Restraint systems and airbags -> Child seat for Your Skoda Kodiaq SUV Second Generation (2024-2026)

Restraint systems and airbags › Child seat 43  
Insert the buckle latch A into the buckle until  
Child seat  
there is an audible click.  
What you should be mindful of  
Use the buckle latch B to slowly pull the belt over  
your chest and pelvis.  
For how to install and use the child seat, please note  
the instructions in this Owner's Manual as well as the  
instructions of the child seat manufacturer.  
Insert the buckle latch B into the second buckle  
until there is an audible click.  
Pull on the belt to ensure that the buckle latch is  
securely fastened.  
For safety reasons, we always recommend that chil-  
dren are transported on the back seats. Carry chil-  
dren on the front passenger seat only in exceptional  
cases.  
To take it off take the buckle latch A and release  
by pressing the red button.  
Use child seats according to standard ECE-R 44 and  
ECE-R 129 of the European Economic Commission.  
Grasp the buckle latch A and release it by pressing  
the red button.  
Child seats according to standard ECE-R 44 and  
ECE-R 129 are marked with the test symbol: large E  
in a circle, with the test number below.  
Hold the belt so it does not twist when rolling up.  
Settings  
We recommend using child seats from the ŠKODA  
Original Accessories range. These child seats have  
been developed and tested for use in ŠKODA vehi-  
cles. They satisfy the standard ECE-R 44 or ECE-R  
129.  
Move the seat belt  
height adjuster up-  
wards to increase the  
height.  
WARNING  
When installing the child seat on a seat in the sec-  
ond or third row of seats, adjust the corresponding  
seat in front so that there is no contact between  
the child seat and the seat in front, or the child be-  
ing carried in the child seat.  
Before installing a forward-facing child seat, adjust  
the headrest so that it is as low as possible.  
If the head restraint prevents the child seat from  
being fitted, then the head restraint must be re-  
moved.  
Press the safety button  
and move the seat belt  
height adjuster down  
to reduce the height.  
After adjustment, firm-  
After removing the child seat, reinstall the head-  
rest.  
When installing the child seat, avoid contact be-  
tween the roof and the rear pillar. If the head air-  
bag is deployed, there is a risk of injury.  
If using a separate child seat cushion, adjust the  
headrest so that the child's head is flush with, but  
not protruding above the height of the top edge of  
the headrest.  
ly pull on the belt to  
ensure that the seat  
belt height adjuster has  
correctly locked in  
place and that the belt  
is locked securely.  
Troubleshooting  
Blocked belt retractor  
Grasp the strap in the  
middle and pull quickly.  
Hold the strap and let  
it roll up slowly.  
Using a child seat on the front passenger seat  
When using a child seat on the passenger seat, any  
country-specific regulations must be observed.  
Never use a child seat in which the child is carried  
with his or her back to the direction of travel on a  
seat protected by an active airbag placed in front of  
the seat. This could cause serious injury to the child,  
even death.  
Pull on the strap to see  
if the retractor is  
working properly.  
If the strap is still  
blocked, repeat the un-  
locking procedure  
once or twice.  
This is also indicated by the following stickers:  
If the strap is still blocked, seek the help of a spe-  
cialist garage.  
44 Restraint systems and airbags › Child seat  
If possible, move the front passenger seat back-  
wards so that there is no contact between the  
front passenger seat and the child seat behind it.  
Adjust the height-adjustable front passenger seat  
as much as possible.  
Set the front passenger seat belt as high up as pos-  
sible.  
WARNING  
Risk of the seat belt causing a neck injury to the  
transported child!  
Sticker on the passenger sun visor  
For child seats in groups 2 and 3, ensure that the  
guide fitting attached to the child seat headrest is  
positioned in front of or at the same height as the  
seat belt height adjuster on the central body pillar.  
Sticker on the central body pillar on the passenger  
side  
The following instructions must be followed when  
using a child seat on the front passenger seat:  
Adjust the height of the front passenger seat belt  
so that the belt passes through the guide fitting  
without kinking and is not bent over the edge of  
the guide fitting.  
It is essential to deactivate the front passenger air-  
bag if using a child seat in which the child is trans-  
ported with its back facing the direction of trav-  
el » page 48.  
WARNING  
As soon as the rear-facing child seat is no longer  
being used on the front passenger seat, activate  
the front passenger airbag again.  
If possible, adjust the front passenger seat back-  
rest so that it is vertical, to ensure that there is se-  
cure contact between the backrest and the child  
seat.  
Recommended child seats  
Grouping of child seats according to standard ECE-R 44.  
Group  
Weight of the child  
0
0+  
1
up to 10 kg  
up to 13 kg  
9-18 kg  
2
3
15-25 kg  
22-36 kg  
Recommended child seats  
Approval number  
Group  
Manufacturer  
Type  
Attachment  
Order number  
(E1 ...)  
0+  
(up to 13  
kg)  
Britax Römer  
Britax Römer  
Britax Römer  
Baby Safe Plus Isofix base frame  
1ST019907  
DDA000006  
000019906K  
04 301146  
1
ISOFIX and TOP  
Duo Plus TT  
04 301133  
04 301198  
(9-18 kg)  
TETHER  
Safety belt and  
Kidfix XP a)  
ISOFIX/safety  
2-3  
belt b)  
(15-36 kg)  
Safety belt and  
ISOFIX/safety  
Britax Römer  
Kidfix II XP  
000019906L  
04 301323  
belt b)  
a)  
For optimum protection, especially in the event of a side impact, it is recommended that you use this child  
seat complete with the backrest.  
b)  
Only use the fastening means of the seat belt if the seat is not equipped with the ISOFIX system.