Doors, windows and boot lid › Sliding/tilting roof 29
Open all of the windows at the same time
Sliding/tilting roof
Press and hold the button on the key.
›
What you should be mindful of
Or:
To reduce the risk of pinch injuries when closing the
tilt/slide sunroof, the vehicle has a force limiter.
Turn off the ignition, open the driver's door, and
hold down the driver's window button until it
stops.
›
If the operation is activated in the closed direction
and the closing process is hindered by an obstacle,
the movement of the glass pane is stopped and the
pane moves back a few centimetres.
Close all of the windows at the same time
Press and hold the button on the key.
›
Or:
If the obstacle is not removed, the force limit is disa-
bled when you try to close again by moving and
holding a finger in the closed direction (if the time
span between the closing attempts is less than 5 s).
The sliding/tilting roof will then close with full force.
Turn off the ignition, open the driver's door, and
pull upwards on the driver's window button until it
stops.
›
Or:
For vehicles with a keyless locking system, hold
one finger on the sensor on the outside of the han-
dle on the front door.
›
CAUTION
Risk of injury!
Close the sliding/tilting roof carefully, even though
there is a force limiter.
▶
NOTICE
Settings
During winter time, if necessary, remove any ice
and snow around the area of the sliding/tilting roof
before opening.
Always close the sliding/tilting roof before discon-
necting the 12 volt vehicle battery.
▶
▶
The window operation is set in the following menu in
the Infotainment system:
Outside Menu item for window operation
Or:
Outside
Operating conditions
By moving your finger sideways, choose the screen
with the window operation menu item.
Select the menu item for window operation.
›
✓ Ignition is switched on.
›
✓ The outside temperature is higher than -20 °C
(applicable for the opening of the sliding/tilting
roof).
Troubleshooting
The window regulator has stopped working after
repeated opening and closing
The window regulator mechanism could have over-
heated.
Operation
Opening
Move backwards using
your finger.
›
Allow the window regulator mechanism to cool
down.
›
The window operation does not work after discon-
necting the 12 volt vehicle battery
Enable window operation » page 29.
›
Activation after disconnecting the 12-volt
vehicle battery
Activate automatic window operation
Turn on the ignition.
Pull the corresponding button upwards and the
window closes.
›
›
Release the button.
Pull up the respective button and hold for 1 sec-
ond.
›
›
English 
