Occupant Restraint Systems -> Seat belts for Your Toyota Celica 2 Door Seventh Generation (2000-2006)

’04MY CELICA U (L/O 0308)  
Seat belts—  
—Seat belt precautions  
Toyota strongly urges that the driver and  
passengers in the vehicle be properly re-  
strained at all times with the seat belts  
provided. Failure to do so could increase  
the chance of injury and/or the severity of  
injury in accidents.  
Do not allow any children to stand up or  
CAUTION  
kneel on either rear or front seats. An  
unrestrained child could suffer serious in-  
jury or death during emergency braking or  
a collision. Also, do not let the child sit  
on your lap. Holding a child in your arms  
does not provide sufficient restraint.  
Persons should ride in their seats  
properly wearing their seat belts  
whenever the vehicle is moving.  
Otherwise, they are much more likely  
to suffer serious bodily injury or  
death in the event of sudden braking  
or a collision.  
The seat belts provided for your vehicle  
are designed for people of adult size,  
large enough to properly wear them.  
Pregnant woman. Toyota recommends the  
use of a seat belt. Ask your doctor for  
specific recommendations. The lap belt  
should be worn securely and as low as  
possible over the hips and not on the  
waist.  
Child. Use a child restraint system ap-  
propriate for the child until the child be-  
comes large enough to properly wear the  
vehicle’s seat belts. See “Child restraint”  
in this Section for details.  
When using the seat belts, observe  
the following:  
D Use the belt for only one person at  
a time. Do not use a single belt for  
two or more people—even children.  
Injured person. Toyota recommends the  
use of a seat belt. Depending on the inju-  
ry, first check with your doctor for specific  
recommendations.  
If a child is too large for a child restraint  
system, the child should sit in the rear  
seat and must be restrained using the  
vehicle’s seat belt. According to accident  
statistics, the child is safer when properly  
restrained in the rear seat than in the  
front seat.  
D To reduce the risk of sliding under  
the lap belt during  
avoid reclining the seatback any  
more than needed. The seat belts  
a
collision,  
provide maximum protection in  
a
frontal or rear collision when the  
driver and the front passenger are  
sitting up straight and well back in  
the seats. If you are reclined, the  
lap belt may slide past your hips  
and apply restraint forces directly  
to the abdomen. In the event of a  
frontal collision, the more the seat  
is reclined, the greater the risk of  
personal injury.  
If a child must sit in the front seat, the  
seat belts should be worn properly. If an  
accident occurs and the seat belts are not  
worn properly, the force of the rapid infla-  
tion of the airbag may cause death or  
serious injury to the child.  
29  
2004 CELICA from Aug. ’03 Prod. (OM20823U)  
’04MY CELICA U (L/O 0308)  
—Fastening seat belts  
When a passenger’s shoulder belt is com-  
D Be careful not to damage the belt  
webbing or hardware. Take care that  
they do not get caught or pinched  
in the seat or side doors.  
pletely extended and is then retracted  
even slightly, the belt is locked in that  
position and cannot be extended. This fea-  
ture is used to hold the child restraint  
system securely. (For details, see “Child  
restraint” in this Section.) To free the belt  
again, fully retract the belt and then pull  
the belt out once more.  
D Inspect the belt system periodically.  
Check for cuts, fraying, and loose  
parts. Damaged parts should be re-  
placed. Do not disassemble or  
modify the system.  
Tab  
If the seat belt cannot be pulled out of the  
retractor, firmly pull the belt and release  
it. You will then be able to smoothly pull  
the belt out of the retractor.  
Buckle  
D Keep the belts clean and dry. If  
they need cleaning, use a mild soap  
solution or lukewarm water. Never  
use bleach, dye, or abrasive clean-  
ers, or allow them to come into  
contact with the belt—they may se-  
verely weaken the belts. (See  
“Cleaning the interior” in Section  
5.)  
Adjust the seat as needed and sit up  
straight and well back in the seat. To  
fasten your belt, pull it out of the re-  
tractor and insert the tab into the  
buckle.  
CAUTION  
D After inserting the tab, make sure  
the tab and buckle are locked and  
that the belt is not twisted.  
You will hear a click when the tab locks  
into the buckle.  
D Do not insert coins, clips, etc. in  
the buckle as this may prevent you  
from properly latching the tab and  
buckle.  
D Replace the belt assembly (includ-  
ing bolts) if it has been used in a  
severe impact. The entire assembly  
should be replaced even if damage  
is not obvious.  
The seat belt length automatically adjusts  
to your size and the seat position.  
The retractor will lock the belt during a  
sudden stop or on impact. It also may  
lock if you lean forward too quickly. A  
slow, easy motion will allow the belt to  
extend, and you can move around freely.  
30  
2004 CELICA from Aug. ’03 Prod. (OM20823U)  
’04MY CELICA U (L/O 0308)  
D If the seat belt does not function  
normally, immediately contact your  
Toyota dealer. Do not use the seat  
until the seat belt is fixed, because  
it cannot protect an adult occupant  
or your child from injury.  
CAUTION  
Take up  
D Both highpositioned lap belts and  
loosefitting belts could cause seri-  
ous injuries due to sliding under  
the lap belt during a collision or  
other unintended event. Keep the  
lap belt positioned as low on hips  
as possible.  
slack  
Too high  
D Do not place the shoulder belt un-  
der your arm.  
Keep as low on  
hips as possible  
Adjust the position of the lap and  
shoulder belts.  
Position the lap belt as low as possible  
on your hips—not on your waist, then ad-  
just it to a snug fit by pulling the shoulder  
portion upward through the latch plate.  
31  
2004 CELICA from Aug. ’03 Prod. (OM20823U)  
’04MY CELICA U (L/O 0308)  
—Stowing the front  
passenger’s seat belt  
—Seat belt extender  
If your seat belts cannot be fastened se-  
curely because they are not long enough,  
a personalized seat belt extender is avail-  
able from your Toyota dealer free of  
charge.  
Please contact your local Toyota dealer so  
that the dealer can order the proper re-  
quired length for the extender. Bring the  
heaviest coat you expect to wear for prop-  
er measurement and selection of length.  
Additional ordering information is available  
at your Toyota dealer.  
CAUTION  
To release the belt, press the buckle  
release button and allow the belt to  
retract.  
The seat belt can be stowed in the  
tongue holder when it is not in use.  
When using the seat belt extender,  
observe the following precautions.  
Failure to follow these instructions  
could reduce the effectiveness of the  
seat belt restraint system in case of  
an accident, increasing the chance of  
personal injury.  
CAUTION  
If the belt does not retract smoothly, pull  
it out and check for kinks or twists. Then  
make sure it remains untwisted as it re-  
tracts.  
The seat belt must be removed from  
the tongue holder when the seat belt  
is in use.  
D Remember that the extender pro-  
vided for you may not be safe when  
used on  
another person, or at  
a
different vehicle, for  
different  
a
seating position than the one origi-  
nally intended.  
32  
2004 CELICA from Aug. ’03 Prod. (OM20823U)  
’04MY CELICA U (L/O 0308)  
D Be sure to wear the seat belt with-  
out the seat belt extender if you  
can fasten the seat belt without the  
extender.  
CAUTION  
D After inserting the tab, make sure  
the tab and buckle are locked and  
that the lap and shoulder portions  
of the belt and the seat belt extend-  
er are not twisted.  
D Do not use the seat belt extender  
when installing  
system on the front or rear passen-  
ger seat. If installing child re-  
a
child restraint  
a
D Do not insert coins, clips, etc. in  
the buckle as this may prevent you  
from properly latching the tab and  
buckle.  
straint system with the seat belt  
extender connected to the seat belt,  
the seat belt will not securely hold  
the child restraint system, which  
could cause death or serious injury  
to the child or other passengers in  
the event of collision.  
D If the seat belt does not function  
normally, immediately contact your  
Toyota dealer. Do not use the seat  
until the seat belt is fixed, because  
it cannot protect an adult occupant  
or your child from injury.  
To connect the extender to the seat  
belt, insert the tab into the seat belt  
buckle so that the “PRESS” signs on  
the buckle release buttons of the ex-  
tender and the seat belt are both facing  
outward as shown.  
You will hear a click when the tab locks  
into the buckle.  
When releasing the seat belt, press on  
the buckle release button on the extender,  
not on the seat belt. This helps prevent  
damage to the vehicle interior and extend-  
er itself.  
When not in use, remove the extender  
and store in the vehicle for future use.  
33  
2004 CELICA from Aug. ’03 Prod. (OM20823U)  
’04MY CELICA U (L/O 0308)  
—Seat belt pretensioners  
When the seat belt pretensioners are acti-  
vated, an operating noise may be heard  
and a small amount of nontoxic gas may  
be released. This does not indicate that  
a fire is occurring. This gas is normally  
harmless.  
Once the seat belt pretensioners have  
been activated, the seat belt retractors  
remain locked.  
CAUTION  
Do not modify, remove, strike or open  
the seat belt pretensioner assemblies,  
airbag sensor or surrounding area or  
wiring. Failure to follow these instruc-  
tions may prevent the seat belt pre-  
tensioners from activating correctly,  
cause sudden operation of the system  
or disable the system, which could  
result in death or serious injury. Con-  
sult your Toyota dealer about any re-  
pair and modification.  
The driver and front passenger seat  
belt pretensioners are designed to be  
activated in response to a severe fron-  
tal impact.  
The seat belt pretensioner system con-  
sists mainly of the following components  
and their locations are shown in the il-  
lustration.  
When the sensor detects a severe frontal  
impact, the front seat belts are quickly  
drawn back by the retractors so that the  
belts snugly restrain the occupants.  
1. Front airbag sensors  
2. SRS warning light  
3. Seat belt pretensioner assemblies  
4. Airbag sensor assembly  
The seat belt pretensioners are activated  
even with no passenger in the front seat.  
The seat belt pretensioners are controlled  
by the airbag sensor assembly. The airbag  
sensor assembly consists of a safing sen-  
sor and airbag sensor.  
The seat belt pretensioners and SRS air-  
bags may not operate together in case of  
collisions at a certain speeds and angles.  
34  
2004 CELICA from Aug. ’03 Prod. (OM20823U)  
’04MY CELICA U (L/O 0308)  
If any of the following conditions occurs,  
NOTICE  
this indicates a malfunction of the airbags  
or seat belt pretensioners. Contact your  
Toyota dealer as soon as possible.  
Do not perform any of the following  
changes without  
consulting your  
Toyota dealer. Such changes can  
interfere with proper operation of the  
seat belt pretensioners in some  
cases.  
D When the ignition key is turned to the  
“ON” position, the light does not come  
on, remains on or flashes.  
D The light comes on or starts flashing  
z Installation of electronic devices  
while driving.  
such as  
a
mobile twoway radio,  
D If any seat belt does not retract or can  
not be pulled out due to a malfunction  
or activation of the relevant seat belt  
pretensioner.  
cassette tape player or compact  
disc player  
z Repairs on or near the front seat  
belt retractor assemblies  
This indicator comes on when the igni-  
tion key is turned to the “ON” position.  
It goes off after about 6 seconds. This  
means the seat belt pretensioners are  
operating properly.  
D The seat belt pretensioner assembly or  
z Modification of the suspension sys-  
tem  
surrounding area has been damaged.  
z Modification of the front end struc-  
ture  
This warning light system monitors the  
airbag sensor assembly, front airbag sen-  
sors, side and curtain shield airbag sen-  
sors, curtain shield airbag sensors, driv-  
er’s seat position sensor, driver’s seat belt  
buckle switch, seat belt pretensioner as-  
semblies, inflators, warning light, intercon-  
necting wiring and power sources. (For  
details, see “Service reminder indicators  
and warning buzzers” in Section 16.)  
z Attachment of a grille guard (bull  
bar, kangaroo bar, etc.), snowplow,  
winches or any other equipment to  
the front end  
z Repairs made on or near the front  
fenders, front end structure or con-  
sole  
35  
2004 CELICA from Aug. ’03 Prod. (OM20823U)