OPERATION OF INSTRUMENTS AND CONTROLS Steering wheel and Mirrors for Your Toyota Prius 4 Door Second Generation (2004-2009)

SECTION 23  
OPERATION OF INSTRUMENTS AND  
CONTROLS  
Steering wheel and Mirrors  
Tilt steering wheel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 104  
Outside rear view mirrorss . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 104  
Antiglare inside rear view mirror . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 106  
Auto antiglare inside rear view mirror . . . . . . . . . . . . . . . . . . . . . . . . 107  
Vanity mirrors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 108  
103  
Tilt steering wheel  
Outside rear view mirrors—  
CAUTION  
Do not adjust the steering wheel  
while the vehicle is moving. Doing  
so may cause the driver to mishan-  
dle the vehicle and an accident may  
occur resulting in death or serious  
injuries.  
After adjusting the steering wheel,  
try moving it up and down to make  
sure it is locked in position.  
When you move the steering wheel, an  
electrical motor noise may be heard. This  
is the power steering motor noise, and is  
not a malfunction.  
To change the steering wheel angle,  
hold the steering wheel, push down the  
lock release lever, tilt the steering  
wheel to the desired angle and push  
the lever up to lock the steering wheel  
in position.  
Adjust the mirror so that you can just  
see the side of your vehicle in the mir-  
ror.  
Be careful when judging the size or dis-  
tance of any object seen in the outside  
rear view mirror on the passenger’s side  
because it is a convex mirror. Any object  
seen in a convex mirror will look smaller  
and farther away than when seen in a flat  
mirror.  
When you touch the rear window defogger  
switch, the heater panels in the outside  
rear view mirrors will quickly clear the  
mirror surface. (See “Rear window and  
outside rear view mirror defoggers” on  
page 118.)  
104  
—Power rear view mirror  
control  
NOTICE  
CAUTION  
If ice should jam the mirror, do not  
operate the control or scrape the mir-  
ror face. Use a spray de−icer to free  
the mirror.  
Do not adjust the mirror while the  
vehicle is moving. Doing so may  
cause the driver to mishandle the  
vehicle and an accident may occur  
resulting in death or serious inju-  
ries.  
Since the mirror surfaces can get  
hot, keep your hands off them when  
the defogger switch is on.  
To adjust a mirror, use the switches.  
1. Master switch—To select the mirror to  
be adjusted  
Push the switch to “L” (left) or “R”  
(right).  
2. Control switch—To move the mirror  
Push the switch in the desired direc-  
tion.  
The mirrors can be adjusted when the  
hybrid system is in “ACC” or “IGON”  
mode.  
105  
Anti−glare inside rear view  
mirror  
—Folding rear view mirrors  
CAUTION  
Do not adjust the mirror while the  
vehicle is moving. Doing so may  
cause the driver to mishandle the ve-  
hicle and an accident may occur re-  
sulting in death or serious injuries.  
The rear view mirrors can be folded  
backward for parking in compact areas.  
Adjust the mirror so that you can just  
see the rear of your vehicle in the mir-  
ror.  
To fold the rear view mirror, push back-  
ward.  
To reduce glare from headlights of the  
vehicle behind you during night driving,  
operate the lever on the lower edge of  
the mirror.  
CAUTION  
Do not drive with the mirrors folded  
backward. Both the driver and pas-  
senger side rear view mirrors must  
be extended and properly adjusted  
before driving.  
Daylight driving—Lever at position 1  
The reflection in the mirror has greater  
clarity at this position.  
Night driving—Lever at position 2  
Remember that by reducing glare you also  
lose some rear view clarity.  
106  
Auto anti−glare inside rear  
view mirror  
In automatic function mode, if the mirror  
detects light from the headlights of the  
vehicle behind you, the mirror surface  
darkens slightly to reduce the reflected  
light.  
To turn off the automatic function, push  
the “” switch.  
To turn on the automatic function again,  
push the “ | ” switch.  
Adjust it before driving so that the rear  
view is in the best condition.  
When the inside air temperature is low, it  
may take a little longer for the mirror to  
darken in response to the detection of  
headlights.  
Adjust the mirror so that you can just  
see the rear of your vehicle in the mir-  
ror.  
To ensure correct functioning of an  
anti−glare mirror sensor located on the  
back side of the mirror, do not touch  
or cover the sensor with your finger or  
a piece of cloth, etc.  
This mirror is equipped with auto anti−  
glare function. The function is designed  
to reduce glare from the headlights of  
the vehicle behind you during night  
driving.  
CAUTION  
Do not adjust the mirror while the  
vehicle is moving. Doing so may  
cause the driver to mishandle the ve-  
hicle and an accident may occur re-  
sulting in death or serious injuries.  
When the hybrid system is in the “IGON”  
mode, the inside rear view mirror always  
turns on in the automatic function mode.  
The green indicator illuminates to show  
you that the function is on.  
107  
Vanity mirrors  
To use the vanity mirror, swing down  
the sun visor and slide the cover.  
To turn on the vanity light, slide the  
switch.  
The vanity light switch has the following  
positions:  
“ON”—Turns the light on when you swing  
down the sun visor. However, if the visor  
has been slid out, the light may not come  
on.  
“OFF”—Turns the light off.  
108