’01 4Runner_U (L/O 0008)
Replacing light bulbs—
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
Bulb
No.
Light bulbs
Headlights
W
Type
—
—
60/55
55
A
B
in a car wash. This is not
a
problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogged up in the rain. However,
if there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact your
Toyota dealer.
Front fog lights
Parking and front
side marker lights
—
—
—
5
C
C
D
CAUTION
Front turn signal
lights
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if scratched
or dropped. Hold a bulb only by its
plastic or metal case. Do not touch
the glass part of a bulb with bare
hands.
21
21
Rear turn signal
lights
Stop/tail lights
—
—
—
21/5
18
5
C
C
C
Back−up lights
License plate light
High mounted
stoplight
NOTICE
921
18
C
Only use a bulb of the listed type.
Interior light
—
—
—
8
8
E
E
C
Personal lights
Glove box light
1.4
Luggage
compartment light
—
8
E
A: HB2 halogen bulbs
B: H3 halogen bulbs
C: Wedge base bulbs (clear)
D: Wedge base bulbs (amber)
E: Double end bulbs
2001 4RUNNER (OM35768U)
262
English 