2010-2015 Suzuki Swift 4 Door EMERGENCY SERVICE -> Flat Tire Repair Kit (if equipped) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

EMERGENCY SERVICE -> Flat Tire Repair Kit (if equipped) for Your Suzuki Swift 4 Door Second Generation (2010-2015)

EMERGENCY SERVICE  
WARNING  
Flat tire repair kit contents  
Flat Tire Repair Kit  
(if equipped)  
Flat tire repair kit sealant is harmful if  
swallowed, or it comes in contact  
with skin or eyes. If swallowed, do  
not induce vomiting. Give plenty of  
water (if possible charcoal slurry)  
and seek medical attention immedi-  
ately. If sealant gets in eyes, flush  
eyes with water and seek medical  
attention. Wash thoroughly after han-  
dling. Solution can be poisonous to  
animals. Keep out of the reach of  
children and animals.  
The flat tire repair kit is stowed in the 1st  
luggage under-box immediately under the  
trunk floorboard.  
(6)  
(5)  
Take a moment to read the attached  
instruction manual.  
(1)  
(2)  
(4)  
IMPORTANT  
The Flat Tire Repair Kit cannot be used  
in the following cases. Consult  
a
SUZUKI Dealer or a Roadside Assis-  
tance Service.  
(3)  
• Cuts or piercing in the tire tread  
larger than approx. 4 mm.  
NOTICE  
• Cuts in the tire side wall.  
57L81006  
• Tire damage caused by driving with  
considerably reduced tire pressure or  
even with deflated tire.  
Be sure to replace the sealant before  
expiry date indicated on the label of  
the sealant bottle. To purchase new  
sealant, see your SUZUKI dealer.  
(1) Air compressor  
(2) Sealant bottle  
(3) Speed restriction sticker  
(with sealant bottle)  
(4) Instruction manual  
(5) Air hose  
• The tire bead completely unseated  
outside of the rim.  
• The rim damaged.  
Small punctures in the tire tread,  
caused by a nail or a screw, can be  
sealed with the Flat Tire Repair Kit.  
Do not remove nails or screws from the  
tire during an emergency repair.  
(6) Filler hose  
8-6  
58MS0-14E  
EMERGENCY SERVICE  
sult a SUZUKI Dealer or a Roadside Assis-  
tance Service.  
How to Perform an Emergency  
Repair  
1) Place the vehicle on level, hard ground.  
Set the parking brake firmly and shift  
into “P” (Park) if your vehicle has a CVT,  
or shift into “R” (Reverse) if your vehicle  
has a manual transaxle.  
10 min. Max.  
NOTE:  
(4)  
If over inflated, deflate air by loosening the  
screw of the filler hose.  
required  
air pressure  
7) Switch off the compressor. Pull out the  
power plug from the accessory socket.  
8) Disconnect the filler hose of the sealant  
bottle from the tire valve.  
9) Push the release button on side and  
detach the sealant bottle.  
Turn on the hazard warning flasher if  
your vehicle is near traffic.  
Block the front and rear of the wheel  
diagonally opposite of the wheel being  
repaired.  
(2)  
(3)  
2) Take out the sealant bottle and the  
compressor.  
3) At the top of the compressor, open the  
lid that covers the socket for the sealant  
bottle, then fit the bottle into the socket.  
4) Unscrew the valve cap from the tire  
valve.  
5) Connect the filler hose of the sealant  
bottle to the tire valve.  
6) Connect the power plug of the com-  
pressor to the accessory socket. Start  
the engine. Switch on the compressor.  
Inflate the tire to the required air pres-  
sure.  
(1)  
57L81009  
(1) Tire valve  
(2) Filler hose  
(3) Compressor  
(4) Power plug  
NOTICE  
Do not operate the compressor for  
longer than 10 minutes. It can cause  
overheating of the compressor.  
(5)  
If the air pressure cannot be reached  
130 kPa (1.3 bar) within 7 minutes, lift the  
tire up using a jack and rotate the tire three  
times or more to spread the sealant over  
the entire tire. Then, inflate the tire again.  
58MST0802  
(5) Release button  
If the required air pressure still cannot be  
reached, the tire may be severely dam-  
aged. In this case, the Flat Tire Repair Kit  
cannot provide the necessary seal. Con-  
8-7  
58MS0-14E  
EMERGENCY SERVICE  
10)Affix the speed restriction label from the  
bottom of the sealant bottle in the  
driver’s field of view.  
11)Make a short drive immediately after  
inflating to the required air pressure.  
Drive carefully with a maximum speed  
of 80 km/h (50 mph).  
How to Use the Kit’s Compressor to  
Inflate a Tire  
WARNING  
Be sure to check the tire pressure  
and confirm the completion of the  
emergency repair after 10 minutes or  
5 km (3 mile) of running.  
1) Place the vehicle on level, hard ground.  
Set the parking brake firmly and shift  
into “P” (Park) if your vehicle has a CVT,  
or shift into “R” (Reverse) if your vehicle  
has a manual transaxle.  
2) Take out the compressor.  
3) Unscrew the valve cap from the tire  
valve.  
4) Connect the air hose of the compressor  
to the tire valve.  
5) Connect the power plug of the com-  
pressor to the accessory socket. Start  
the engine. Switch on the compressor.  
Inflate the tire to the required air pres-  
sure.  
12)Carry on driving carefully to the nearest  
SUZUKI Dealer or a tire repair shop.  
NOTICE  
Have the tire renewed at the nearest  
SUZUKI Dealer. When repair to reuse  
the sealed tire, consult a tire repair  
shop.  
The wheel can be reused after wiping  
sealant off completely with cloth in  
order not to rust, but the tire valve  
must be renewed.  
Dispose of the sealant bottle at a  
SUZUKI dealer or in accordance with  
your regional codes and practices.  
After using the sealant bottle, replace  
it with a new bottle from your SUZUKI  
dealer.  
WARNING  
Do not affix the speed restriction  
label to the air bag. Also do not affix  
it to the warning light indicator or to  
the speedometer.  
13)After 10 minutes or 5 km (3 mile) run-  
ning, check the tire pressure with the  
pressure gauge of the compressor. If  
the air pressure is indicated more than  
130 kPa (1.3 bar), the emergency  
repair is completed. But, if the air pres-  
sure is indicated less than the required  
air pressure, correct the tire pressure to  
the required air pressure. If the tire  
pressure has dropped below 130 kPa  
(1.3 bar), the Flat Tire Repair Kit cannot  
provide the necessary seal. Do not  
drive on and consult a SUZUKI Dealer  
or a Roadside Assistance Service.  
NOTICE  
Do not operate the compressor for  
longer than 10 minutes. It can cause  
overheating of the compressor.  
8-8  
58MS0-14E  

Related Topics

Popular Owner Manuals