46 Lighting, windscreen wipers and washers › Replace light bulbs
Operation
Conditions for changing a bulb
Switching on
✓ Ignition off
✓ Light switched off
Push the lever in the
direction of the arrow.
›
It lights up in the instru-
Rear turn signal
ment cluster
from
the isolation box.
Remove the cover with
the bracket from the
tool kit.
›
Switching off
Manually switch the high beam on or off.
›
Function restriction
The system may dazzle other road users if their
headlights/lights are not detected for the following
reasons, for example:
› Unscrew screws A and
remove the lamp.
The headlights/lights of oncoming vehicles are
covered by crash barriers, for example.
▶
The headlamps/lights of the oncoming or preced-
ing vehicle are dirty or not functioning.
▶
Settings
Activation/deactivation
The function is activated or deactivated in the fol-
lowing menu in the Infotainment system:
Press the lock mecha-
›
nisms on the connec-
tor and remove the
connector.
Or:
Activation/deactivation
The function is activated or deactivated as follows in
the Infotainment system in the menu
.
Turn and remove the
socket with the bulb.
›
Replace light bulbs
What you should be mindful of
DIY replacement of the following bulbs is possible.
Have the remaining light sources replaced by a spe-
cialist garage.
The new bulb must conform to the specification of
the original light bulb. The name of the bulb is
marked on the bulb socket.
NOTICE
Danger of headlight damage due to the ingress of
water and dirt!
Always fit the protective cap on the headlight cor-
▶
rectly after changing a bulb.
English 
