2016-2023 Skoda Superb SUV Vehicle battery and fuses -> Using the jump-starting cable User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Vehicle battery and fuses -> Using the jump-starting cable for Your Skoda Superb SUV Third Generation (2016-2023)

Vehicle battery and fuses › Using the jump-starting cable 199  
Tap on the indicator  
before testing, to clear  
air bubbles.  
Stop driving!  
Stop the engine and seek the help of a specialist  
garage.  
›
›
›
Black colour - the acid  
level is OK.  
Colourless or pale yel-  
low colour - acid level  
is too low, the battery  
must be replaced.  
▶
▶
Disconnecting, connecting and replacing  
CAUTION  
Risk of fire!  
Do not mix up the connection cables.  
▶
Requirements for the charging process  
✓ Ignition off.  
✓ Power consumers switched off.  
Disconnect  
Close the electric boot lid, the tilting/sliding sun-  
›
roof, all windows and the electric sun blind.  
Switch off the ignition and any connected power  
consumers.  
›
Vehicle battery charging process  
To charge the vehicle battery fully, set a charging  
current of max. of 0.1 times the battery capacity.  
Disconnect the  
nal.  
terminal and then the  
termi-  
›
Connect the  
nal of the charger to  
termi-  
›
Connect  
the  
terminal of the  
Connect the  
terminal and then the  
terminal.  
›
vehicle battery.  
After switching on ignition, the indicator lights illumi-  
nate briefly. from the isolation box.  
Connect the termi-  
nal of the charger to  
the earth point A .  
›
›
If, after a short distance, one of the above-men-  
tioned indicator lights does not go out, seek the  
help of a specialist garage.  
›
Plug the charger's  
power cable into the  
socket and switch on  
the device.  
Commission these functions after disconnecting  
and connecting the vehicle battery  
Clock setting » page 62.  
Window operation » page 30.  
Operation of the tilting/sliding sunroof » page 31.  
Sun blind » page 32.  
Earth point  
▶
▶
▶
▶
After charging, switch off the charger and unplug  
the power cable from the socket.  
Disconnect the charger terminals from the vehicle  
battery.  
›
›
Changing  
WARNING  
The new vehicle battery must have the same param-  
eters as the original battery. Have the replacement  
carried out by a specialist garage.  
Risk of explosion!  
During charging, hydrogen is released. An explo-  
sion can also be caused by sparks, for example,  
when disconnecting or loosening the cable con-  
nector.  
▶
Using the jump-starting cable  
What you should be mindful of  
Never charge a frozen or thawed vehicle battery.  
▶
▶
Do not carry out the so-called quick charging of  
the vehicle battery yourself, but have it carried out  
by a specialist garage.  
WARNING  
Risk of explosion and chemical burns!  
NOTICE  
Do not jump start with the battery of another vehi-  
cle under the following conditions.  
▶
A flat vehicle battery can freeze easily!  
▶
The discharged vehicle battery is frozen. A dis-  
charged vehicle battery can freeze at tempera-  
tures just below 0°C.  
The battery acid level is too low » page 198.  
Troubleshooting  
▶
Vehicle battery does not charge while the engine is  
running  
Use jump leads with a sufficient cross section and in-  
sulated terminal clamps.  
or  
illuminates  
Seek the help of a specialist garage.  
›
The rated voltage of both batteries must be 12V. The  
capacity (in Ah) of the charging battery must not be  
significantly lower than the capacity of the dis-  
charged battery.  
Engine fault  
or  
illuminates  
200 Vehicle battery and fuses › Fuses  
Disconnecting the cable  
Jump-starting with the battery of another  
vehicle  
Disconnect the cables in the reverse order from  
›
connection.  
WARNING  
Risk of injury and danger of vehicle damage!  
Lay the jump start cables so that they cannot be-  
come caught by rotating parts in the engine com-  
partment.  
▶
Fuses  
What you should be mindful of  
NOTICE  
Short circuit!  
NOTICE  
Fire hazard and risk of damage to the electrical sys-  
tem.  
The non-insulated parts of the terminal clamps  
must not touch each other.  
The cable connected to the positive pole of the  
battery must not come into contact with electri-  
cally conductive vehicle parts.  
▶
Do not repair fuses or replace them with stronger  
fuses.  
Replace the defective fuse with a new fuse with  
the same amperage.  
We recommend using replacement fuses from the  
ŠKODA Genuine Accessories range. These guaran-  
tee reliable and safe consumer protection.  
If a newly inserted fuse blows again, seek the help  
of a specialist garage.  
▶
▶
▶
▶
The vehicles must not touch each other.  
▶
Connect the jump start cable  
Connect the terminal clamps of the jump start ca-  
bles in the order shown in the legend.  
›
▶
One fuse may belong to several consumers. One  
consumer may have several fuses.  
Functionality  
- discharged battery /  
- current-emitting battery  
1
-pole of the discharged battery  
2
3
4
-pole of the current-emitting battery  
-pole of the current-emitting battery  
Earth point of the engine to be started  
Blown fuse  
Conditions for replacing a fuse  
✓ Ignition off.  
✓ Driver door opened.  
✓ All consumers switched off.  
Replacing a fuse  
Replace the fuse with  
›
›
the clamp located on  
the inside of the fuse  
box cover in the engine  
compartment.  
Use the appropriate  
end of the clamp ac-  
cording to the fuse di-  
mensions.  
Earth point  
Start the engine  
Start the engine of the current-giving vehicle and  
let it idle.  
›
Start the engine of the vehicle with the flat battery.  
If the engine of the vehicle with the flat battery  
does not start within 10 seconds, repeat the start-  
ing procedure after approximately 30 seconds.  
›
›

Related Topics

Popular Owner Manuals