Black plate (166,1)
北米Model "A2420BE-B" EDITED: 2006/ 7/ 26
3-44 Instruments and controls
. Grease, wax, insects or other mate-
rial on the windshield or the wiper
blades results in jerky wiper operation
and streaking on the glass. If you
cannot remove those streaks after
operating the washer or if the wiper
operation is jerky, clean the outer sur-
face of the windshield or rear window
and the wiper blades using a sponge or
soft cloth with a neutral detergent or
mild-abrasive cleaner. After cleaning,
rinse the win dow glass and wiper
blades with clean water. The glass is
clean if no beads form on the glass
when you rinse with water.
. If you cannot eliminate the streaking
even after following this pr ocedure,
replace the wiper blades with new
ones. Refer to the “Replacement of
wiper blades” section (chapter 11) for
replacement instructions.
& Windshield wiper and washer
switches
The wiper operates only when the ignition
switch is in the “ON” or “ACC” position.
! Windshield wipers
OFF : Park
: Intermittent
LO: Low speed
HI: High speed
To turn the wipers on, push the wiper
control lever down.
To turn the wipers off, return the lever to
the “OFF” position.
! Mist (for a single wipe)
For a single wipe of the wipers, pull the
lever toward you. The wipers operate until
you release the lever.
English 
