Wheels › Tyre pressure 211
Usage restrictions
Tyre pressure
Do not use the kit in the following cases:
What you should be mindful of
The rim is damaged.
▶
▶
NOTICE
The outdoor temperature is below the minimum
temperature indicated in the manual of the tyre fill-
ing bottle.
Tyre punctures are greater than 4 mm.
There is damage to the tyre wall.
Always adjust the tyre pressure to the load.
Check the pressure in all tyres at least once a
month and before each longer ride.
Check the pressure when the tyres are cold. Do
not reduce the higher pressure of warm tyres.
After each change in tyre pressure, save the new
values in the tyre control display.
▶
▶
▶
▶
▶
▶
▶
The expiry date stated on the tyre inflation bottle
has expired.
WARNING
Risk of an accident!
Self-help
If tyre pressure loss is very quick, try to stop the
vehicle carefully without heavy steering or heavy
braking.
▶
Seal the tyres
Unscrew the valve cap from the damaged tyre.
Unscrew the valve core with the valve insert and
place it on a clean surface.
›
›
Sticker with prescribed tyre pressures
Shake the tyre inflation bottle back and forth with
sealant.
›
The sticker with prescribed tyre pressures is located
on the inside of the fuel filler flap.
Screw the inflation hose onto the tyre inflater bot-
tle. The film on the closure is pierced automatically.
›
Inflation pressure for
half load
Inflation pressure for
a full load
Tyre diameter in in-
ches
This information only
serves as informa-
tion for the prescri-
bed tyre pressure.
This is not a listing of
A
B
C
Remove the plug from the inflation hose and push
it fully onto the tyre valve.
›
Hold the bottle with the bottom facing upwards
and fill all of the sealing agent into the tyre.
›
Remove the filler plug from the valve.
Screw in the valve insert.
›
›
Inflate tyres
Fit the tyre inflation hose of the air compressor to
the tyre valve.
›
Secure the vehicle with the parking brake.
Start the engine.
Plug the connector into the 12 volt socket .
Turn on the air compressor.
Once a tyre pressure of 2.0-2.5 bar is reached, turn
off the air compressor.
›
approved tyre sizes for your vehicle. These are in
the vehicle's technical documentation, as well as
in the declaration of conformity (in the so-called
COC document).
›
›
›
›
Tyre pressure reading for the front axle tyres
D
E
F
Tyre pressure reading for the rear axle tyres
Observe the maximum running time of the air com-
pressor according to the directions of the repair kit
manufacturer.
Prescribed tyre pressure value for the emergen-
cy wheel
If an air pressure of 2.0 - 2.5 bar has not been
reached, remove the tyre inflation hose from the
›
Tyre pressure monitor
Functionality
valve.
Drive approx. 10 metres forwards or backwards to
allow the sealing agent to distribute in the tyre.
›
The tyre pressure monitoring indicator indicates a
change in tyre pressure.
Replace the tire inflation hose on the valve and re-
peat the inflation procedure.
›
Warning when pressure changes
illuminates
Stop the vehicle.
Check the tyres and tyre pressures.
›
›
English 
