Air conditioning system -> Manual air conditioning system for Your Toyota Avalon 4 Door Second Generation (2000-2004)

’03 AVALON U (L/O 0206)  
Manual air conditioning system—  
—Controls  
1. Temperature selector  
(mainly for driver and secondarily for  
front passenger)  
2. Air intake selector  
3. “A/C” button  
4. Temperature selector  
(mainly for front passenger and  
secondarily for driver)  
5. Air flow selector  
6. Fan speed selector  
2003 AVALON (OM41401U)  
168  
’03 AVALON U (L/O 0206)  
Fan speed selector  
D There are cases where one or both of  
the airflow temperatures may not accu-  
rately correlate with the set tempera-  
ture according to circumstances, when  
the airflow temperature settings on the  
left and right are substantially different.  
For example, if the left controller is set  
at central or neutral temperature while  
the right one is set at maximum heat-  
ing or maximum cooling, or vice versa.  
If this situation occurs, use the fine  
tune operation to adjust the air temper-  
ature on each side.  
Turn the knob to adjust the fan speed—to  
the right to increase, to the left to de-  
crease.  
Temperature selector  
Turn the knob to adjust the temperature—  
to the right to warm, to the left to cool.  
Knowledge for the two−temperature se-  
lector operation  
This air conditioning system has two inde-  
pendent temperature selectors: left and  
right (for the use of driver and front pas-  
senger respectively).  
Air flow selector  
D There are cases where the temperature  
of the airflow may not accurately corre-  
late on the driver and front passenger  
side according to circumstances, even  
if the left and right temperature selec-  
tors are set at the same temperature.  
If this situation occurs, use the fine  
tune operation to adjust the air temper-  
ature on one side.  
Turn the knob to select the vents used for  
air flow.  
1. Panel—Air flows mainly from the  
instrument panel vents.  
2. Bi−level—Air flows from both the floor  
vents and the instrument panel vents.  
When you set the temperature selector  
setting at about the center, warm air  
flows out of the floor vents and rela-  
tively low−temperature air flows out of  
the center and side vents.  
Note: This manual dual temperature se-  
lectors should generally only be used  
as independent temperature settings for  
the left and right.  
3. Floor—Air flows mainly from the floor  
vents.  
2003 AVALON (OM41401U)  
169  
’03 AVALON U (L/O 0206)  
4. Floor/Windshield—Air  
flows  
mainly  
Press the “A/C” button for dehumidified  
heating or cooling. This setting clears  
the front view more quickly.  
from the floor vents and windshield  
vents.  
Turning the air flow selector to the  
floor/windshield position turns on the  
defogging function with the purpose of  
clearing the front view.  
For details about air flow selector settings,  
see “—Air flow selector settings” de-  
scribed below.  
This position allows the air intake to  
select FRESH automatically. This is to  
clean up the front view more quickly.  
If you want to return the setting to  
RECIRCULATE mode, press the air in-  
take selector button once again.  
Air intake selector  
Press the “A/C” button for dehumidified  
heating or cooling. This setting clears  
the front view more quickly.  
Press the button to select the air source.  
An indicator light will illuminate to show  
which air intake mode is being selected.  
5. Windshield—Air flows mainly from the  
windshield vents.  
1. Recirculate—Recirculates the air inside  
the vehicle.  
Turning the air flow selector to the  
windshield position turns on the defog-  
ging function with the purpose of clear-  
ing the front view.  
2. Fresh—Draws outside air into the sys-  
tem.  
To prevent fogging up of the windshield,  
the air intake mode may change automati-  
cally to FRESH depending on the condi-  
tion of the air conditioning system.  
This position allows the air intake to  
select FRESH automatically. This is to  
clean up the front view more quickly.  
If you want to return the setting to  
RECIRCULATE mode, press the air in-  
take selector button once again.  
2003 AVALON (OM41401U)  
170  
’03 AVALON U (L/O 0206)  
“A/C” button  
To turn on the air conditioning, press the  
“A/C” button. The “A/C” button indicator  
will come on. To turn the air conditioning  
off, press the button again.  
If the “A/C” button indicator flashes, there  
is a problem in the air conditioning system  
and the air conditioning automatically  
shuts off. If this happens, take your ve-  
hicle to your Toyota dealer for service.  
2003 AVALON (OM41401U)  
171  
’03 AVALON U (L/O 0206)  
—Air flow selector settings  
—Operating tips  
D To cool off your Toyota after it has  
been parked in the hot sun, drive with  
the windows open for a few minutes.  
This vents the hot air, allowing the air  
conditioning to cool the interior more  
quickly.  
D Make sure the air intake grilles in front  
of the windshield are not blocked (by  
leaves or snow, for example).  
D On humid days, do not blow cold air  
on the windshield. The windshield could  
fog up because of the difference in air  
temperature on the inside and outside  
of the windshield.  
D Keep the area under the front seats  
clear to allow air to circulate through-  
out the vehicle.  
D On cold days, set the fan speed to  
high for  
a
minute to help clear the  
intake ducts of snow or moisture. This  
can reduce the amount of fogging on  
the windows.  
D When driving on dusty roads, close all  
windows. If dust thrown up by the ve-  
hicle is still drawn into the vehicle after  
closing the windows, it is recommended  
that the air intake selector be set to  
FRESH and the fan speed selector to  
any setting except “OFF”.  
On some models  
2003 AVALON (OM41401U)  
172  
’03 AVALON U (L/O 0206)  
D If following another vehicle on a dusty  
road, or driving in windy and dusty  
conditions, it is recommended that the  
air intake selector be temporarily set to  
RECIRCULATE, which will close off the  
outside passage and prevent outside  
air and dust from entering the vehicle  
interior.  
Heating  
Air conditioning  
For best results, set controls to:  
For best results, set controls to:  
Fan speed—Any setting except “OFF”  
Temperature—Towards WARM  
(red zone)  
Air intake—FRESH (outside air)  
Air flow—FLOOR  
Air conditioning—OFF  
Fan speed—Any setting except “OFF”  
Temperature—Towards COLD  
(blue zone)  
Air intake—FRESH (outside air)  
Air flow—PANEL  
Air conditioning—ON  
D For quick heating, select recirculated  
D For quick cooling, select recirculated  
air for a few minutes.  
air for  
a
few minutes. To keep the  
windows from fogging, select fresh af-  
ter the vehicle interior has been  
warmed.  
Ventilation  
For best results, set controls to:  
D Press the “A/C” button on for dehumidi-  
fied heating.  
Fan speed—Any setting except “OFF”  
Temperature—Towards COLD  
(blue zone)  
Air intake—FRESH (outside air)  
Air flow—PANEL  
Air conditioning—OFF  
D Choose floor/windshield air flow to heat  
the vehicle interior while defrosting or  
defogging the windshield.  
2003 AVALON (OM41401U)  
173  
’03 AVALON U (L/O 0206)  
Defogging  
Defrosting  
The inside of the windshield  
For best results, set controls to:  
The outside of the windshield  
For best results, set controls to:  
Fan speed—Any setting except “OFF”  
Temperature—Towards WARM  
(red zone) to heat;  
Fan speed—Any setting except “OFF”  
Temperature—Towards WARM  
(red zone)  
COLD (blue zone) to  
cool  
Air intake—FRESH (outside air)  
Air flow—WINDSHIELD  
Air intake—FRESH (outside air)  
Air flow—WINDSHIELD  
Turning the air flow selector to the wind-  
shield or floor/windshield position turns on  
the defrosting function with the purpose of  
clearing the front view.  
Turning the air flow selector to the wind-  
shield or floor/windshield position turns on  
the defogging function with the purpose of  
clearing the front view.  
When turning the air flow selector to wind-  
shield or floor/windshield position, the air  
intake selects FRESH automatically. This  
is to clean up the front view more quickly.  
When turning the air flow selector to wind-  
shield or floor/windshield position, the air  
intake selects FRESH automatically. This  
is to clean up the front view more quickly.  
If you want to return the setting to  
RECIRCULATE mode, press the air intake  
selector button once again.  
If you want to return the setting to  
RECIRCULATE mode, press the air intake  
selector button once again.  
Press the “A/C” button for dehumidified  
heating or cooling. This setting clears the  
front view more quickly.  
Press the “A/C” button for dehumidified  
heating or cooling. This setting clears the  
front view more quickly.  
D To heat the vehicle interior while de-  
frosting  
floor/windshield air flow.  
the  
windshield,  
choose  
D On humid days, do not blow cold air  
on the windshield—the difference be-  
tween the outside and inside tempera-  
tures could make the fogging worse.  
2003 AVALON (OM41401U)  
174