Get Steering Column Controls -> Lighting/Turn Signal Control Lever Guide for Suzuki Alto 4 Door Sixth Generation (2004-2008)

76G-74E

• Do not use the starter motor for

more than 15 seconds at a time. If

the engine does not start; wait 15

seconds before trying again. If the

engine does not start after several

attempts, check the fuel and ignition

systems or consult your MARUTI

SUZUKI dealer.

• Do not leave the ignition switch in

the “ON” position if the engine is

not running as the battery will

discharge.

LIGHTING/TURN SIGNAL

CONTROL LEVER

STEERING COLUMN CONTROLS

ACC

Accessories such as the radio can operate,

but the engine is off.

This is the normal operating position. All

electrical systems are on.

START

This is the position for starting the engine

using the starter motor. The key should be

released from this position as soon as the

engine starts.

• Never remove the ignition key while

the vehicle is moving. The steering

wheel will lock and you will not be

able to steer the vehicle.

• Do not leave children alone in a

parked vehicle. Unattended children

could cause accidental movement of

the vehicle, which could result in

severe personal injury.

• Always remove the key when parked

to prevent unintentional operation of

the vehicle and to improve security.

w WARNING

CAUTION

4-2

76G-04-00576G-04-004

ALTO

76G-04-005A

ALTO K10 TYPE-1

76G-74E

STEERING COLUMN CONTROLS

4-3

76G-04-005B

With the headlights on, push the lever

forward to switch to the high beams (main

beams) or pull the lever toward you to

switch to the low beams. When the high

beams (main beams) are on, a light on the

instrument panel will come on. To flash the

high beams (main beams) pull the lever

slightly towards you and release it.

76G-04-006

ALTO K10 TYPE-2

76G-04-006A

76G-04-006B

ALTO K10 TYPE-1

ALTO K10 TYPE-2

ALTO

This control lever is located on the outboard

side of the steering column. Operate the

lever as described below.

Lighting Operation

To turn the lights on or off, twist the knob

on the end of the lever. There are three

positions: in the “OFF” position all lights are

off; in the middle position the front parking

lights, tail-lights, registration plate light, and

instrument lights are on, but the headlights

are off; in the third position the headlights

come on in addition to the other lights.

76G-74E

STEERING COLUMN CONTROLS

Turn Signal Operation

With the ignition switch in the “ON” position,

move the lever up or down to activate the

left or right turn signals.

Normal Turn Signal

Move the lever clockwise until it clicks to

signal a right turn or anticlockwise to signal

a left turn. When the turn is completed, the

signal will cancel and the lever will return

to its normal position.

4-4

76G-04-00876G-04-007

76G-04-007A

76G-04-007B

ALTO K10 TYPE-1

ALTO K10 TYPE-2

ALTO ALTO

76G-04-008A

ALTO K10 TYPE-1

76G-74E

STEERING COLUMN CONTROLS

WINDSCREEN WIPER AND

WASHER LEVER

Windscreen Wipers

To turn the windscreen wipers on, move the

lever down to one of the three operating

positions. In the “INT” position, (if equipped)

the wipers operate intermittently. The “INT”

position is very convenient for driving in mist

or light rain. In the “LO” position the wipers

operate at a steady low speed. In the “HI”

position, the wipers operate at a steady high

speed. To turn off the wipers, move the

lever back to the “OFF” position.

4-5

HAZARD WARNING SWITCH

Push in the marked part of the hazard

warning switch to activate the hazard

warning lights. All four turn signal lights and

both turn signal indicators will flash

simultaneously. To turn off the lights, push

the switch once again.

Use the hazard warning lights to warn other

traffic during emergency parking or when

your vehicle could otherwise become a

traffic hazard.

76G-04-009 76G-04-010

76G-04-008B

ALTO K10 TYPE-2

Lane Change Signal

Some times, such as when changing lanes,

the steering wheel is not turned far enough

to cancel the turn signal. For convenience,

you can flash the turn signal by moving the

lever part way and holding it there. The

lever will return to its normal position when

you release it.

Steering Column Controls -> Lighting/Turn Signal Control Lever for Your Suzuki Alto 4 Door Sixth Generation (2004-2008)

Related Topics

Popular Owner Manuals

Latest Owner Manuals