2000-2004 Subaru Outback SUV In case of emergency -> Flat tires User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

In case of emergency -> Flat tires for Your Subaru Outback SUV Second Generation (2000-2004)

9-4
HB8003BBHG0106
Indicator
location
mark
Tread wear
indicator bar
NOTE
[Automatic transmission vehicle not equipped with VDC (Vehicle Dy-
namics Control) and not equipped with SPORTSHIFT] Before driving
your vehicle with the temporary spare tire, put a spare fuse inside
the FWD connector located in the engine compartment and confirm
that the Front-wheel drive warning light comes on. The all wheel
drive capability of the vehicle has now been deactivated. After re-
installing the conventional tire, remove the spare fuse from the FWD
connector in order to reactivate all wheel drive.
Flat tires
WARNING
D Do not jack up the vehicle on an incline or a loose road sur-
face. The jack can come out of the jacking point or sink into the
ground and this can result in a severe accident.
D Use only the jack provided with your vehicle. The jack sup-
plied with the vehicle is designed only for changing a tire. Never
get under the vehicle while supporting the vehicle with this jack.
D Always turn the engine off before raising the flat tire off the
ground using the jack. Never swing or push the vehicle sup-
ported with the jack. The jack can come out of the jacking point
due to a jolt and this can result in a severe accident.
9
In case of emergency
9-5
– CONTINUED –
D Do not use oil or grease on the wheel studs or nuts when the
spare tire is installed. This could cause the nuts to become loose
and lead to an accident.
D Never place a tire or tire changing tools in the passenger
compartment after changing wheels. In a sudden stop or colli-
sions, loose equipment could strike occupants and cause injury.
Store the tire and all tools in the proper place.
If you have a flat tire while driving, never brake suddenly; keep driving
straight ahead while gradually reducing speed. Then slowly pull off the
road to a safe place.
1. Park on a hard, level surface, whenever possible, then stop the en-
gine.
2. Set the parking brake securely and shift a manual transmission ve-
hicle in reverse or an automatic transmission vehicle in the “P” (Park)
position.
3. Turn on the hazard warning flasher and have everyone get out of the
vehicle.
4. Put wheel blocks at the front and rear of the tire diagonally opposite
the flat tire.
HGS038BA
9-6
5. Take out the spare tire, jack, and wheel nut wrench.
HB6008BCHB9003BB
HS0252
Temporary spare tire
HBF015CB
Jack handle
Jack
Spare tire
HB8004BD
The spare tire is stored under the floor of the trunk or cargo area.
To remove the spare tire, proceed as follows:
Sedan: Remove the floor cover from the trunk. Remove the storage tray.
Turn the attaching bolt counterclockwise, then take the spare tire out.
Station wagon: Open the lid and hang the hook provided on the under-
9
In case of emergency
9-7
– CONTINUED –
side of the lid on the rear edge of the roof to keep the lid open.
Remove the storage tray. Turn the attaching bolt counterclockwise, then
take spare tire out.
If the spare tire provided in your vehicle is a temporary spare tire, care-
fully read the section “Temporary spare tire” in this chapter and strictly
follow the instructions.
HB7008CD
HB9001BB
The jack is stored on the left side of the trunk or cargo area.
To take out the jack:
Remove the cover, turn the jackscrew counterclockwise to loosen it, then
remove the jack.
HB9041BAHB9040BA
If the jackscrew is too tight to be loosened by hand, loosen it using a
screwdriver or the jack handle.
9-8
The jack handle is stored under the spare tire cover.
NOTE
Make sure the jack is well lubricated before using it.
6. (If your vehicle has wheel covers) Insert the wheel nut wrench into the
notch provided in the wheel cover, and pry it off.
OM-H0376
HB9032BA
7. Loosen the wheel nuts using the wheel nut wrench but do not remove
the nuts.
8. Place the jack under the side sill at the front or rear jack-up point clos-
est to the flat tire.
HB9012BB
OM-H2262
Turn the jackscrew by hand until the jack head engages firmly into the
jack-up point.
If your vehicle is equipped with side sill skirts, jack-up points are pointed
9
In case of emergency
9-9
– CONTINUED –
to by arrow marks on the underside of the side sill skirt. Place the jack
under the front or rear jack-up point closest to flat tire.
HS9023BA
9. Insert the jack handle into the jackscrew, and turn the handle until the
tire clears the ground. Do not raise the vehicle higher than necessary.
OM-H2263
10. Remove the wheel nuts and the flat tire.
11. Before putting the spare tire on, clean the mounting surface of the
wheel and hub with a cloth.
9-10
HG0104OM-H0172
12. Put on the spare tire. Replace the wheel nuts. Tighten them by hand.
13. Turn the jack handle counterclockwise to lower the vehicle.
14. Use the wheel nut wrench to securely tighten the wheel nuts to the
specified torque, following the tightening order in the illustration.
OM-H0377
The torque for tightening the nuts is 58 to 72 ft-lb (78 to 98 N-m, 8 to 10
kg-m). This torque is equivalent to applying about 88 to 110 lbs (40 to 50
kg) at the top of the wheel nut wrench. Never use your foot on the wheel
nut wrench or a pipe extension on the wrench because you may exceed
the specified torque. Have the wheel nut torque checked at the nearest
automotive service facility.
15. Store the flat tire in the spare tire compartment.
9
In case of emergency
9-11
– CONTINUED –
HS0153
Flat tire
Attaching bolt
Spacer
When storing a conventional tire, put the spacer upside down and tight-
en the attaching bolt firmly.
Also store the jack and wheel nut wrench in their storage locations.
HB9041CAHB9040CA
After placing the jack in its storage location, turn the jackscrew clock-
wise by hand until it becomes too hard to turn. Then, tighten it by an
additional 1/4 – 1/3 of a turn using a screwdriver or the jack handle. Un-
less the jack is properly secured, it may rattle while the vehicle is mov-
ing.

Related Topics

Popular Owner Manuals