Doors, windows and boot lid -> Window - with electrical operation for Your Skoda Kodiaq SUV Second Generation (2024-2026)

Doors, windows and boot lid › Protective door strip 29  
Electrically operated child lock  
NOTICE  
If any part of the strip remains in the door, seek the  
help of a specialist garage.  
Press the left button to  
switch on/off the child  
lock in the left rear  
door.  
Insert a new strip in  
the grooves.  
Press in the strip.  
Press the right button  
to switch on/off the  
child lock in the right  
rear door.  
The fact that the child  
lock is switched on can  
be seen by the illuminated displayed in the button.  
After switching on the child lock the electric window  
is also blocked in the respective door.  
A new strip can be purchased from ŠKODA Origi-  
nal Parts.  
Protective door strip  
Window - with electrical operation  
What you should be mindful of  
What you should be mindful of  
NOTICE  
Force limiter  
To reduce the risk of pinch injuries when closing the  
windows, the vehicle has a force limiter.  
Risk of damage to the strip, the door and the body!  
Do not open the door too hastily or abruptly.  
Do not hold the door on the strip when opening  
and closing, as the strip must be able to move in  
and out freely.  
If the strip prevents the door from closing freely,  
do not close the door forcefully! Remove the strip,  
and seek the help of a specialist garage.  
If there is an obstacle, the window closing process is  
stopped and the pane retracts by several centime-  
tres.  
If the obstacle prevents it from being closed for the  
next 10 seconds, the closing process is interrupted  
once again and the window goes down by several  
centimetres.  
Usage  
If you attempt to close the window again within  
10 seconds of the window being moved down for  
the second time, even though the obstacle was not  
yet been removed, the closing process is only stop-  
ped. During this time, it is not possible to automati-  
cally close the windows by pulling the button all the  
way. The force limiter is, however, switched on.  
Depending on the trim level, the doors can each be  
equipped with a protective strip. This moves out  
when opening the door and protects the central area  
of the door edge from damage.  
When the door closes the protective strip retracts.  
The force limiter is only not operational if you at-  
tempt to close the window again within the next  
10 seconds – the window will now close with full  
force! If you wait longer than 10 seconds, the force  
limiter is switched on again.  
Self-help  
Replacing the damaged strip  
CAUTION  
CAUTION  
Risk of injury!  
Risk of injury!  
Be careful when handling the strip.  
Close the windows carefully, even though they  
have a force limiter.  
Remove the strip from  
the door.  
30 Doors, windows and boot lid › Window - with electrical operation  
Open all of the windows at the same time  
Press and hold the button on the key.  
Overview of the operating buttons on the  
driver's door  
Or:  
Turn off the ignition, open the driver's door, and  
hold down the driver's window button until it  
stops.  
Close all of the windows at the same time  
Press and hold the button on the key.  
Or:  
Turn off the ignition, open the driver's door, and  
pull upwards on the driver's window button until it  
stops.  
Depending upon vehicle equipment:  
Or:  
A
B
C
D
E
Front left window  
Front right window  
Rear left window  
Rear right window  
For vehicles with a keyless locking system, hold  
one finger on the sensor on the outside of the han-  
dle on the front door.  
Deactivation/activation of the buttons in the  
rear doors  
Settings  
The window operation is set in the following menu in  
the Infotainment system:  
F
Deactivation/activation of the key in the left rear  
door (part of the child safety lock with electric  
operation) » page 28, Operation  
Menu item for window operation  
G
Deactivation/activation of the key in the right  
back door (part of the child safety lock with  
electric operation) » page 28, Operation  
Or:  
Menu item for window operation  
Troubleshooting  
Operation  
When the windows are open, irritating noises  
The window regulator has stopped working after  
repeated opening and closing  
The window regulator mechanism could have over-  
heated.  
may occur at certain speeds.  
Opening  
Press the corresponding button slightly down-  
wards and hold it until the window has reached the  
desired position.  
Allow the window regulator mechanism to cool  
down.  
The window operation does not work after discon-  
necting the 12 volt vehicle battery  
Or:  
Enable window operation » page 30.  
Press the corresponding button until it stops; the  
window opens automatically. Pressing the button  
again will stop the opening process.  
Activation after disconnecting the 12-volt  
vehicle battery  
Closing  
To close, pull gently upwards on the top edge of  
the corresponding button and hold until the win-  
dow has reached the desired position.  
Activate automatic window operation  
Turn on the ignition.  
Pull the corresponding button upwards and the  
window closes.  
Release the button.  
Pull up the respective button and hold for 1 sec-  
ond.  
Or:  
Pull the corresponding button until it stops; the  
window closes automatically. By pressing the but-  
ton again, the closing process is stopped.  
After switching off the ignition, the windows can  
still open and close for about 10 minutes so long as  
none of the doors are opened.