Maintenanceandcare -> Positioning a floor jack for Your Toyota Corolla 4 Door Ninth Generation (2007-2012)

4-3. Do-it-yourself maintenance  
Positioning a floor jack  
When raising your vehicle with a floor jack, position the jack cor-  
rectly. Improper placement may damage your vehicle or cause injury.  
Front  
1.8 L 4-cylinder (2ZR-FE) engine  
2.4 L 4-cylinder (2AZ-FE) engine  
4
Rear  
Take out the jack attachment.  
STEP  
1
307  
4-3. Do-it-yourself maintenance  
Set the jack attachment on the  
floor jack with the “FOR-  
WARD” facing towards the  
front of the vehicle, and place  
the jack.  
STEP  
2
Front of vehicle  
Before raising the vehicle,  
make sure that the floor jack is  
positioned so that the jack  
point fits securely inside the  
groove on the jack attach-  
ment.  
STEP  
3
308  
4-3. Do-it-yourself maintenance  
CAUTION  
When raising your vehicle  
Make sure to observe the following to reduce the possibility of death or seri-  
ous injury.  
Lift up the vehicle using a floor jack  
such as the one shown in the illustra-  
tion.  
Do not use the jack that was supplied with your vehicle.  
Do not put any part of your body or get underneath the vehicle supported  
only by the floor jack.  
Always use automotive jack stands on a solid, level surface.  
4
Do not start the engine while the vehicle is supported by the floor jack.  
Stop the vehicle on level firm ground, firmly set the parking brake and put  
the shift lever in P (automatic transmission) or R (manual transmission).  
Make sure to set the jack attachment  
properly at the jack point.  
Raising the vehicle with an improperly  
positioned floor jack will damage the  
vehicle and may cause the vehicle to  
fall off the floor jack.  
Do not raise the vehicle while someone is in the vehicle.  
When raising the vehicle, do not place any objects on top of or underneath  
the floor jack other than the jack attachment.  
309