Get Vehicle specifications Guide for Toyota Aygo SUV First Generation (2005-2014)

Vehicle specifications

6

6-1. Specifications

Maintenance data

(fuel, oil level, etc.).......... 346

Fuel information................ 357

345

6-1. Specifications

Maintenance data (fuel, oil level, etc.)

Dimensions and weights

Overall length

Overall width

Overall height*¹

Wheelbase

3430 mm (135.0 in.)

1615 mm (63.6 in.)

1465 mm (57.7 in.)

2340 mm (92.1 in.)

1420 mm (55.9 in.)

1410 mm (55.5 in.)

Front

Rear

Tread

^{1180 kg (2601 lb.)}*²

Gross vehicle mass

1190 kg (2623 lb.)*³

Front

Rear

695 kg (1532 lb.)

Maximum permissi-

ble axle capacity

695 kg (1532 lb.)

*¹: Unladen vehicles

*²: 3-door models

*³: 5-door models

Vehicle identification

 Vehicle identification number

The vehicle identification number (VIN) is the legal identifier for

your vehicle. This is the primary identification number for your

Toyota. It is used in registering the ownership of your vehicle.

This number is stamped under

the right-hand front seat.

346

6-1. Specifications

3-door models

5-door models

 Engine number

This number is also on the man-

ufacturer’s label on the right-

hand side center pillar.

This number is also on the man-

ufacturer’s label on the right-

hand side rear pillar.

The engine number is stamped

on the engine block as shown.

6

347

6-1. Specifications

Engine

Model

Type

1KR-FE

3-cylinder in line, 4-cycle, gasoline

71.0  84.0 mm (2.79  3.30 in.)

998 cm³(60.9 cu.in.)

Bore and stroke

Displacement

Valve clearance

(engine cold)

Intake: 0.145 0.235 mm (0.006 0.009 in.)

Exhaust: 0.275 0.365 mm (0.011 0.014 in.)

9.0 11.0 mm (0.35 ^{0.43 in.)}*

Vehicles without an air conditioning system:

Generator

Water pump

Crankshaft

Drive belt tension

Vehicles with an air conditioning system:

Generator

Water pump

Crankshaft

Air

conditioning

compressor

*: Drive belt deflection with 98 N (10 kgf, 22 lbf) thumb force (used belt)

348

6-1. Specifications

Fuel

EU area:

Unleaded gasoline conforming to European stan-

dard EN228 only

Fuel type

Except EU area:

Unleaded gasoline only

Research octane num-

ber

95 or higher

Fuel tank capacity

(Reference)

35 L (9.2 gal., 7.7 Imp.gal.)

Lubrication system

Oil capacity

(Drain and refill

 ^reference*)

With filter

3.3 L (3.5 qt., 2.9 Imp.qt.)

3.1 L (3.3 qt., 2.7 Imp.qt.)

Without filter

*: The engine oil capacity is a reference quantity to be used when changing the

engine oil. Warm up and turn off the engine, wait more than 5 minutes, and

check the oil level on the dipstick.

6

349

6-1. Specifications

 Engine oil selection

“Toyota Genuine Motor Oil” is used in your Toyota vehicle. Toyota rec-

ommends the use of approved “Toyota Genuine Motor Oil”. Another

motor oil of matching quality can also be used.

Oil grade:

0W-20, 5W-20, 5W-30 and 10W-30:

API grade SL “Energy-Conserving”, SM “Energy-Conserving”, SN

“Resource-Conserving” or ILSAC multigrade engine oil

15W-40 and 20W-50:

API grade SL, SM or SN multigrade engine oil

Recommended viscosity (SAE):

SAE 0W-20 is filled into your

Toyota vehicle at manufacturing,

Preferred

and better choice for good fuel

economy and good starting in

cold weather.

If SAE 0W-20 oil is not available,

SAE 5W-30 oil may be used.

However, it should be replaced

with SAE 0W-20 at the next oil

Temperature range anticipated before

next oil change.

change.

If you use SAE 10W-30 or a

higher viscosity engine oil in

extremely low temperatures, the

engine may become difficult to

start, so SAE 5W-30 or lower vis-

cosity engine oil is recom-

mended.

350

6-1. Specifications

Oil viscosity (0W-20 is explained here as an example):

• The 0W in 0W-20 indicates the characteristic of the oil which allows

cold startability. Oils with a lower value before the W allow for easier

starting of the engine in cold weather.

• The 20 in 0W-20 indicates the viscosity characteristic of the oil when

the oil is at high temperature. An oil with a higher viscosity (one with a

higher value) may be better suited if the vehicle is operated at high

speeds, or under extreme load conditions.

How to read oil container labels:

Either or both API registered marks are added to some oil containers

to help you select the oil you should use.

API Service Symbol

Top portion: The oil quality

designation by API (American

Petroleum Institute) (SN)

Center portion: The SAE viscosity

grade (SAE 0W-20)

Lower

Conserving” means that the oil

has fuel saving and

protection

portion:

“Resource-

environmental

capabilities.

ILSAC Certification Mark

6

The

ILSAC

(International

Lubricant Standardization and

Approval Committee) Certification

Mark is displayed on the front of

the container.

351

6-1. Specifications

Cooling system

^0Q07*:

4.4 L (4.6 qt., 3.9 Imp.qt.)

^{0Q01, 0Q02}*:

Capacity (Reference)

4.0 L (4.2 qt., 3.5 lmp.qt.)

Use either of the following:

• “Toyota Super Long Life Coolant”

• A similar high-quality ethylene glycol-based non-

silicate, non-amine, non-nitrite, and non-borate

coolant with long-life hybrid organic acid technol-

ogy

Coolant type

Do not use plain water alone.

*: The identification code are stamped on the locations shown in the below

illustration.

On the back side

352

6-1. Specifications

Ignition system

Spark plug

Make

Gap

DENSO SK16HR11

1.1 mm (0.043 in.)

NOTICE

Iridium-tipped spark plugs

Use only iridium-tipped spark plugs. Do not adjust the spark plug gap.

Electrical system

Battery

Open voltage* at

12.6 12.8 V Fully charged

12.2 12.4 V Half charged

11.8 12.0 V Discharged

⁽*: Voltage checked 20 minutes after

the engine and all the lights are

turned off)

20C (68F):

Charging rates

5 A max.

Manual transmission

6

Gear oil capacity (Reference)

1.7 L (1.8 qt., 1.5 Imp.qt.)

Use either of the following:

• “TOYOTA Genuine Manual Transmission

Gear Oil LV”

Gear oil type

• Other gear oil that meets API GL-4 and

SAE 75W specifications

353

6-1. Specifications

NOTICE

Manual transmission gear oil

Please be aware that depending on the particular characteristics of the gear

oil used or the operating conditions, idle sound, shift feeling and/or fuel effi-

ciency may be different or affected. Toyota recommends to use “TOYOTA

Genuine Manual Transmission Gear Oil LV” to achieve optimal performance.

Clutch

Pedal free play

18  28 mm (0.7  1.1 in.)

Brakes

Left-hand drive vehicles:

84 mm (3.3 in.)

Right-hand drive vehicles:

77 mm (3.0 in.)

Pedal clearance*¹

Pedal free play

1  6 mm (0.04  0.24 in.)

5  8 clicks

Parking brake lever travel *²

Fluid type

SAE J1704 or FMVSS No.116 DOT 4

*¹: Minimum pedal clearance when depressed with a force of 490 N (50 kgf,

110 lbf) while the engine is running

*²: Parking brake lever travel when pulled up with a force of 196 N (20 kgf, 44

lbf)

Steering

Free play

Less than 30 mm (1.2 in.)

354

6-1. Specifications

Tires and wheels

Tire size

155/65R14 75T

Vehicle speed

Front wheel

Rear wheel

kPa (kgf/cm²or kPa (kgf/cm²or

bar, psi)

Tire inflation pressure

(Recommended cold

tire inflation pressure)

More than 160

km/h (100 mph)

230 (2.3, 34)

160 km/h (100

mph) or less

220 (2.2, 32)

Wheel size

14  4 1/2J

Wheel bolt torque

103 N·m (10.5 kgf·m, 76 ft·lbf)

6

355

6-1. Specifications

Light bulbs

Light Bulbs

W

60/55

21

5

Type

A

Headlights

Front turn signal lights

Front position lights

Front fog lights (if equipped)

Side turn signal lights

Rear turn signal lights

Stop/tail lights

D

E

55

5

B

—

C

Exterior

21

21/5

5

C

License plate lights

Back-up lights

E

21

5

C

Rear fog lights

C

High mounted stoplight

Interior light

E

Interior

5

E

A: H4 halogen bulbs

B: H11 halogen bulbs

C: Single end bulbs (clear)

D: Single end bulbs (amber)

E: Wedge base bulbs (clear)

356

6-1. Specifications

Fuel information

EU area:

Your vehicle must use only unleaded gasoline conforming to

European standard EN228. For optimum engine performance,

select unleaded gasoline with a Research Octane Number of

95 or higher.

Except EU area:

Your vehicle must use only unleaded gasoline. For optimum

engine performance, select unleaded gasoline with a

Research Octane Number of 95 or higher.

Fuel tank opening for unleaded gasoline

To help prevent incorrect fueling, your vehicle has a fuel tank opening that

only accommodates the special nozzle on unleaded fuel pumps.

If your engine knocks

 Consult any authorized Toyota dealer or repairer, or another duly quali-

fied and equipped professional.

 You may occasionally notice light knocking for a short time while acceler-

ating or driving uphill. This is normal and there is no need for concern.

6

357

6-1. Specifications

NOTICE

Notice on fuel quality

 Do not use improper fuels. If improper fuels are used, the engine will be

damaged.

 Do not use leaded gasoline.

Leaded gasoline will cause the three-way catalytic converter to lose its

effectiveness and the emission control system to function improperly.

 Gasoline engine (EU area): Bioethanol fuel sold under names such as

“E50” or “E85” and fuel containing a large amount of ethanol should not be

used. The use of these fuels will damage the vehicle’s fuel system. In case

of any doubt, ask any authorized Toyota dealer or repairer, or another duly

qualified and equipped professional.

 Gasoline engine (except EU area): Bioethanol fuel sold under names such

as “E50” or “E85” and fuel containing a large amount of ethanol should not

be used. Your vehicle can use gasoline mixed with 10% max ethanol. The

use of fuel with more than 10% ethanol content (E10) will damage the

vehicle’s fuel system. You must ensure that refueling is carried out only

from a source where fuel specification and quality can be guaranteed. In

case of any doubt, ask any authorized Toyota dealer or repairer, or another

duly qualified and equipped professional.

358

Vehicle specifications for Your Toyota Aygo SUV First Generation (2005-2014)

Related Topics

Popular Owner Manuals

Latest Owner Manuals