will flash for  
about 2 seconds in quick succession after the vehicle  
is locked, then it will start flashing regularly at longer  
intervals.  
battery will be displayed.  
Replace the battery » page 22.  
The vehicle cannot be unlocked or locked with the  
remote control  
There may be the following reasons.  
If none of the doors or the boot lid is opened  
within 45 seconds of unlocking, the vehicle automat-  
ically locks again.  
The battery in the key is empty.  
Replace the battery » page 22.  
The key is not synchronized.  
SAFE-Function  
Depending on the equipment, the SAFEFunction can  
be incorporated into the central locking system.  
Synchronize the key as follows.  
The SAFEFunction prevents the doors from opening  
from the inside after locking the vehicle.  
Press one of the buttons on the key.  
Unlock the door within 1 minute with the key via  
the locking cylinder » page 23.  
The SAFEFunction turns on when the vehicle is  
locked from the outside.  
If necessary, the key must be synchronized if one  
of the buttons on the key has been repeatedly press-  
ed outside of the effective range of the remote con-  
trol.  
After the ignition is switched off, a message regard-  
ing the SAFEFunction is displayed on the instrument  
cluster display.  
DANGER  
Risk of death!  
Changing the key battery  
When the vehicle is locked and SAFEFunction is  
switched on, no people may remain in the vehicle.  
The new battery must meet the specifications of the  
original battery.  
SAFE-Turn off the function  
By double locking within 2 seconds.  
Keys, locks and alarm system › Central locking 23  
Or:  
Together with the deactivation of the interior sur-  
When unlocked again, the other doors and the boot  
lid are also unlocked.  
veillance » page 25, Settings.  
Doors on one side of the vehicle  
The doors on the driver’s side and the fuel filler flap  
are unlocked with the button on the key.  
The warning light in the driver's door will flash for  
about 2 seconds in quick succession after the vehicle  
is locked, then goes out and starts flashing regularly  
at longer intervals after about 30 secs.  
In vehicles equipped with a keyless locking system,  
the doors on the passenger’s side near to which the  
key is located and the fuel filler flap are unlocked by  
touching the door handle.  
If the SAFEFunction is switched off, the door can be  
opened from the inside by pulling the opening lever  
once.  
When unlocked again, the other doors and the boot  
lid are also unlocked.  
The SAFEFunction is switched on again after unlock-  
ing and locking the vehicle.  
Automatic locking after starting  
After starting, all doors and the boot lid are locked  
when a speed of 15 km/h is reached.  
Operation  
Unlocking of the vehicle takes place when opening a  
door from the inside or when removing the key from  
the ignition.  
Means for operating the central locking  
Depending on the equipment:  
Key » page 22.  
Keyless Entry (KESSY) » page 24.  
Central locking button.  
WARNING  
An automatically locked vehicle makes it difficult for  
responders to enter the vehicle in an emergency.  
Lock / unlock with the central locking button  
Press the button in the centre console.  
Troubleshooting  
The symbol in the button lights up when locking.  
Central locking fault  
The button locks all doors and the boot lid.  
The warning light in the driver's door first flashes  
Unlocking of the vehicle also takes place when open-  
ing a door from the inside or when removing the key  
from the ignition.  
for 2 secs in quick succession.  
Then it lights up continuously.  
After 30 secs, it flashes slowly.  
WARNING  
Seek the help of a specialist garage.  
A locked vehicle with a central locking button makes  
it difficult for responders to enter the vehicle in an  
emergency.  
Unlock and lock the door mechanically  
Unlocking and locking the door with the lock cylin-  
der  
Setting the unlocking and locking function  
Remove cover  
The lock and unlock functions are set in the follow-  
ing menu in the Infotainment system.  
Pull the handle on the  
front left door and hold  
it.  
Insert the key into the  
recess on the under-  
side of the cover.  
Or:  
All doors  
Open the cover in the  
direction of the arrow.  
Let go of the door han-  
dle.  
Unlocking all doors, the luggage compartment lid  
and the fuel filler flap.  
Single door  
The driver's door and the fuel filler flap are un-  
locked with the button on the key.  
In vehicles equipped with a keyless locking system,  
the door near to which the key is located and the  
fuel filler flap are unlocked by touching the door han-  
dle.  
24 Keys, locks and alarm system › Keyless locking (KESSY)  
Unlock and lock  
Unlock  
Insert the key with the  
Grip the door handle.  
Open the door.  
buttons facing up-  
wards into the lock cyl-  
inder and unlock or  
lock.  
Install cover  
Pull and hold the door  
handle.  
Replace the cover.  
Let go of the door handle.  
Lock  
Lock the door without the locking cylinder  
Touch the sensor.  
After locking, it is not  
possible to unlock  
within 2 seconds by  
touching the door han-  
dle. This can be used to  
check whether the ve-  
hicle is locked.  
Unlock the boot lid  
Open the door.  
For vehicles with a panel over the opening, remove  
the panel.  
Insert the key or a flat-head screwdriver into the  
slot.  
Turn the key or flat-head screwdriver towards the  
outside of the vehicle (spring-loaded position).  
Push the handle of the boot lid.  
Protection against inadvertently locking the key in  
the vehicle  
When the key is locked in the vehicle, the vehicle is  
automatically unlocked. If no door is opened within  
45 seconds, the vehicle automatically locks again.  
When the key is locked in the luggage compartment,  
the luggage compartment lid is automatically un-  
locked.  
After closing, the door is locked.  
Keyless locking (KESSY)  
Usage  
Settings  
Deactivate keyless locking  
The keyless locking system, KESSY, enables unlock-  
ing and locking of the vehicle without actively using  
the remote control key.  
Lock the vehicle with the button on the key.  
Within 5 s, touch the sensor on the door handle  
with your finger.  
Deactivation is confirmed by a single flash of the  
direction indicators.  
Operation  
To check the deactivation, wait at least 10 seconds  
and then pull the door handle.  
Keep the key with you when unlocking and locking.  
The sensors on the handle are intended to be operat-  
ed with bare hands, e.g. wearing gloves may affect  
the function of the sensors.  
The door must remain locked.  
Keyless locking is automatically activated once again  
after the vehicle is unlocked.  
Troubleshooting  
The vehicle cannot be unlocked or locked using  
the sensors on the handle  
Lock or unlock the vehicle with the button on the  
key.  
Keys, locks and alarm system › Alarm system 25  
The trailer is not equipped with LED tail lights.  
Then try to unlock or lock the vehicle using the  
sensors on the handle.  
If keyless locking does not work, get the help of a  
specialist garage.  
If the electrical connection to the trailer is interrup-  
ted in a vehicle with an activated alarm system,  
warning signals are triggered.  
If the vehicle is not unlocked for a longer period  
of time, the function can be deactivated automati-  
cally.  
Disable the alarm before connecting or discon-  
necting a trailer.  
No key was found when the ignition was switched  
on  
Settings  
illuminates  
The following functions of the alarm system can be  
deactivated at the same time.  
A message that no key was found in the vehi-  
cle.  
Interior surveillance.  
Towing protection.  
Insert the key into the vehicle.  
By deactivating the SAFEFunction will also be  
switched off » page 22, Functionality.  
Alarm system  
Functionality  
Deactivation  
By double locking within 2 seconds.  
The alarm system triggers acoustic and optical sig-  
nals in the event of a break-in or towing attempt.  
Or:  
In Infotainment, in the menu:  
item for interior monitoring.  
Menu  
The alarm system is activated automatically approxi-  
mately 30 seconds after the vehicle is locked.  
Or:  
The alarm system is automatically deactivated after  
the vehicle is unlocked.  
In Infotainment, in the menu:  
Menu item for interior monitoring.  
Alarm trigger  
The activated alarm system triggers an alarm when  
one of the following events occurs.  
The deactivated functions are reactivated after un-  
locking and locking the vehicle.  
Deactivation is to be carried out if the vehicle is,  
for example, towed or transported.  
Open the engine compartment lid.  
Open the boot lid.  
Opening the door.  
Manipulation of the ignition lock.  
Towing the vehicle.  
Movement in the vehicle.  
Sudden and significant voltage drop in the electri-  
cal system.  
Unhitch the trailer.  
Opening the door unlocked via the lock cylinder.  
Switch off the triggered alarm  
Unlock the vehicle.  
Or:  
Turn on the ignition.  
Functional conditions  
All windows must be closed for the alarm system to  
function correctly.  
A trailer is integrated into the alarm system under  
the following conditions.  
The vehicle is factory-fitted with a towing device.  
The trailer is electrically connected to the vehicle  
via the trailer socket.