Power windows
If the 12 volt battery is disconnected or
run down, the power window may not
operate automatically and the jam protec-
tion function will not function correctly af-
ter you reconnect, replace or recharge the
12 volt battery. In any of these cases, you
should normalize the power window.
21p019a
21p020b
To normalize the power window:
1. Push down the power window switch
and lower the window halfway.
2. Pull up the switch until the window
closes and hold the switch for a sec-
ond.
The windows can be operated with the
switch on each door.
Automatic operation: Push the switch
completely down or pull it completely up,
and then release it. The window will fully
open or close. To stop the window part-
way, lightly move the switch in the oppo-
site direction and then release it.
Make sure that the window opens and
closes automatically. If the power window
cannot be operated properly, have it
checked by your Toyota dealer.
The power windows work when the “IG−
ON” mode is enabled.
Key off operation: If both front doors are
closed, they work for 43 seconds even
after the hybrid system is stopped. They
stop working when either front door is
opened.
CAUTION
Jam protection function: If something
gets caught between the window and win-
dow frame during automatic closing opera-
tion or key off closing operation, the win-
dow stops and opens halfway.
ꢀ Never try jamming any part of your
body to activate the jam protection
function intentionally, as it could re-
sult in death or serious injury.
OPERATING THE DRIVER’S WINDOW
Use the switch on the driver’s door.
If the window receives a strong impact,
this function may work even if nothing is
caught.
ꢀ The jam protection function may
not work if something gets caught
just before the window is fully
closed.
Normal operation: The window moves as
long as you hold the switch.
To open: Lightly push down the switch.
To close: Lightly pull up the switch.
43
English 