Before using
the multi−information display
Switch operation
This system operates mainly by the
switches on the screen. To protect the
screen, lightly touch switches on the
screen with your finger. When you touch
a switch on the screen or on the bezel,
a beep sounds.
CAUTION
Do not adjust the display while the
vehicle is moving. Be sure to adjust
the display only when the vehicle is
stopped.
D If the system does not respond to a
26p049
touch of
a
switch, move your finger
away from the screen and then touch
it again.
D You cannot operate dimmed switches.
D Wipe off fingerprints on the surface of
the display using
cloth.
a
glass cleaning
Operate the multi−information display
with the ignition switch on.
When the ignition switch is turned to
“ON”, the initial “TOYOTA” screen appears
and the system begins operating.
After a few seconds, the previous mode
display will appear.
If the electrical power source has been
disconnected from the multi−information
display, the display will be automatically
set to the initial mode.
111
English 
