’04 Corolla_U (L/O 0306)
Checking brake fluid
Checking power steering fluid
If the level is low, add SAE J1703 or
FMVSS No.116 DOT 3 brake fluid to the
brake reservoir.
If hot O.K.
Remove and replace the reservoir cap by
hand. Fill the brake fluid to the dotted
line. This brings the fluid to the correct
level when you put the cap back on.
If cold O.K.
Close
Open
Use only newly opened brake fluid. Once
opened, brake fluid absorbs moisture from
the air, and excess moisture can cause a
dangerous loss of braking.
If hot add
If cold add
CAUTION
To check the fluid level, simply look at
the see−through reservoir. The level
should be between the “MAX” and
“MIN” lines on the reservoir.
Check the fluid level through the reser-
voir. If necessary, add automatic trans-
mission fluid DEXRONr II or III.
Take care when filling the reservoir
because brake fluid can harm your
eyes and damage painted surfaces. If
fluid gets in your eyes, flush your
eyes with clean water immediately. If
you still feel uncomfortable with your
eyes, go to the doctor.
If the vehicle has been driven around 80
km/h (50 mph) for 20 minutes (a little
more in frigid temperatures), the fluid is
hot (60_C—80_C or 140_F—175_F). You
may also check the level when the fluid
It is normal for the brake fluid level to go
down slightly as the brake pads wear. So
be sure to keep the reservoir filled.
If the reservoir needs frequent refilling, it
may indicate a serious mechanical prob-
lem.
is
cold
(about
room
temperature,
10_C—30_C or 50_F—85_F) if the engine
NOTICE
has not been run for about five hours.
If you spill some of the fluid, be sure
to wash it off with water to prevent
it from damaging the parts or paint.
228
2004 COROLLA from Oct. ’03 Prod. (OM12859U)
English 
