Lights, Wipers and Defogger -> Windshield wipers and washer for Your Toyota Avalon 4 Door Second Generation (2000-2004)

’03 AVALON U (L/O 0206)  
Windshield wipers and washer  
(intermittent operation type)  
Windshield wipers and washer  
(raindrop detection type)  
The “INT TIME” band lets you adjust the  
wiping time interval when the wiper lever  
is in the intermittent position (position 1).  
Twist the band upward to increase the  
time between sweeps, and downward to  
decrease it.  
Automatic control adjuster  
To squirt washer fluid, pull the lever  
toward you (position 4).  
If the windshield wipers are off, they will  
operate a couple of times after the washer  
squirts.  
For instructions on adding washer fluid,  
see “Adding washer fluid” in Section 7−3.  
To turn on the windshield wipers, move  
the lever to the desired setting.  
To turn on the windshield wipers, move  
the lever to the desired setting.  
In freezing weather, warm the windshield  
with the defroster before using the washer.  
This will help prevent the washer fluid  
from freezing on your windshield, which  
can block your vision.  
The key must be in the “ON” position.  
The key must be in the “ON” position.  
Lever position  
Position 1  
Operation  
Lever position  
Position 1  
Operation  
Intermittent  
operation  
Automatic  
operation  
NOTICE  
Do not operate the wipers if the wind-  
shield is dry. It may scratch the glass  
or may damage wiper blades.  
Low speed  
operation  
Low speed  
operation  
Position 2  
Position 2  
High speed  
operation  
High speed  
operation  
Position 3  
Position 4  
Position 3  
Position 4  
Washer on  
Washer on  
2003 AVALON (OM41401U)  
107  
’03 AVALON U (L/O 0206)  
Even if the wiper lever is in the position  
1, the system will switch to intermittent  
operations in the following conditions:  
CAUTION  
Be careful not to get your fingers  
caught between the wipers and wind-  
shield.  
D When the windshield gets extremely  
cold (at less than −10_C or 14_F)  
D When the system malfunctions  
When the wiper lever is in the posi-  
tion 1 with the ignition switch on, the  
wipers could operate automatically in  
the following cases:  
However, when the windshield gets ex-  
tremely hot (at more than 90_C or 194_F),  
the wipers do not operate even if the  
wiper lever is in the position 1.  
D If you touch the upper center of the  
windshield adjacent to the sensor.  
When the ignition switch is turned off with  
the wiper lever in the position 1, and then  
the ignition switch is turned on again, the  
automatic operation may not work even if  
raindrops are on the windshield.  
D If you wipe the upper center of the  
windshield (adjacent to which the  
sensor is located) with a towel or  
other object.  
Automatic operation (position 1)  
The wiper speed is determined by the  
amount of raindrops and sunlight detected  
by the automatic wiper control sensor.  
In this case, move the lever to another  
position and return it to the position 1  
again.  
D If the windshield vibrates.  
D If you touch the sensor.  
The automatic wiper control sensor is on  
the inside of the windshield as shown  
above.  
NOTICE  
If you feel that the operation of the auto-  
matic wiper control is too fast or too slow,  
twist the automatic control adjuster in the  
“−” direction to lower sensitivity, and “+”  
direction to boost the sensitivity.  
Do not apply detergent to or wet the  
automatic wiper control sensor when  
cleaning the inside of the windshield.  
2003 AVALON (OM41401U)  
108  
’03 AVALON U (L/O 0206)  
Shifting the windshield wiper  
position  
To squirt washer fluid, pull the lever  
toward you (position 4).  
If the windshield wipers are off, they will  
operate a couple of times after the washer  
squirts.  
For instructions on adding washer fluid,  
see “Adding washer fluid” in Section 7−3.  
In freezing weather, warm the windshield  
with the defroster before using the washer.  
This will help prevent the washer fluid  
from freezing on your windshield, which  
can block your vision.  
NOTICE  
The wiper blades retract under the hood  
when the wipers are turned off.  
SHIFTING TO THE REST POSITION  
Hold the connection of the wiper arm  
and wiper blade and pull it upward for  
more than 10 cm (3.9 in.) along the  
windshield glass with the force of  
about 98 N (10 kgf, 22 lbf).  
Do not operate the wipers if the wind-  
shield is dry. It may scratch the glass  
or may damage wiper blades.  
In the following cases, the wipers should  
be shifted from the retracted position  
(position 2) to the rest position (position  
1) above the hood level.  
D When cleaning the windshield  
NOTICE  
D When inspecting or replacing the wip-  
ers  
To prevent the wiper blades from be-  
ing deformed, be sure to hold the  
connection of the wiper arm and wip-  
er blade securely.  
D When the retraction may be obstructed  
by snow, etc., at the bottom of the  
windshield  
Other than the above cases, keep the  
wipers in the retracted position.  
2003 AVALON (OM41401U)  
109