’04 Corolla_U (L/O 0306)
Hood
D The side windows are tapped or bro-
CANCELLING THE SYSTEM
ken.
You can cancel the system as described
in “Stopping the alarm”.
D The battery terminal is disconnected
and then reconnected.
If you cancel the system by unlocking any
of the doors but no door is opened within
30 seconds, all the doors lock automati-
cally and the system will be set again.
D The ignition is hotwired.
After one minute, the alarm automatically
stops and the indicator light starts flashing
again.
TESTING THE SYSTEM
Reactivating the alarm
You can check the system operation as
follows.
Once set, until you cancel the system, the
system automatically resets the alarm af-
ter the alarm has stopped.
1. Open all the windows.
2. Set the system as described in
“SETTING THE SYSTEM”.
The alarm will activate again under the
same circumstances described in “Activat-
ing the alarm”.
To open the hood:
3. Unlock the driver’s door with the inside
lock knob. The system should activate
and the alarm should sound.
1. Pull the hood lock release lever. The
hood will spring up slightly.
Stopping the alarm
CAUTION
You can stop the alarm in either of the
following ways:
4. Stop the alarm as described in “Stop-
ping the alarm”.
Before driving, be sure that the hood
is closed and securely locked. Other-
wise, the hood may open unexpected-
ly while driving and an accident may
occur.
D Unlock any of the doors with the key
5. Repeat steps
2
to
4
for the other
or wireless remote control transmitter.
doors. (For rear doors, unlock and then
open the doors as described in step 3.)
D Place the ignition switch in the “ON”
position.
If the system does not work properly,
have it checked by your Toyota dealer.
22
2004 COROLLA from Oct. ’03 Prod. (OM12859U)
English 
