196 Wheels › Wheel bolt cover caps
Push the wheel wrench through the clamp, support
on the tyre and pull off the wheel trim.
Saving tyre pressure values
Saving tyre pressure values
›
Installing
Press the
button under the Infotainment.
›
›
Press the wheel trim onto the wheel rim at the
designated valve opening.
›
In the displayed menu in Infotainment, tap the
functional surface
.
When using an anti-theft wheel bolt, it must be lo-
cated at the location indicated on the bezel.
Press the trim, starting at the valve, into the rim on
both sides until it engages around the entire cir-
cumference.
Then follow the instructions on the screen.
›
Save the tyre pressures in the following cases:
›
Change of tyre pressure
Change of one or more wheels
Change of position of a wheel on the vehicle
Always after covering a distance of 10,000 km or
once a year
▶
▶
▶
▶
NOTICE
Use hand pressure, do not hit the wheel cover.
▶
Troubleshooting
Tyre pressure display faulty
flashes for about 1 minute and stays on
Stop the vehicle, switch off the ignition and
start the engine.
›
If the symbol flashes again after starting the en-
gine, there is a system fault.
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
›
Wheel bolt cover caps
Remove cover caps and install
Disconnecting
Push the pull-off clamp
onto the cover cap up
to the stop.
›
Remove the cover cap.
›
Installing
Push the cover cap onto the wheel bolt to the stop.
›
Full wheel frame
Removing and installing the trim
Applies to factory built or original accessory trims
from ŠKODA.
Disconnecting
Hang the clamps for removing the wheel trims at
the edge of one of the openings in the trim.
›
English 
