’03 AVALON U (L/O 0206)
Driving position memory
system
The micro computer can memorize the
position of the driver’s seat and outside
rear view mirror. Two different driving
position profiles can be entered into
computer’s memory.
CAUTION
To reduce the risk of sliding under
the lap belt during a collision, avoid
reclining the seatback any more than
needed. The seat belts provide maxi-
mum protection in a frontal or rear
collision when the driver and the pas-
senger are sitting up straight and
well back in the seats. If you are
reclined, the lap belt may slide past
your hips and apply restraint forces
directly to the abdomen. In the event
of a frontal collision, the more the
seat is reclined, the greater the risk
of personal injury.
Recording
a
driving position in the
computer’s memory can only be done
when the ignition key is in the “ON”
position and the automatic transmission
selector lever is in the “P” position.
SETTING THE DRIVING POSITION
1. Adjust the driver’s seat and outside
rear view mirror to the desired posi-
tion.
3. SEAT
LUMBAR
ADJUSTING SWITCH
SUPPORT
2. While pushing the “SET” button,
push button “1” or “2” until the sig-
nal beeps.
Push the switch on either side.
The amount of lumbar support will change
while the switch is pushed.
The beep sound means that the positions
are recorded in the computer’s memory.
By repeating these two steps and pressing
the remaining button, the driving position
for another driver can be recorded.
To set a new memorized position, select
the desired position and perform step 2.
The previous memory will be erased and
a new position will be set.
2003 AVALON (OM41401U)
45
English 