Engine and Chassis -> Checking the engine oil level for Your Toyota Avalon 4 Door Second Generation (2000-2004)

’03 AVALON U (L/O 0206)  
Checking the engine oil level  
NOTICE  
CAUTION  
Low level  
Full level  
z Be careful not to spill the engine  
oil on the vehicle components.  
Be careful not to touch the hot ex-  
haust manifold.  
z Avoid overfilling, or the engine  
could be damaged.  
NOTICE  
z Check the oil level on the dipstick  
once again after adding the oil.  
Be careful not to drop the engine oil  
on the vehicle components.  
Add oil  
O.K.  
Too full  
If the oil level is below or only slightly  
above the low level, add engine oil of  
the same type as already in the engine.  
With the engine at operating tempera-  
ture and turned off, check the oil level  
on the dipstick.  
Remove the oil filler cap and add engine  
oil in small quantities at a time, checking  
the dipstick. We recommend that you use  
a funnel when adding oil.  
1. To get  
a
true reading, the vehicle  
should be on a level spot. After turning  
off the engine, wait a few minutes for  
the oil to drain back into the bottom of  
the engine.  
The approximate quantity of oil needed to  
fill between the low level and the full level  
on the dipstick is indicated below for ref-  
erence.  
2. Pull the dipstick out, hold a rag under  
the end and wipe it clean.  
When the level reaches within the correct  
range, install the filler cap hand−tight.  
3. Reinsert the dipstick—push it in as far  
as it will go, or the reading will not be  
correct.  
Oil quantity, L (qt., Imp. qt.):  
1.5 (1.6, 1.3)  
4. Pull the dipstick out and look at the oil  
level while holding  
end.  
a
rag under the  
2003 AVALON (OM41401U)  
276  
’03 AVALON U (L/O 0206)  
ENGINE OIL SELECTION  
SAE 5W−30 is the best choice for good  
fuel economy and good starting in cold  
weather.  
Toyota Genuine Motor Oil” is filled in  
your Toyota vehicle. Use Toyota approved  
Toyota Genuine Motor Oil” or equivalent  
to satisfy the following grade and  
viscosity.  
If SAE 5W−30 is not available, SAE  
10W−30 may be used. However, it  
should be replaced with SAE 5W−30 at  
the next oil change.  
Oil grade:  
API grade SL “Energy−Conserving” or  
ILSAC multigrade engine oil  
Recommended viscosity:  
SAE 5W−30  
API service symbol  
Outside temperature  
ILSAC certification mark  
2003 AVALON (OM41401U)  
277