Airconditioningsystem -> Automatic air conditioning system for Your Toyota 4 Runner SUV Third Generation (1996-2002)

’01 4Runner_U (L/O 0008)  
Automatic air conditioning system—  
—Controls  
1. Air Intake Selector  
2. Windshield Air Flow Button  
3. “A/C” Button  
4. Fan Speed Selector  
5. “OFF” Button  
6. “MODE” Button (air flow selector)  
7. Temperature Selector  
8. “AUTO” Button  
2001 4RUNNER (OM35768U)  
162  
’01 4Runner_U (L/O 0008)  
“AUTO” button  
Temperature selector  
For automatic operation of the air condi-  
tioning, press the “AUTO” button. An indi-  
cator light will illuminate to show that the  
automatic operation mode has been se-  
lected.  
Turn the knob to adjust the temperatu-  
re—to the right to warm, to the left to  
cool.  
“OFF” button  
Push the button to turn off the air condi-  
tioning system.  
In the automatic operation mode, the air  
conditioning selects the most suitable fan  
speed, air flow, air intake and on−off of  
the air conditioning according to the tem-  
perature.  
When you adjust the temperature selector  
button to maximum cooling,  
a
“MAX  
COLD” message will appear on the display  
and the air intake mode will be automati-  
cally changed to RECIRCULATE.  
Air flow selector, “MODE” button  
Press the button to select the vents used  
for air flow.  
You may use manual controls if you want  
to select your own settings.  
In automatic operation, you do not have  
to select the air flow unless you desire  
another air flow mode.  
To turn off the automatic operation, press  
the “OFF” button.  
1. Panel—Air flows mainly from the  
instrument panel vents.  
Fan speed selector  
Turn the knob to adjust the fan speed.  
2. Bi−level—Air flows from both the floor  
vents and the instrument panel vents.  
In automatic operation, you do not have  
to adjust the fan speed unless you desire  
another fan speed mode.  
3. Floor—Air flows mainly from the floor  
vents.  
It is recommended to close the lower  
vent. For details about it, see “Instru-  
ment panel vents” in this section.  
2001 4RUNNER (OM35768U)  
163  
’01 4Runner_U (L/O 0008)  
4. Floor/Windshield—Air  
flows  
mainly  
To turn off the air conditioning alone,  
press the “A/C” button once again.  
from the floor vents and windshield  
vents.  
When the “A/C” button is not pressed in,  
pressing another air flow button turns off  
the air conditioning.  
It is recommended to close the lower  
vent. For details about it, see “Instru-  
ment panel vents” in this section.  
For details about air flow selector settings,  
see the illustration after “A/C” button.  
For details about air flow selector settings,  
see the illustration after “A/C” button.  
For further information for removing frost  
and fog, see “Instrument panel vents” in  
this section.  
Windshield air flow button  
When this button is pressed, air flows  
mainly from the windshield vents and the  
FRESH mode is automatically set. This  
setting clears the front view more quickly.  
If you want to return the setting to RE-  
CIRCULATE mode, press the air intake  
selector button once again.  
Pressing the button once again returns the  
air flow mode to the last one used.  
Pressing the windshield air flow button  
turns on the defroster−linked air condition-  
ing. At this time, the “A/C” button indicator  
comes on regardless of whether or not the  
“A/C” button is pressed in. This is to  
clean up the front view more quickly.  
2001 4RUNNER (OM35768U)  
164  
’01 4Runner_U (L/O 0008)  
“A/C” button  
To turn on the air conditioning, press the  
“A/C” button. The “A/C” button indicator  
will come on. To turn the air conditioning  
off, press the button again.  
If the “A/C” button indicator flashes, there  
is a problem in the air conditioning system  
and the air conditioning automatically  
shuts off. If this happens, take your ve-  
hicle to a Toyota dealer for service.  
Air intake selector  
Press the button to select the air source.  
1. Recirculate—Recirculates the air inside  
the vehicle.  
2. Fresh—Draws outside air into the sys-  
tem.  
If the engine coolant temperature becomes  
extremely high, RECIRCULATE mode will  
automatically be selected. This is not a  
malfunction. When the engine coolant tem-  
perature is lowered, the previous mode  
will resume.  
To prevent fogging up of the windshield,  
the air intake mode may change automati-  
cally to FRESH depending on the condi-  
tion of the air conditioning system.  
2001 4RUNNER (OM35768U)  
165  
’01 4Runner_U (L/O 0008)  
—Air flow selector settings  
—Operating tips  
D To cool off your Toyota after it has  
been parked in the hot sun, drive with  
the windows open for a few minutes.  
This vents the hot air, allowing the air  
conditioning to cool the interior more  
quickly.  
D Make sure the air intake grilles in front  
of the windshield are not blocked (by  
leaves or snow, for example).  
D On humid days, do not blow cold air  
on the windshield. The windshield could  
fog up because of the difference in air  
temperature on the inside and outside  
of the windshield.  
D Keep the area under the front seats  
clear to allow air to circulate through-  
out the vehicle.  
D On cold days, push the fan speed se-  
lector to adjust the fan speed high for  
a minute to help clear the intake ducts  
of snow or moisture. This can reduce  
the amount of fogging on the windows.  
D When driving on dusty roads, close all  
windows. If dust thrown up by the ve-  
hicle is still drawn into the vehicle after  
closing the windows, it is recommended  
that the air intake selector be set to  
FRESH and the fan speed to any set-  
ting except “OFF”.  
: See “Instrument panel vents” in this section.  
2001 4RUNNER (OM35768U)  
166  
’01 4Runner_U (L/O 0008)  
D If following another vehicle on a dusty  
road, or driving in windy and dusty  
conditions, it is recommended that the  
air intake selector be temporarily set to  
RECIRCULATE, which will close off the  
outside passage and prevent outside  
air and dust from entering the vehicle  
interior.  
Heating  
Air conditioning  
For best results, set controls to:  
—For automatic operation  
For best results, set controls to:  
—For automatic operation  
Press in the AUTObutton.  
Temperature—To the desired  
temperature  
Press in the AUTObutton.  
Temperature—To the desired  
temperature  
Air conditioning—OFF  
Air conditioning—ON  
—For manual operation  
—For manual operation  
Fan speed—To the desired fan speed  
Temperature—Towards WARM  
(to the right)  
Fan speed—To the desired fan speed  
Temperature—Towards COLD  
(to the left)  
Air intake—FRESH (outside air)  
Air flow—FLOOR  
Lower vent—CLOSED  
Air intake—FRESH (outside air)  
Air flow—PANEL  
Air conditioning—ON  
Air conditioning—OFF  
D For quick cooling, select recirculated  
air for a few minutes.  
D For quick heating, select recirculated  
air for  
a
few minutes. To keep the  
windows from fogging, select fresh af-  
ter the vehicle interior has been  
warmed.  
D Press the “A/C” button on for dehumidi-  
fied heating.  
D Choose floor/windshield air flow to heat  
the vehicle interior while defrosting or  
defogging the windshield.  
2001 4RUNNER (OM35768U)  
167  
’01 4Runner_U (L/O 0008)  
Ventilation  
Defogging and defrosting  
—The inside of the windshield  
For best results, set controls to:  
For automatic operation—  
Pressing the windshield air flow button  
turns on the defroster−linked air condition-  
ing. At this time, the “A/C” button indicator  
comes on regardless of whether or not the  
“A/C” button is pressed in. This is to  
clean up the front view more quickly.  
For best results, set controls to:  
—For automatic operation  
Press in the AUTObutton.  
Temperature—Towards COLD  
(to the left)  
Temperature—Towards WARM  
(to the right) to heat;  
COLD (to the left)  
To turn off the air conditioning alone,  
press the “A/C” button once again.  
Air conditioning—OFF  
to cool  
When the “A/C” button is not pressed in,  
pressing another air flow button turns off  
the air conditioning.  
—For manual operation  
Air intake—FRESH (outside air)  
Air flow—WINDSHIELD  
Lower vent—CLOSED  
Fan speed—To the desired fan speed  
Temperature—Towards COLD  
(to the left)  
Air intake—FRESH (outside air)  
Air flow—PANEL  
Air conditioning—OFF  
D On humid days, do not blow cold air  
on the windshield—the difference be-  
tween the outside and inside tempera-  
tures could make the fogging worse.  
For manual operation—  
Fan speed—To the desired fan speed  
Temperature—Towards WARM  
(to the right) to heat;  
COLD (to the left)  
to cool  
Air intake—FRESH (outside air)  
Air flow—WINDSHIELD  
Lower vent—CLOSED  
When pressing the windshield air flow but-  
ton, the air intake selects FRESH auto-  
matically. This is to clean up the front  
view more quickly.  
If you want to return the setting to RE-  
CIRCULATE mode, press the air intake  
selector button once again.  
2001 4RUNNER (OM35768U)  
168