Keys,locksandalarmsystem for Your Skoda Fabia 4 Door Fourth Generation (2021-2026)

20 Keys, locks and alarm system › Key  
Fold out the key bit.  
Release the battery  
cover with your  
thumbnail or by insert-  
ing a flat-head screw-  
driver at the marked  
points.  
Open the battery cov-  
er.  
Keys, locks and alarm system  
Key  
Key Overview  
Locking the vehicle  
Operating the boot  
lid  
Unlocking the vehi-  
cle  
Remove the battery.  
Battery status warn-  
ing light  
Locking button for  
folding the key bit  
in/out  
A
B
Press any button on  
the remote key to re-  
set the key.  
Insert the new battery.  
Fit the battery cover  
and press until it clicks  
into place.  
NOTICE  
Protect the key from moisture and strong vibra-  
tions.  
Keep the grooves in the key clean.  
WARNING  
Risk of death!  
The effective range of the key signal is about  
30 m. The effective range can be reduced, e.g. due to  
If the battery is swallowed, serious or even fatal inju-  
ries can result from burns in the digestive tract.  
signal interference from other transmitters.  
Always keep children away from the vehicle key  
and batteries.  
If the battery is swallowed, seek medical help im-  
mediately.  
Troubleshooting  
The battery in the key is almost empty  
After pressing a button on the key, the warning  
light does not flash.  
Central locking  
Functionality  
Or:  
A message stating it is necessary to change the  
battery will be displayed.  
Central locking system  
The system unlocks and locks all doors, the fuel filler  
flap and the boot lid at the same time.  
Replace the battery » page 20.  
The vehicle cannot be unlocked or locked with the  
remote control  
There may be the following reasons:  
Unlock indicator: double flashing of the indicator  
lights.  
The battery in the key is empty.  
Replace the battery » page 20.  
The key is not synchronized.  
Lock indicator: single flashing of the indicator lights.  
The warning light in the driver's door will flash for  
about 2 seconds in quick succession after the vehicle  
is locked, then it will start flashing regularly at longer  
intervals.  
Synchronize the key as follows:  
Press any button on the key.  
Unlock the door within 1 minute with the key via  
the locking cylinder » page 22.  
If none of the doors or the boot lid is opened  
within 45 seconds of unlocking, the vehicle automat-  
ically locks again.  
If necessary, the key must be synchronized if a  
favoured button on the key has been repeatedly  
pressed outside of the effective range of the remote  
control.  
SAFE function  
Depending on the equipment, the central locking  
system can include the SAFE function.  
The SAFE function prevents the doors from opening  
from the inside once the vehicle is locked.  
Changing the key battery  
The SAFE function is activated when the vehicle is  
locked from the outside.  
The new battery must comply with the specification  
of the original battery.  
Keys, locks and alarm system › Central locking 21  
In the display of the instrument cluster after the igni-  
tion is switched off, a message regarding the SAFE  
function is displayed.  
All doors  
Unlocking of all doors, the boot lid and the fuel filler  
flap.  
DANGER  
Risk of death!  
No people are allowed in the locked vehicle with  
the SAFE function.  
Single door  
Using the button on the key, the driver's door and  
the fuel filler flap are unlocked.  
In vehicles equipped with a keyless locking system,  
the door near to which the key is located and the  
fuel filler flap are unlocked by touching the door han-  
dle.  
Turn off the SAFE function  
By double locking within 2 seconds.  
Or:  
Together with the deactivation of the interior mon-  
itoring » page 23, Settings.  
When unlocked again, the other doors and the boot  
lid are unlocked.  
Doors on one side of the vehicle  
Using the button on the key, the doors on the driv-  
er’s side and the fuel filler flap are unlocked.  
The warning light in the driver's door will flash for  
about 2 seconds in quick succession after the vehicle  
is locked, then goes out and starts flashing regularly  
at longer intervals after about 30 secs.  
In vehicles equipped with a keyless locking system,  
the doors on the passenger’s side near to which the  
key is located and the fuel filler flap are unlocked by  
touching the door handle.  
When the SAFE function is switched off, the door  
can be opened from the inside by pulling once on the  
opening lever.  
When unlocked again, the other doors and the boot  
lid are unlocked.  
The SAFE function is switched on again after unlock-  
ing and locking the vehicle.  
Automatic locking after starting  
All doors and the boot lid are locked when a speed of  
15 km/h is reached.  
Operation  
Ways in which central locking operates  
Depending upon vehicle equipment:  
Unlocking of the vehicle takes place when opening a  
door from the inside or when removing the key from  
the ignition.  
Key » page 20  
Keyless locking (KESSY)» page 22.  
Central locking button  
WARNING  
An automatically locked vehicle makes it difficult for  
responders to enter the vehicle in an emergency.  
Lock/unlock using the central locking button  
Press the button in the centre console.  
The symbol in the button comes on when locked.  
Troubleshooting  
The button locks/unlocks all of the doors and the  
boot lid.  
Central locking fault  
The warning light in the driver's door first flashes  
Unlocking of the vehicle also takes place when open-  
ing a door from the inside or when removing the key  
from the ignition.  
for 2 secs in quick succession.  
Then it lights up continuously.  
After 30 secs, it flashes slowly.  
WARNING  
Seek the help of a specialist garage.  
A locked vehicle with a central locking button makes  
it difficult for responders to enter the vehicle in an  
emergency.  
Setting the unlocking and locking function  
In Infotainment, select the following menu:  
Or:  
22 Keys, locks and alarm system › Keyless locking (KESSY)  
Mechanically unlocking and locking the door  
Operation  
Unlocking and locking the door with the lock cylin-  
der  
Keep the key with you when unlocking and locking.  
The sensors on the handle are intended to be operat-  
ed with bare hands, e.g. wearing gloves may affect  
the function of the sensors.  
Remove the cover  
Pull the handle on the  
front left door and hold  
it in place.  
Release  
Grab the door handle.  
Open the door.  
Insert the key into the  
recess on the under-  
side of the cover.  
Lift the cover in the di-  
rection of the arrow.  
Release the door han-  
dle.  
Locking and unlocking  
Insert the key with the  
buttons facing up-  
wards into the lock cyl-  
inder and unlock or  
lock.  
Lock  
Touch the sensor.  
After locking, it is not  
possible to unlock  
Install cover  
within 2 seconds by  
touching the door han-  
dle. This can be used to  
check whether the ve-  
hicle is locked.  
Pull on the door handle  
and hold it.  
Replace the cover.  
Release the door handle.  
Locking the door without the lock cylinder  
Unlocking the boot lid  
Press the handle of the boot lid.  
Protection against inadvertently locking the key in  
the vehicle  
If the key is locked inside the vehicle, the vehicle will  
unlock itself automatically. If no door is opened with-  
in 45 seconds, the vehicle automatically locks again.  
If the key is locked in the boot, the boot lid will auto-  
matically unlock itself.  
Open the door.  
For vehicles with a panel over the opening, remove  
the panel.  
Settings  
Insert the key or a flat-head screwdriver into the  
slot.  
Turn the key or flat-head screwdriver towards the  
outside of the vehicle (spring-loaded position).  
Deactivate keyless locking  
Lock the vehicle with the button on the key.  
Within 5 s, touch the sensor on the door handle  
with your finger.  
After closing, the door is locked.  
Deactivation is confirmed by a single flash of the  
direction indicators.  
To check the deactivation, wait at least 10 seconds  
and then pull the door handle.  
Keyless locking (KESSY)  
Usage  
The door must remain locked.  
The keyless locking system, KESSY, enables unlock-  
ing and locking of the vehicle without actively using  
the remote control key.  
Keyless locking is automatically activated once again  
after the vehicle is unlocked.  
Keys, locks and alarm system › Alarm system 23  
A trailer is integrated into the alarm system under  
the following conditions:  
Troubleshooting  
The vehicle cannot be unlocked or locked using  
the sensors on the handle  
The vehicle is factory-fitted with a towing device.  
The trailer is electrically connected to the vehicle  
via the trailer socket.  
The trailer is not equipped with LED taillights.  
Lock or unlock the vehicle with the button on the  
key.  
Then try to unlock or lock the vehicle using the  
sensors on the handle.  
If the electrical connection to the trailer is interrup-  
ted on a vehicle with an activated alarm system,  
warning signals are triggered.  
If keyless locking does not work, seek the help of a  
specialist garage.  
Disable the alarm before connecting or discon-  
necting a trailer.  
If the vehicle is not unlocked for a longer period  
of time, the function can be deactivated automati-  
cally.  
When the ignition was switched on, no key was  
found  
Settings  
illuminates  
The following functions of the alarm system can be  
deactivated at the same time:  
Message that no key was found in the vehicle  
Insert the key into the vehicle.  
Interior monitoring  
Towing protection  
Deactivation will also switch off the SAFE func-  
tion » page 20, Functionality.  
Alarm system  
Functionality  
Deactivation  
By double locking within 2 seconds.  
The alarm system triggers audible and visual signals  
during a break-in or towing attempt.  
Or:  
The alarm system is activated automatically approxi-  
mately 30 seconds after the vehicle is locked.  
In infotainment in the menu  
item for interior monitoring  
Menu  
The alarm system is automatically deactivated after  
the vehicle is unlocked.  
Or:  
In infotainment in the menu  
Menu item for interior monitoring  
Alarm triggering  
The activated alarm system triggers an alarm when  
one of the following events occurs:  
The deactivated functions are reactivated after the  
vehicle is unlocked and locked again.  
Opening the bonnet  
Opening the boot lid  
Opening the door  
Manipulation of the ignition lock  
Towing the vehicle  
Movement in the vehicle  
Deactivation is to be carried out if the vehicle is,  
for example, towed or transported.  
Sudden and significant voltage drop of the electri-  
cal system  
Uncoupling the trailer  
Opening the door unlocked via the lock cylinder  
Switching off the triggered alarm  
Unlock the vehicle.  
Or:  
Turn on the ignition.  
Operating conditions  
For the correct functioning of the alarm system, all  
windows must be closed.